Sebart Stev S 30E Bedienungsanleitung
SebArt professional line
Stev S 30E ARF
ASSEMBLY MANUAL
The new trainer Stev S 30E ARF, was designed by Italian
Champion Sebastiano Silvestri.
ith this design SebArt reinvented the idea of the Trainer. This
professional ARF kit is the result of more than 25 years in
model airplane design experience. This innovative design
combined with the extremely lightweight structure, all wood
airframe, give the Stev S 30E an impressive precision and
smoothness at any airspeed and flight condition.
It is unbelievable how the Stev S 30E can do it all!
It can fly very stable and easy at any airspeed: a dream for every
beginner.
In expert hands it can perform very easy reverse flight, hover,
positive harrier, low speed knife edge, and almost anything else
you can dream up are waiting you, and that for a trainer is
revolutionary!
.....your Stev S is waiting you!
Specifications
ing Span:..……….……...........157 cm (62 in.) Recommended power set up:
Length:……........….………...... 138 cm (54 in.) Motor:........................... Hacker A30-14L
ing Area:…….................. 44 dm2 (680 sq.in.) ESC:……………………. X40 SBec-Pro
eight:……...1.450 g. RTF less battery (50 oz) Battery: ……….Thunder Power 2700-3S
Radio: 4+ channel with 4 sub-micro servo(12g.) Propeller: …….…...………. APC 14x7E
Required radio, motor and battery
Radio equipment:
•Minimum 4-channel radio system
•5 digital sub-micro servo, recommended JR PROPO DS386, DS385 or DS381
•2 servo extension 600mm, for elevator and rudder servo
•2 servo extension 200mm, for aileron servo
Recommended electric motor for best performance:
•Hacker A30-14L + X40 SBec-Pro controller + APC 14x7 E
Recommended Li-Po battery pack for best performance:
•Thunder Power 2700-3S.…..or larger size for longer flight time
Additional required item, tools and adhesives
Tools:
•Drill
•Drill bits: 1,5mm, 2mm, 3mm
•Phillips screwdriver
•Hobby knife
•Soldering iron
Adhesi es:
•thin CA
•medium CA
Warning
This RC aircraft is not a toy!
If misused, it can cause serius bodily harm and damage to property. ly only in
open areas, preferably in official flying sites, following all instructions included
with your radio and motor.
efore starting assembly
2
Before starting the assebly, remove each part from its bag and protection for a prior
inspection. Closely inspect the fuselage, wing panels, rudder, and stabilizer for
damage. If you find any damage or missing parts, contact the place of purchase.
If you find any wrinkles in the covering, use a heat gun or covering iron to remove
them. Use caution while working around areas where the covering material overlap to
prevent separating the covers.
Warranty information
SebArt garantees this kit to be free from defects in both material and workmanship at
the date of purchase.
This warranty does not cover any parts damage by use or modification, and in no case
shall SebArt’s liability exceed the original cost of the purchased kit.
Further, SebArt reserve the right to change or modify this warranty without notice. In
that SebArt has no control over the final assembly or material used for the final
assembly, no liability shall be assumed or accepted for any damage of the final user-
assembled product. By the act of using the product, the user accepts all resulting
liability.
If the buyer is not prepared to accept the liability associated with the use of this
product, the buyer is advised to return this kit immediately in new and unused
condition to the place of purchase.
Control throws
Please, follow carefully the recommended linkage setups for ailerons, elevators and
rudder.
For the AILERON we recommend the following throws:
Low rate: 20° up / 20° down Expo: 20%
High rate: 40° up / 40° down Expo: 60%
For the ELEVATOR we recommend the following throws:
Low rate: 20° up / 20° down Expo: 20%
High rate: 40 ° up / 40° down Expo: 60%
For the RUDDER we recommend the following throws:
Low rate: 30° left / 30° right Expo: 20%
High rate: 40° left / 40° right Expo: 60%
Note: the Expo is (+) for JR systems, and (–) for Futaba systems
3
Use the recommended expos to soften the feel of the model, expecially on high rates.
The goal is to get the model to feel the same around neutral as it does on low rates.
Recommended CG
The recommended Center of Gravity location is 105mm behind the leading edge of
the wing against the fuselage.
Use the battery pack, moving it forward or backward, to achieve the correct balance.
Pre-flight
Never attempt to make full throttle dives! This model have to be flown like a full-
scale airplane. If the airframe goes too fast, such as in a high throttle dive, it may fail.
Throttle management is absolutely necessary.
Range test your radio
Before fly, be sure to range check your radio as manufacturer’s instruction
manual of you radio-system recommend.
Double-check all controls (aileron, elevator, rudder and throttle) move in the
correct direction.
Be sure that your motor battery pack is fully charged, as per the instructions
included with your batteries and that your radio is fully charged as per its
instructions.
Finally... have nice flights!
SEBART International S.r.l.
Via L. Tabellione, 1
47891 Rovereta - Repubblica di San Marino (RSM)
4
Inhaltsverzeichnis
Andere Sebart Spielzeug Handbücher
Sebart
Sebart Katana S 50E V.2 Bedienungsanleitung
Sebart
Sebart PrometheuS 50E ARF Bedienungsanleitung
Sebart
Sebart Mini Avanti Bedienungsanleitung
Sebart
Sebart MYTHO S 30E Bedienungsanleitung
Sebart
Sebart Mig29 3D-EDF Bedienungsanleitung
Sebart
Sebart Aermacchi MB339 XS Bedienungsanleitung
Sebart
Sebart KatanaS 50E Bedienungsanleitung
Sebart
Sebart KatanaS 30E Bedienungsanleitung
Sebart
Sebart Sukhoi 29S 50E ARF Bedienungsanleitung
Sebart
Sebart AngelS EVO 50E Bedienungsanleitung
Sebart
Sebart KatanaS 120 ARF Bedienungsanleitung
Sebart
Sebart Cessna S 30-50E ARF Bedienungsanleitung
Sebart
Sebart MC-72 50E ARF scale Programmierhandbuch
Sebart
Sebart Avanti S XXL Bedienungsanleitung
Sebart
Sebart Wind S 110 ARF Bedienungsanleitung
Sebart
Sebart EDGE 540S 50E Bedienungsanleitung
Sebart
Sebart Mytho S 125E ARF Bedienungsanleitung
Sebart
Sebart G-91 PAN EDF Bedienungsanleitung
Sebart
Sebart Mini Avanti 1.4m ARF Bedienungsanleitung
Sebart
Sebart F3A-50E-A4 Bedienungsanleitung
