Sanus SASB1 Bedienungsanleitung
SASB
1
SOUNDBAR MOUNT
INSTRUCTION MANUAL
WE’RE HERE TO HELP
If you have any questions along the way,
our US-based install experts are standing by to help.
Call us at: 800-359-5520
Or, chat at: SANUS.com/chatSP
Please verify the following items:
Your TV, soundbar, soundbar mount, and any accessories you plan to install DO NOT EXCEED the specified weight limit of your TV wall mount.
You read and understand these directions.
You refer to the documentation that came with your sound bar, your TV and your TV wall mount for additional guidance.
IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ ENTIRE MANUAL PRIOR TO USE – SAVE THESE INSTRUCTIONS
Before You Begin
WARNING:
• This soundbar mount is only designed for use with TV wall mounts that meet UL/TUV safety certifications.
• This soundbar mount is ONLY designed to mount BELOW the television (see Figure 1).
• This soundbar mount is designed to be installed and utilized only as specified in this manual.
The manufacturer is not responsible for improper assembly, use, or handling of this product.
• Failure to follow these instructions could result in an unstable situation that may result in property damage or personal injury.
TV
Soundbar
Figure 1
Weight Restrictions
Weight Limit for SASB1 Weight Limit for Your TV Mount
DO NOT EXCEED
20 lbs. (9.0 kg) for this
Soundbar Mount
20 lbs.
(9.0 kg)
CAUTION:
Avoid potential personal injuries and property damage!
The weight of your TV, PLUS this soundbar mount, your soundbar, and any accessories, MUST BE LOWER
than the maximum weight rating of your TV mount. See your TV mount's manual for maximum weight allowed.
2 lbs.
(0.9 kg)
__ kg
(__ lbs.)
__ kg
(__ lbs.)
__ kg
(__ lbs.)
(plus) (plus) (plus) (equals)
Soundbar
Mount ANY Other
Accessories
Your
Soundbar Your TV
TOTAL
WEIGHT
Maximum for
Your TV Mount
Texto en español, página 12
2
Spacer: 16mm
Spacer: 2.5mm
M4 x 30mm
Horizontal
Bracket
Arm
Bracket A
Arm
Bracket B
Bottom Bracket
M6 x 30mm
M4 x 50mm
M8x30 mm
M6 x 50mm
M8 x 40mm
M8 x 50mm
M8 x 65mm
M4 Washer
M4 / M5 Washer
M8 /M6 Washer
Interface Washer
M4 x 10mm
M4 x 16mm
M5 x 16mm
M6 x 16mm
Key Hole Screw
(1/4-20)
Knob
M6 Washer
UL/TUV Certified
TV Wall Mount *
*Your TV wall mount may vary from the
illustrations throughout this manual.
NOTE that the procedure to install the
soundbar is the same.
Phillips Screwdriver Level
NOTE: Not all hardware included will be used.
WARNING:
This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If
any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts!
01
02
03
04 08 09
12
13
QTY.1
QTY.1
QTY.1
QTY.2 QTY.2 QTY.2
QTY.2
QTY.2
TV MOUNT
Your TV Mount
Manual
TV Screws (qty. 4 each)
[Only one size fits your TV]
Soundbar Screws (qty. 2 each)
[Only one size fits your Soundbar]
Washer
(qty. 4 each)
Soundbar Washers
(qty. 2 each)
Spacer
[If necessary]
(qty. 4 each)
05
10 11
06 07
M4
M4 M5
M6
M6
M8
PARTS INCLUDED
Items Needed
3
STEP 1: PREPARE YOUR TV [IF MOUNTED]
Measure the distance between the mounting
holes on your soundbar.
Remove screws Pand
save for STEP 2e.
STEP 2: ASSEMBLE SOUNDBAR MOUNT
03
CAUTION: Follow your TV mount’s manual for instructions on how to safely remove your TV and TV bracket.
NOTE: Your TV wall mount may vary from the illustrations throughout this manual — the procedure to install the
soundbar is the same.
a
ab
c
TV MOUNT
TV MOUNT
TOSS
S
TV MOUNT
02
b
(if needed)
REUSE STEP 3Ba
STEP 2e
PBACK Mounting Holes
BOTTOM Mounting Holes
4
6.6 in. to 19.5 in. 20 in. to 31 in.12 in. to 22.5 in. 22.5 in. to 35.5 in.
02
01 0302
NOTE: The channel of the horizontal
bracket 01 will rest ON your TV.
NOTE: The flat side of the arm brackets
02 and 03 rests ON the soundbar.
03
02
0303
0202
03
Insert the soundbar arm brackets 02 and 03 into the horizontal bracket 01 .
NOTE: Holding the lever inward as shown, helps to slide the arms.
Re-attach the screws Ponto the arm brackets 02 and 03 .
CAUTION: The screws PMUST be installed to secure the arms to the horizontal bracket 01 .
01
0302
0302 01
0302
P
Based on your soundbar measurement, rotate arm brackets 02 /03 left or right, to align with your soundbar
mounting holes, but not overhanging the ends of your soundbar or covering up any cable connections.
e
c
d
01
5
Determine which screw diameter fits your TV — M4, M6, or M8.
Only one screw size fits your TV.
Step 3A Step 3B
STEP 3: INSTALL THE SOUNDBAR MOUNT ON YOUR TV
08
09
01
01
06 06
05 05
Too Short Too Long Correct Correct
Inset Holes Cables Rounded Back
M6
M4 M8
• for Flat Back TV
[TV brackets lay flat on your TV]
follow Step 3A on PAGE 6.
• for Flat Back TV with
Extra Space Needed
[for deep inset holes
or cable interference]
follow Step 3B on PAGE 7.
• for Rounded or
Irregular Back TV
[TV brackets NOT
resting flat on your TV]
follow Step 3B on PAGE 7.
