SDRPLAY RSP1A Bedienungsanleitung
What is an SDR (Software Defined Radio)
Receiver?
www.sdrplay.com
A radio receiver where much of what
traditionally was done in hardware,
is now done in software.
The SDRplay RSP1A hardware does up-front
filtering, amplifying, mixing and Analog to
Digital conversion.
It sends the digitised signal to the PC over the
USB cable and the SDRuno software performs
the rest of processing chain
www.sdrplay.com
The SDRplay RSP1A is a powerful wideband SDR
which covers the RF spectrum from 1kHz to 2GHz. All
it needs is aPC and an antenna to provide excellent
communications receiver functionality.
USB cable*
Ideally outside
and at least
4m above
ground
Wire antenna, >10m long
for shortwave
Download SDRuno software
from SDRplay website
RSP1A Windows PC
USB2 Type B cable (used to connect printers
Follow the prompts
www.sdrplay.com
Allow Windows to install if you get a message saying that Windows can’t verify the publisher
When you get the message below, wait 30 seconds and then plug in your RSP1A and click
“Next”
Click on “Finish” and SDRuno will launch – lots of windows will automatically appear and arrange
themselves on your PC screen (accept these defaults for now)
Andere SDRPLAY Empfänger Handbücher
