Sanyo LNS-W04 Gebrauchs- und Pflegehandbuch

LCD PROJECTOR LENS

MODEL NO. LNS-W04/LNS-W05/LNS-W06/LNS-W07

LENS INSTALLATION

AND REPLACEMENT PROCEDURES

NOTES ON REPLACEMENT AND INSTALLATION

The procedures and the needed pars for lens installation depend on the type of

cabinet. Before installing or replacing the lens, make sure the type of cabinet of your

projector and install the lens following this procedure precisely.

When installing or replacing the lens, make sure the Lens Model No. matches with to

your projector. Refer to the catalog, or contact your sales dealer for the proper Lens

Model No.

TYPE OF THE CABINET AND INSTALLATION PROCEDURES

This manual provides the following cabinet type models.

1AA6P1P4885-- (IDZC)

※For lens installation to the other models than below, contact your sales dealer.

Printed in Japan

Not all the parts included may be used for lens installation or replacement. Keep these

parts for later use.

Note : Illustrations in this manual may differ from the actual product.

NOTES ON LENS INSTALLATION

• Lens installation and replacement should be made by the qualified service per-

sonnel.

• Be sure to install the lens following this procedure precisely.

• Do not touch or remove any parts except the lens and related parts. It may result

in malfunctions, electrical shock, fire hazard or other accidents.

• The lens cover is attached to the lens for protection. Be sure to remove the lens

cover from the lens before installation.

• When installing or replacing the lens, be careful not to stain, scratch or damage

its surface.

• When moving or setting up the projector, be sure to replace the Lens Cover to

protect the surface. Be careful not to hold the lens. It may damage the lens, cabi-

net, or mechanical parts.

After installing or replacing the lens, be sure to confirm the followings for safety.

1. Make sure the lens attachment is fixed on the lens by 4 screws.

2. Make sure the lens is fixed on the projector by lens lock lever.

3. Make sure no part is missing, or loose.

BE SURE TO CHECK THE FOLLOWING MATTERS FOR SAFETY

LIST OF CONTENTS

Following parts are included in the package.

• LENS 1 pc

• DRIVER 1 pc

-1-

LENS REPLACEMENT AND INSTALLATION PROCEDURE

-2-

Pulling up Light Block Sheet Holder and Cover Plate,

remove them. (See Fig-2)

Fig-1

Front Cover

Fig-2

Fig-3

Disconnect the power cord from AC outlet.

Remove 5 screws (A) from the front cabinet.

Pulling up the front cover and remove it. (See Fig-1.)

Remove the cover plate from the light block sheet

holder . (See Fig-3)

Cover Plate

Light Block Sheet Holder

Cover Plate

-3-

4 Remove lens cap on the rear (mounting side) of the projection lens and mount Lens Attachment to the

lens with four screws included with the lens.

Insert the connector at the end of Lens Motor Lead into the socket located at right-top of the lens

attachment. (With motor model only.)

Fig-4

Socket

Lens Motor Lead

Lens Attachment

Connector

Part No. (610 275 6029)

Lens Attachment

POA-LNA-04 (610 317 1289)

Locate motor on

right side.

5Pinch Lens Lock Lever and turn it clockwise to unlock. (See Fig-5.)

Insert the Lens through the lens mounting bracket and turn the lens lock lever anticlockwise until the lens

is securely mounted. After installing the lens, make sure the Lens is not loose and properly mounted.

(See Fig-6 and Fig-7 on next page.)

Fig-5

Lens Lock Lever

Driver included with

the lens

Note : Lens Illustrations in this manual may differ from the actual product.

Note : Lens attachment is not included in this lens.

Driver included with

the lens

Part No. (610 275 6029)

Lens Attachment

-4-

ReleaseLensLock(Clockwise)

FixLensLock(Anticlockwise)

Fig-6

Fig-7

Pinch the tab and

turn the lever

clockwise to unlock

the lens.

Pinch the tab and

turn the lever anti-

clockwise to lock

the lens.

CAUTION:

Turn the Lens Lock Lever anticlockwise until the lens is locked. Make sure

the lens is securely installed after installation.

Focus Lock Screw

Focus Lock Ring

FOCUS ADJUSTMENT (For Model LNS-W07)

Set up the projector and project image on the screen.

1. Loosen the Focus Lock Screw on the projection

lens.

2. Rotate the projection lens to obtain proper focus

on center area of the screen.

3. Lock the Focus Lock Screw securely.

When proper focus is not observed at outer area of

the screen, proceed following adjustments.

4. Loosen the Focus Lock Ring on the projection

lens. (Turn the Lock Ring counter-clockwise.)

5. Rotate the lens to obtain proper focus on outer

area of the screen.

6. Lock the Focus Lock Ring securely. (Turn the Lock

Ring to clockwise.)

If proper focus is not observed over the entire screen,

repeat above adjustments 1~ 6.

-5-

6 Install Light Block Sheet and Light Block Sheet Holder corresponding to the lens into the projector. (See Fig-8 and

Fig-9.) Appropriate light block sheet varies depending on the Lens Model No. Check Type No. on the light block

sheet and Lens Model No. and use an appropriate one.

7Replace the front cover and secure it with the 5

screws.

Fig-10

Fig-9

Light Block Sheet Holder

Light Block Sheet

Fig-8

To unfold, reverse the light block sheet and

release the latch.

Back of Light

Block Sheet

Back

Front Cover

Note: Make sure the light block sheet is fully inserted into the light block sheet holder when installing the

light block sheet and the sheet holder into the projector. Improper installation may cause the lens

malfunction.

TYPE F14A (610 315 7337)

LNS-W04/LNS-W05/LNS-W06

TYPE F14B (610 315 7320)

LNS-W07

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Sanyo Projektorzubehör Handbücher

Sanyo

Sanyo LNS-S02K Series Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo PLC-LNS07 Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo LNS-T01 Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo LNS-T03 - Telephoto Zoom Lens Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo POA-MD03VD2A - Projector Terminal Expansion... Stücklistenhandbuch

Sanyo

Sanyo POA-SR-140 Bedienungsanleitung

Sanyo

Sanyo PJ-Net Organizer POA-PN01 Bedienungsanleitung

Sanyo

Sanyo LNS-W20 Bedienungsanleitung

Sanyo

Sanyo LNS-S30 Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo LNS-T31A - Telephoto Zoom Lens Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo PLC Bedienungsanleitung

Sanyo

Sanyo LNS-W10 - Wide-angle Zoom Lens Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo LNS-S02Z Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo POA-FBOX130 Bedienungsanleitung

Sanyo

Sanyo LNS-T03 Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo MT-EDU102 Bedienungsanleitung

Sanyo

Sanyo LNS-M01 Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo PLC-XU116 - 4500 Lumens Montageanleitung

Sanyo

Sanyo POA-SP-SU31 Bedienungsanleitung

Sanyo

Sanyo LNS-W50 Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo MT-EDU101 Bedienungsanleitung

Sanyo

Sanyo POA-CH-EX06 Bedienungsanleitung

Sanyo

Sanyo LNS-W10 - Wide-angle Zoom Lens Bedienungsanleitung

Sanyo

Sanyo LNS-S03 - Zoom Lens - 97 mm Gebrauchs- und Pflegehandbuch

Beliebte Projektorzubehör Handbücher anderer Marken

Optoma

Optoma BX-AL133B Bedienungsanleitung

PEERLESS

PEERLESS PE 1120 Leitfaden

Osram

Osram SIRIUS HRI Series Handbuch

Presentation Switchers

Presentation Switchers PS111 Bedienungsanleitung

Kramer

Kramer VIA GO Bedienungsanleitung

Yamaha

Yamaha PJL-112 Stücklistenhandbuch

Mitsubishi Electric

Mitsubishi Electric 236CB Betriebsanleitung

Epson

Epson BrightLink 475Wi Bedienungsanleitung

Acer

Acer WP100 Bedienungsanleitung

i3 i3board Bedienungsanleitung

CHIEF

CHIEF HB-43E Bedienungsanleitung

Biamp

Biamp Modena Hub Service-Handbuch

NEC

NEC MP10RX Bedienungsanleitung

Panamorph

Panamorph DCR-S3 Bedienungsanleitung

Exact solutions

Exact solutions FRAME-EVO-P10 Bedienungsanleitung

CHIEF

CHIEF VCM103S Bedienungsanleitung

InFocus

InFocus LP70+ Leitfaden

Sharp

Sharp AN-PH20EZ Bedienungsanleitung