Sanus Systems Vision Mount VMBR Bedienungsanleitung

Assembly Instructions for Vision Mount VMBR

Thank you for purchasing a Vision Mount product. This product is designed to hold a VCR, DVD player, or cable / satellite

box under a VMBR television wall mount. It will accommodate one component up to 15 lbs. Check carefully to make sure

there are no missing or defective parts. Never use defective parts. Improper installation may cause damage or serious injury.

If you do not understand these directions, or have any doubts about the safety of the installation, please call a qualified

contractor or contact Sanus Systems at 800.359.5520 or visit www.sanus.com. We can quickly assist you with installation

questions and missing or damaged parts. Replacement parts for Sanus products purchased through authorized dealers will

be shipped directly to you.

Required Tools: Ratchet or wrench set

Supplied Parts:

(1) Main Arm - a (2) Extension Arm - b (2) Component Holder - c

(2) 17 mm Wide Foam Pad - d (2) 15 mm Wide Foam Pad - e (2) Square Foam Pad - f

(2) Set Screw - g (2) Knob - h (1) Allen Key - i

(1) Mount Bracket - j (2) 6 mm Diameter Bolt - k (2) 6 mm Diameter Nut - l

(1) 8 mm Diameter Bolt - m (1) Tube Spacer - n (2) Washer - o

(1) Plastic Spacer - p (1) 8 mm Diameter Nut - q

Step 1: Place the 2 Square Foam Pads (f) onto the 2 square surfaces on the bottom of the Main Arm (a) as shown

in Diagram 1 below.

Step 2: Place a 17 mm Wide Foam Pad (d) onto the vertical side of each Component Holder (c). Next place a 15

mm Wide Foam Pad (e) onto the horizontal side of each Component Holder as shown in Diagram 2 below.

Sanus Systems 3785 Lexington Ave. North, Saint Paul, MN 55126 800.359.5520 www.sanus.com

Diagram 1 Diagram 2

Step 3: Add an Extension Arm (b) to each side of the Main Arm (a). Lock each Extension Arm into place at the

desired width using a Set Screw (g). Tighten the Set Screw with the Allen Key (i) as shown in Diagram 3 below.

Step 4: A Component Holder (c) ﬁ ts into the track on the inside of each Extension Arm (b). Next, a Knob (h)

passes through the slot in the Extension Arm from the outside and threads into the hole in each Component Holder

as shown in Diagram 4 below.

Determine how you will mount the VMTV to your TV Wall Mount: There are two different methods to attach

the VMBR component bracket to the wall mount. It is recommended that you use Method 1 described in steps

5 through 8. You may also use Method 2 described in steps 9 through 11. Method 2 will be easier if you already

have a television on your TV Wall Mount.

Method 1

Step 6: Place the 8 mm Diameter Bolt (m) down through the TV Platter in place of the bolt provided with the TV

Wall Mount as shown in Diagram 6 below.

Step 7: Next place the Plastic Cap Bottom onto the TV Wall Mount assembly.

Step 8: Finally add the hardware to the bottom of the 8 mm Diameter Bolt (m) in the following order: Tube Spacer

(n), Washer (o), Component Bracket Assembly, Plastic Spacer (p), Washer (o), and the 8 mm Nut (q) as shown in

Diagram 6 below. Adjust the width and height to ﬁ t your component and the assembly is complete.

Method 2

Step 9: Place the Mount Bracket (j) over the Arm of the TV Wall Mount as shown in Diagram 7 below.

Step 10: Next place both 6 mm Diameter Bolts (k) down through the Mount Bracket (j) so that the square neck of

the bolts ﬁ t into the square holes in the bracket also shown in Diagram 7.

Step 11: Add the component bracket to the assembly so that the two 6 mm Bolts (k) ﬁ t down through the two

square holes in the Main Arm (a) and tighten a 6 mm Nut (l) onto each 6 mm Bolt as shown in Diagram 7 below.

Sanus Systems 3785 Lexington Ave. North, Saint Paul, MN 55126 800.359.5520 www.sanus.com

Step 5: First ﬁ nd the Plastic Cap Bottom from the TV Wall Mount. There is a

pre-punctured hole in the bottom that you must push out as shown in Diagram 5.

032204

Diagram 3 Diagram 4

Threaded Hole

Diagram 5

Hole

Diagram 6 Diagram 7

Plastic Cap

Bottom Component Bracket

Assembly

Arm

Component Bracket

Assembly

Andere Sanus Systems Rack & Stand Handbücher

Sanus Systems

Sanus Systems PFFP Bedienungsanleitung

Sanus Systems

Sanus Systems VMSA Bedienungsanleitung

Sanus Systems

Sanus Systems WMS5 Bedienungsanleitung

Sanus Systems

Sanus Systems Natural Foundations NF18 Bedienungsanleitung

Sanus Systems

Sanus Systems Platinum Furniture PFV36sb-01 Bedienungsanleitung

Sanus Systems

Sanus Systems VisionMount ML22 Bedienungsanleitung

Sanus Systems

Sanus Systems New VisionMount VMA201 Bedienungsanleitung

Sanus Systems

Sanus Systems FM37 Bedienungsanleitung

Sanus Systems

Sanus Systems VMPR1 Bedienungsanleitung

Sanus Systems

Sanus Systems PFAV30 Bedienungsanleitung

Sanus Systems

Sanus Systems PFV36SB-01 Installationsanleitung

Sanus Systems

Sanus Systems Sanus Ultimate Foundations UF34 Bedienungsanleitung

Sanus Systems

Sanus Systems HTSAT Bedienungsanleitung

Sanus Systems

Sanus Systems Sanus VisionMount VMAA18 Bedienungsanleitung

Sanus Systems

Sanus Systems VMUC1 Bedienungsanleitung

Sanus Systems

Sanus Systems VM2 Bedienungsanleitung

Sanus Systems

Sanus Systems VisionMount MT25 Bedienungsanleitung

Sanus Systems

Sanus Systems VM400 Bedienungsanleitung

Sanus Systems

Sanus Systems EFSat Bedienungsanleitung

Sanus Systems

Sanus Systems VMCC1 Installationsanleitung

Sanus Systems

Sanus Systems NEW FOUNDATIONS 500 Series Bedienungsanleitung

Sanus Systems

Sanus Systems VMCT Bedienungsanleitung

Sanus Systems

Sanus Systems BF16 Bedienungsanleitung

Sanus Systems

Sanus Systems VisionMount VMCA7 Bedienungsanleitung

Beliebte Rack & Stand Handbücher anderer Marken

Salamander

Salamander Acadia AC/W/L400/WH Bedienungsanleitung

Fohhn

Fohhn VAT-09 Benutzerhandbuch

ricoo

ricoo FS0522 Bedienungsanleitung

AMSOIL

AMSOIL BMK-22 Kurzanleitung

Kargo Master

Kargo Master 48220 Bedienungsanleitung

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung

ricoo

ricoo S1222 Bedienungsanleitung

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Bedienungsanleitung

VidaBox

VidaBox VB MNT FFS2 Bedienungsanleitung

Welch Allyn

Welch Allyn 48960 Bedienungsanleitung

Arkon

Arkon CM035-ST-2 Bedienungsanleitung

PROEL

PROEL PLWIN60C Bedienungsanleitung

Agilent Technologies

Agilent Technologies E2609B Bedienungsanleitung

Mustang

Mustang MV-ARM4 Bedienungsanleitung

Mounting Solutions

Mounting Solutions WRM-320 Bedienungsanleitung

Pyle

Pyle PMKSPAD1 Bedienungsanleitung

ShelterIt

ShelterIt 21208 Bedienungsanleitung

SPL

SPL RackPack?4 1040 Bedienungsanleitung