Schaerer 7300 Bedienungsanleitung

Installation and Operation

Manual

Model 7300 Modular

Surgery Table

OMI

7300

CA802000

Description

Page 7

Components

Overview

Page 8

Controls &

Indicators

Page 9

Calling For

Service

Page 26

Operation

Page 12

Specifications &

Accessories

Page 26

Operator

Maintenance

Page 25

Installation

Page 4

Important

Information

Page 2

Limited

Warranty

Page 31

Schaerer Medical USA, Inc.

OMI 7100

MODEL

NUMBER

SERIAL

NUMBER

OMI

7100-001

115 VAC

2 AMP 60 HZ

TDWXXXXX

MODEL

INPUT

RATING

SERIAL NO.

CA7681

Owner’s Product Identification

(information that you will need to provide for servicing - key information is highlighted)

Date of Purchase Serial Number

Name of Owner / Facility / Department

Model Number

Nameof Authorized SM-USA Dealer Telephone #of Authorized SM-USA Dealer

AddressofAuthorized SM-USA Dealer

CONTENTS

IMPORTANT INFORMATION.................................................................................................2

Scope and Purpose of This Manual ...............................................................................2

Intended Use of Product.................................................................................................2

Safety Instructions..........................................................................................................2

Explanation of Safety Symbols and Notes......................................................................2

Transportation and Storage Conditions ..........................................................................3

INSTALLATION ......................................................................................................................4

Unpacking.......................................................................................................................4

DESCRIPTION........................................................................................................................7

Introduction.....................................................................................................................7

Features..........................................................................................................................7

COMPONENTS OVERVIEW..................................................................................................8

CONTROLS & INDICATORS .................................................................................................9

OPERATION .........................................................................................................................12

Patient Positions & Weight Capacities..........................................................................12

Head Section, Installation & Operation.........................................................................13

Installing Table Top Sections ........................................................................................13

Possible Pinch Points....................................................................................................14

Pendant Hand Control ..................................................................................................16

Foot Control..................................................................................................................18

Emergency Override Panel...........................................................................................20

Hand Control Display Messages ..................................................................................22

OPERATOR MAINTENANCE ..............................................................................................25

Preventive Maintenance Schedule ...............................................................................25

Cleaning .......................................................................................................................25

CALLING FOR SERVICE.....................................................................................................26

SPECIFICATIONS & ACCESSORIES .................................................................................26

Options and Accessories..............................................................................................27

LIMITED WARRANTY..........................................................................................................31

RETURN TO TABLE

OF CONTENTS

IMPORTANT INFORMATION

Scope and Purpose of This Manual

This manual covers complete instructions for the installation, operation, and nor-

mal care of the Model 7300 Surgery Table. It is intended that this manual be

used by any medical personnel responsible for operating the surgery table dur-

ing a medical procedure or performing operator level maintenance.

Intended Use of Product

The intended use of the Model 7300 Surgery Table is to perform general surgi-

cal procedures.

Safety Instructions

The primaryconcern of SM-USA isthat thisequipment isoperated and main-

tained with the safety of the patient and staff in mind. To assure safer and more

reliable operation:

• Read and understand this manual before attempting to install or operate the

table.

• Assure that appropriate personnel are informed on the contents of this man-

ual; this is the responsibility of the purchaser.

• Assure that this manual is located near the table, or if possible, permanently

affixed to the table.

Explanation of Safety Symbols and Notes

DANGER

Indicates an imminently hazardous situation which, if not

avoided, will result in death or serious injury. The DANGER

symbol is limited to the most extreme situations.

WARNING

Indicates a potentially hazardous situation which, if not avoid-

ed, could result in death or serious injury.

CAUTION

Indicates a potentially hazardous situation which, if not avoided,

may result in minor or moderate injury. It may also be used to alert

against unsafe practices.