05
CAUTION: Verify adequate thread engagement with your screw 05 , washer
06 , spacer 08 /09 combination AND soundbar bracket 01 .
— Too short will not hold your TV. — Too long will damage your TV.
If your TV included inset
spacers or wall mount adapters,
use them UNDER the soundbar
mount hardware.
6
Place the 16mm spacers 08 over your TV’s top
mounting holes and the interface washers 09
over the bottom mounting holes.
Center the soundbar horizontal bracket 01 over
the interface washers 09 on your TV’s bottom
mounting holes.
STEP 3A
08
05
06
01
Center your TV mount bracket(s) on top of the 16mm spacers 08 and the soundbar bracket 01 .
Secure the TV mount and soundbar mount to your TV using the supplied TV screws 05 and washers 06 .
CAUTION: be sure to use correct length screws.
Your TV
mount
TOP of TV
TOP of TV
TOP of TV
09
01
08
09
a
c
b
7
Place your TV mount spacers over your TV’s mounting
holes. Then place the 16mm spacers 08 over the spacer
on the top mounting holes and the interface washers 09
over the spacer on the bottom mounting holes.
Center the soundbar horizontal bracket 01 over
the interface washers 09 on your TV’s bottom
mounting holes.
STEP 3B
05
06
08
01
Center your TV mount bracket(s) on top of the 16mm spacers 08 and the soundbar bracket 01 .
Secure the TV mount and soundbar mount to your TV using the supplied TV screws 05 and washers 06 .
CAUTION: be sure to use correct length screws.
TV mount
spacers
Your TV
mount
TOP of TV
TOP of TV TOP of TV
09
08
09
01
a
c
b
8
4A: Back-Mounted Key hole slots
4B: Back-Mounted Threaded inserts
4C: Bottom-Mounted Threaded inserts
STEP 4: INSTALL YOUR SOUNDBAR TO THE ARMS
4A: Back-Mounted
Key Hole Slots
Assemble knobs 13 and keyhole screws 12 .
Attach brackets 02 and 03 to your soundbar using the knob assemblies.
Tighten the screws Lto
secure the arms in place.
01
L
0302
0302
Center your soundbar under the soundbar mount, and adjust the arms 02 /03 over your soundbar mount holes.
NOTE: Holding the lever inward as shown, helps to slide the arms.
Attach your soundbar, based on the mounting holes of your soundbar.
Look at the mounting holes on the back or bottom of your soundbar to determine your install method A, B or C.
13
12
a
a
b
b
PAGE 8
PAGE 9
PAGE 9
9
Tighten the screws Lto
secure the arms in place.
L
4B: Back-Mounted Threaded Inserts
Attach the soundbar arm brackets 02 and 03 to your soundbar using
two screws 10 and washers 11 .
10
11
Align the bottom brackets 04 with your soundbar mounting holes and
attach using two screws 10 and washers 11 .
Install the bottom brackets 04 to the soundbar arms using the
screws Sand washers W.
4C: Bottom-Mounted Threaded inserts
Tighten the screws Lto
secure the arms in place.
Remove screws Sand
washers Wfrom brackets 04 .
L
04
NOTE: Use the 2.5mm
spacers 07 if the
supplied screws are
too long for your
soundbar.
S
W
04
S
W
0302
04
10
11
a
a
c
b
b
d
0302
10
STEP 5: HANG YOUR TV
BEFORE hanging, verify the depth of your soundbar will not interfere with the wall after mounting your TV.
Adjust the depth of your soundbar as needed, by loosening screw L. Tighten screw Lafter adjustments.
0302
L
Attach the magnet of release cord R,to back of the soundbar mount, for easy access during adjustments.
R
Follow your TV wall mount installation manual to hang your TV assembly.
TV MOUNT
a
c
b
R
Andere Handbücher für SASB1
1
Inhaltsverzeichnis
Andere Sanus Rack & Stand Handbücher
Sanus
Sanus OLF24-B2 Bedienungsanleitung
Sanus
Sanus AMAZON ECHO SHOW 5 Bedienungsanleitung
Sanus
Sanus VMF518 Bedienungsanleitung
Sanus
Sanus WSSAWM1 Bedienungsanleitung
Sanus
Sanus WSSCAM1-B2 Bedienungsanleitung
Sanus
Sanus OLF22-B2 Bedienungsanleitung
Sanus
Sanus VisionMount VMPR1 Bedienungsanleitung
Sanus
Sanus SLT2 Bedienungsanleitung
Sanus
Sanus Secura QLL12 Bedienungsanleitung
Sanus
Sanus HTB4B Bedienungsanleitung
Sanus
Sanus SAN55BA Bedienungsanleitung
Sanus
Sanus WSS22 Bedienungsanleitung
Sanus
Sanus WSEDM1-B2 Bedienungsanleitung
Sanus
Sanus Trillium 63 Bedienungsanleitung
Sanus
Sanus MST16b Bedienungsanleitung
Sanus
Sanus 6901-170053 Bedienungsanleitung
Sanus
Sanus VST15 Bedienungsanleitung
Sanus
Sanus DLF118 Bedienungsanleitung
Sanus
Sanus WSECS1-B2 Bedienungsanleitung
Sanus
Sanus F107 Bedienungsanleitung
Beliebte Rack & Stand Handbücher anderer Marken
Salamander
Salamander Acadia AC/W/L400/WH Bedienungsanleitung
Fohhn
Fohhn VAT-09 Benutzerhandbuch
ricoo
ricoo FS0522 Bedienungsanleitung
AMSOIL
AMSOIL BMK-22 Kurzanleitung
Kargo Master
Kargo Master 48220 Bedienungsanleitung
Milestone AV Technologies
Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung
