Sargent Assa Abloy 9900 Bedienungsanleitung

1-800-727-5477 • www.sargentlock.com

A5572F 4/21

Copyright © 2018, 2021 SARGENT Manufacturing Company. All rights reserved. Reproduction in

whole or in part without the express written permission ofSARGENT Manufacturing Company is

prohibited.

Installation Instructions

9900 & 12-9900

Mortise Lock Exit Device

See Figure 1 for identification of parts.

Review the dimensions on the template to obtain the correct

height from finished floor.

1. Locate and place template as follows:

a. Stick center case and lock front template on door as

illustrated in Figure 2.

b. Using the cross bar hole centers for measuring, locate

the vertical center line of bracket.

2. Drill holes and mortise for lock as directed by the templates. See Figure 3.

3. If screwless rose outside trim is used, see separate instruction sheet and install rose at this time.

See Figure 4.

Figure3

4. Fasten mortise lock in place. See Figure 5.

Figure4

Figure1

Figure5

Figure2

1-800-727-5477 • www.sargentlock.com

A5572F 4/21

Copyright © 2018, 2021 SARGENT Manufacturing Company. All rights reserved. Reproduction in

whole or in part without the express written permission ofSARGENT Manufacturing Company is

prohibited.

WARNING

This product can expose you to lead

which is known to the state of California

to cause cancer and birth defects or other

reproductive harm. For more information go

to www.P65warnings.ca.gov.

Figure7

6. Attach outside trim when used.

a. Install cylinder and tighten cylinder set screw in lock front.

b. Attach center case cover to chassis.

7. Mount bracket chassis on door and attach bracket cover to

chassis.

8. Assemble and secure cross bar to arms.

9. Mortise strike in position.

A5572F 4/21

NOTE: If thru bolted trim is used, drill four 7/32” diameter holes through the

door and counterbore outside of the door for lugs.

5. IMPORTANT: Mount the center case chassis as follows:

a. Remove cover from center case chassis. Lock down arm. (For exit devices

less the cross bar lock down feature, hold arm in depressed position.)

See Figure 6.

b. Position center case chassis against the door so that the center case lever

is under the rear lever of themortise lock.

c. Lift center case chassis upward until the latch bolt is completely retracted.

d. With chassis in this position, mark location of the screw holes.

e. Drill holes for screws and mount center case chassis to the door.

Figure6

Figure 7

Dieses Handbuch passt für folgende Modelle

1

Inhaltsverzeichnis

Andere Sargent Sperren Handbücher

Sargent

Sargent IN220 Bedienungsanleitung

Sargent

Sargent PASSPORT 1000 Exit Device Bedienungsanleitung

Sargent

Sargent ASSA ABLOY IDP-H1 Bedienungsanleitung

Sargent

Sargent ASSA ABLOY Harmony Series Bedienungsanleitung

Sargent

Sargent IN100 Bedienungsanleitung

Sargent

Sargent Profile Series v.S2 Bedienungsanleitung

Sargent

Sargent IN100 Bedienungsanleitung

Sargent

Sargent EK Exit Device Retrofit Kit Bedienungsanleitung

Sargent

Sargent ASSA ABLOY Profile Series Bedienungsanleitung

Sargent

Sargent SE LP10 7000 Series Bedienungsanleitung

Sargent

Sargent RDL Bedienungsanleitung

Sargent

Sargent ASSA ABLOY SE LP10 Bedienungsanleitung

Sargent

Sargent IN220 Service-Handbuch

Sargent

Sargent ASSA ABLOY Simpli R8200 Series Bedienungsanleitung

Sargent

Sargent H1 Bedienungsanleitung

Sargent

Sargent Profile Series Bedienungsanleitung

Sargent

Sargent ASSA ABLOY Harmony Series Bedienungsanleitung

Sargent

Sargent Assa Abloy IN120 Bedienungsanleitung

Sargent

Sargent ASSA ABLOY SN Series Bedienungsanleitung

Sargent

Sargent ASSA ABLOY 8200 Bedienungsanleitung

Sargent

Sargent ASSA ABLOY PR100 Bedienungsanleitung

Sargent

Sargent 7800 Series Bedienungsanleitung

Sargent

Sargent 7800 Bedienungsanleitung

Sargent

Sargent v.G1.5 Bedienungsanleitung

Beliebte Sperren Handbücher anderer Marken

Magic

Magic 105 Bedienungsanleitung

Gantner

Gantner GAT NET.Lock 7020 System Kurzanleitung

Wittkopp

Wittkopp Insys 7202 Bedienungsanleitung

Dorma

Dorma Studio Classic Bedienungsanleitung

Securam

Securam ECSL-601 Bedienungsanleitung

Sudhaus

Sudhaus 3003 Bedienungsanleitung

Safety 1st

Safety 1st 48517 Bedienungsanleitung

Pado

Pado FDS-10 Bedienungsanleitung

Esco

Esco systeQ Series Bedienungsanleitung

COMPX

COMPX National D8951 Bedienungsanleitung

secureo

secureo Key Box Bedienungsanleitung

Stock Loks

Stock Loks C8713 Bedienungsanleitung

COMPX

COMPX 1T-058 Betriebsanleitung

Auslock

Auslock T11 Bedienungsanleitung

ELCOM

ELCOM 7205 Bedienungsanleitung

Stealth SAFES

Stealth SAFES ShadowVault Bedienungsanleitung

Knox

Knox KeySecure 5 Bedienungsanleitung

Kwikset

Kwikset 48334/01 Bedienungsanleitung