Important

Information

RETURN TO TABLE

OF CONTENTS

Important

Information

Transportation and Storage Conditions

• Ambient Temperature Range:..... -20°C to +40°C (-4°F to 104°F)

• Relative Humidity........................ 10% to 90% (non-condensing)

• Atmospheric Pressure ................ 500hPa to 1060hPa (0.49atm to 1.05atm)

EQUIPMENT ALERT

Indicates an imminently or potentially hazardous situation which, if

not avoided, will or may result in serious, moderate, or minor

equipment damage.

NOTE

Amplifies an operating procedure, practice, or condition.

RETURN TO TABLE

OF CONTENTS

INSTALLATION

Unpacking

1. Carefully cut the banding, remove the washer head nails, and lift off the

cardboard shipping box.

2. Remove the plastic bag from around the table and inspect the table for any

shipping damage.

3. Remove the box with accessories, etc. located on the table base and inspect

for shipping damage.

EQUIPMENT ALERT

To avoid damaging the table do not use a knife or other sharp ob-

ject to open the table’s packaging.

NOTE

You must report any shipping damage to the transit company within 15 days

of receiving the table from the transit company and ask them for an inspec-

tion.

FIGURE 1

CA799300

Installation

RETURN TO TABLE

OF CONTENTS

4. Unbolt and remove the two metal straps (1) from around the table base.

5. Remove the shipping plug (2) from the table’s hydraulic fluid reservoir and

install the vent plug (3) in it’s place; then install the hole plug (4).

6. Locate the hand control that

has been packaged with the

table and plug the cord of the

hand control into the port

labeled HAND CONTROL

located on the bottom, patient’s

right side of the table top.

7. Press the ENABLE/LOCK button. The display should read,

“NORMAL POSITION...LOCKING FLOOR”. The floor locks

and outriggers will function, locking the table to the skid.

8. Remove the two wood slats (5, Figure 1) from beneath

the table base.

9. Unbolt and remove the wood block (6) at the foot end base of the table.

EQUIPMENT ALERT

Do not operate the table until the shipping plug has been removed

from the hydraulic reservoir and the vent plug has been installed in

its place.

NOTE

If the hand control does not re-

spond when turned on, it may

mean the table’s battery system

needs to be charged. Using the

table’s power cord, connect the

cord to the table and then plug

the cord into a 115 VAC, 60 Hz,

hospital grade power recepta-

cle. Allow the batteries to

charge for 1/2 hour; then re-

move the power cord and con-

tinue with unpacking

procedures.

7100

LEVEL

UNLOCK

ENABLE

LOCK

DISABLE

7100

MIDOMIARK

HAND CONTROL

FOOT CONTROL

CA799400

ENABLE

LOCK

Installation

RETURN TO TABLE

OF CONTENTS

10.Unbolt and remove the wood block (7) located at the foot end base beneath

the wood skid.

11.Using an assistant, take hold of

each side of the table; then press

the ENABLE/LOCK and UNLOCK but-

tons and

hold for 3 seconds

. The

floor locks will disengage.

12.Carefully roll the table to the foot end of the skid. The skid tilts, allowing the

table to be rolled off.

13.Plug the table into a 115 VAC, 60 Hz, hospital grade, grounded outlet from 8

to 12 hours to fully recharge the batteries before actual use.

WARNING

The table w/ Pelvic Base (73001) weighs approximately 660

lbs. (299.4 kg). Get an assistant to help remove the table from

the shipping skid. Also, use proper lifting techniques when lifting table.

Failure to do so could result in serious back injury.

EQUIPMENT ALERT

Assure the brake cylinders have retracted all the way before at-

tempting to roll the table from the skid. Failure to comply may

cause damage to the brake cylinders.

EQUIPMENT ALERT

Use only 115 volt, alternating current (VAC), 60 cycle (Hz) to oper-

ate or recharge the batteries in the table. Failure to comply could

result in damage to the table.

