Rev. B Doc. 6001238 Page 3 of 5
PART 2
NARROW BAND GARAGE DOOR RECEIVER
PROGRAMMING AND USE GUIDE
The narrow band garage door receiver can be programmed to activate the garage door operator upon
receiving signals from up to four uniquely-encoded transmitters. Since the codes in the transmitters
cannot be changed or duplicated, only transmitters you have programmed can access your garage. If a
transmitter is lost or stolen, you can quickly disable its ability to activate the garage door operator.
A. PROGRAMMING A TRANSMITTER INTO THE NARROW BAND GARAGE DOOR RECEIVER
You must program each transmitter in the receiver before it will activate your garage door operator. You
can program up to four separate transmitters into the receiver:
1. Open the hatch door on the front of the receiver using a small screwdriver. Inside the receiver on the
left you will see a block containing four microswitches. The switches in the block are numbered 1
through 4, from left to right. On the right side you will see three LEDs; a red “Valid” LED, a yellow
“Data” LED, and a red “Noise” LED.
2. Move switch 1 to the "ON" (up) position using the small screwdriver or a pen. The red “Valid” LED
should come on and stay lit continuously. If there is not room in the memory to accept another
transmitter, the “Valid” LED will blink. (To erase a transmitter to allow room in the memory, see the
instructions below.)
3. Press and hold the button on the transmitter you want to program. When the “Valid” LED begins to
flash, the unique code has been learned by the receiver and you may release the button. After a few
seconds, the “Valid” LED will extinguish. For safety reasons, the garage door operator will not be
activated by the receiver while in the programming mode.
4. If the transmitter you just programmed filled the last space in the memory, the “Valid” LED will begin
flashing again after five seconds. If there is room in the memory to program another transmitter, the
“Valid” LED will return to its steadily lit state.
5. If you wish to program another transmitter, wait ten seconds and then repeat steps 3 and 4. Once you
have finished programming all of your transmitters, terminate the programming mode by moving switch
1 back to the "OFF" (down) position. For safety reasons, there is a five second delay after you return
switch 1 to the "OFF" position before the receiver will be capable of activating the garage door
operator.
IMPORTANT NOTE:
While the transmitter button is being pressed, the yellow “Data” LED will light up indicating that the receiver
is receiving data from the transmitter. The red “Noise” LED may lighupt at the same time; this is normal. If
the red “Noise” LED lights up continuously and the yellow “Data” LED does not light up, then there is too
much interference for proper operation of the receiver.
B. ERASING TRANSMITTERS FROM THE NARROW BAND GARAGE DOOR RECEIVER
If a transmitter should ever be lost or stolen, you can erase the lost or stolen transmitter from the system
and leave the other transmitters operational
1. Open the hatch door as described above and move switch 3 to the "ON" (up) position. Make sure that
switch 3 is the only switch that is in the “ON” position. The “Valid” LED will come on and stay lit.
(If the “Valid” LED begins to blink when you move switch 3 to “ON”, the receiver’s memory does not
contain any ClikCard codes.)
2. Move switch 2 to the "ON" (up) position. When the “Valid” LED begins blinking, all of the transmitters
that had been programmed into the receiver will have been erased.
3. Move switches 2 and 3 to the "OFF" position and follow the procedures described in the section above
to reprogram the transmitters which you wish to continue to have access to your garage.
