MI002191-I-E ENGLISH 2/8
Seneca S.r.l. www.seneca.it
Headquarter: Via Germania, 34 - 35127 - Z.I.
CAMIN - PD - IT
Operations: Via Svizzera, 17 - 35127 -
Z.I. CAMIN - PD - IT
Before executing any operation it’s mandatory to read all the content of this
user manual. Only electrical-skilled technicians can use the module
described in this user Manual; it is responsibility of the manufacturer to verify
that the installation complies with safety standards.
Only the Manufacturer is authorized to repair the module or to replace
damaged components.
No warranty is guaranteed in connection with faults resulting from improper
use, from modifications or repairs carried out by Manufacturer-unauthorised
personnel on the module, or if the content of this user Manual is not followed.
2.0 DESCRIPTION AND GENERAL FEATURES
The Z107E adapts the Ethernet communication signal into a serial signal RS485 or RS232; it
can be used as a remote serial communication port via TCP or UDP port of the Ethernet
network.
·
·
·
·
·
·
·
·
Ethernet to RS485 or RS232 communication through VIRTUAL COM PORT
Communication POINT TO POINT with ethernet TCP or UDP protocol connection
Communication POINT TO MULTIPOINT with ethernet connection
Ethernet communication velocity: 10Mbit/s o 100Mbit/
10-BaseT and 100-BaseT Ethernet port with TCP/IP communication protocol
Up to 115200 Bps for Modbus protocol.
500 Vac output isolation compared with other low voltage circuits
Quick installation on DIN 46277 rail.
Removable screw terminals with section of 2.5 mm
s
.
·
2
3.0 TECHNICAL SPECIFICATIONS
3.1 General specifications
maximum power consumption
3.2 R 485 communication portS