EQUIPMENT ALERT

To prevent damage to the table, allow the table to reach room tem-

perature before operating. This is especially important when the

table has been exposed to below freezing temperature during transit.

ENABLE

LOCK

UNLOCK

Installation

RETURN TO TABLE

OF CONTENTS

DESCRIPTION

Introduction

The 7300 Modular Surgical Table is primarily used for general surgery but can

be easily adapted with various accessories to accomodate many different pro-

cedures such as cardio vascular, neurosurgical, urology, obstetrics, gynecolog-

ic, and orthopaedic.

Features

The Model 7300 General Surgical Table has . . .

• excellent image amplification with superior C-arm access.

• excellent access for anesthetist for short patients in lithotomy or other posi-

tions.

• a variety of accessories for almost any surgical procedure.

• various accessories constructed of light-weight carbon fiber yet retaining the

strength and durability for optimum life plus providing excellent radio-translu-

cency.

• stainless steel and carbon fiber construction for strength and cleanability.

• five powered functions that include powered floor locking, height adjustment,

lateral tilt, trendelenburg, and seat positioning.

• a “Return to Level” feature that, when enabled, automatically stops each

function at the level or “neutral setting.

• ability to flex and reflex table position with a single button.

• three sources for table positioning commands, pendant hand control,

optional foot control, or the emergency override control.

• back up hydraulic motor/pump in case the primary motor/pump becomes

disabled.

• ability to power the table directly from a 115 VAC power source for limited

periods should the batteries become fully discharged.

• ideal position for lithotomy without compromising other forms of surgery.

• state-of-the-art factory and field, trained, technical service organizations

plus easy- to-follow technical literature,

in paper or CD format

, to assure your

equipment is maintained at peak operating performance.

Description

RETURN TO TABLE

OF CONTENTS

COMPONENTS OVERVIEW

The illustration below shows the location of the table’s major components and

the chart below provides their descriptive name.

DESCRIPTION OF COMPONENTS (Basic Table)

1. Hand Control 5. Line Power Pilot Lamp

2. Foot Control (Optional) 6. Plug Receptacle

3. Emergency Override Panel 7. Power Cord

4. Floor Lock Cylinders 8. Latch Handle(s)

CA800300

OMI

7300

OMI

7300

LEVEL UNLOCK

ENABLE

LOCK DISABLE

7100

OMI

Component

Overview

Andere Handbücher für 7300

Inhaltsverzeichnis

Andere Schaerer Medizinische Geräte Handbücher

Schaerer

Schaerer 7300 Bauanleitung

Beliebte Medizinische Geräte Handbücher anderer Marken

TekTone

TekTone Tek-CARE160 Bedienungsanleitung

NeuroMetrix

NeuroMetrix Quell 2.0 Bedienungsanleitung

AMT

AMT XLR8 Bedienungsanleitung

EDAN

EDAN SONOTRAX Pro Bedienungsanleitung

Restorative Therapies

Restorative Therapies RT300 Bedienungsanleitung

Gendex

Gendex Expert DC Bedienungsanleitung

Dexcowin

Dexcowin ADX4000W Bedienungsanleitung

Libelium

Libelium MySignals Bedienungsanleitung

Acelity

Acelity V.A.C.ULTA 4 Bedienungsanleitung

Caputron

Caputron ActivaDose II tDCS Bedienungsanleitung

Plinth 2000

Plinth 2000 93CDT Bedienungsanleitung

GE SENOGRAPHE 800T Bedienungsanleitung

GE Definium 5000 Bedienungsanleitung

Kanmed

Kanmed GE-1380 Bedienungsanleitung

Huntleigh

Huntleigh FD1 Bedienungsanleitung

Stryker

Stryker SPR Plus Bedienungsanleitung

Tobii Dynavox

Tobii Dynavox I-Series Bedienungsanleitung

S-Capepod

S-Capepod Evac Cocoon Bedienungsanleitung