SFF time MNLT Bedienungsanleitung
SFF time MNLT manual
1
Dear customer,
Thank you for purchasing the SFF time MNLT case. Please read the full compatibility list before assembling your PC and make sure that your
components fit. You can find it on sfftime.com or on the next page of the manual.
If you have any doubts about choosing your components, or steps in this manual, please contact us via email on [email protected], and we will
be glad to assist you.
Important notes:
- always use correct screwdriver tip for corresponding bolts (PH1 or PH2)
- always use correct bolt type
- do not overtighten the bolts
- do not force any components in, each component should be installed without using excessive force
SFF time MNLT manual
2
Sff time MNLT specifications:
19.7 L volume with 231 x 209 x 408 mm outer dimensions
vertical riser-less tower case with bottom IO
support for ITX and m-DTX motherboards
support for 3 slot GPU's up to 345 mm long (315/320 mm with 200 mm top fan)
CPU air coolers up to 182 mm (max allowed overhang from the motherboard is 5 mm)
mount for 120 mm AIO or radiator on the bottom
SFX power supplies up to 100 mm long (no SFX-L support)
support for two 2.5" hard drives
case fans: 140 or 120 mm bottom | 200, 140 or 120 mm top | 2 x 120 mm side
included two 140 mm Arctic P14 Silent fans on top and bottom positions
59 mm clearance for cable connectors on bottom
invisible power switch on top
SFF time MNLT manual
3
1. Preparing the case – disassembly (part 1)
- unscrew thirteen bolts marked in the picture that hold the side panel and shell
SFF time MNLT manual
4
2. Preparing the case – disassembly (part 2)
- remove the rear panel
SFF time MNLT manual
5
3. Preparing the case – disassembly (part 3)
- remove the top panel by pulling it away from the case. The panel is held to the case with magnetic tape
SFF time MNLT manual
6
4. Preparing the case – disassembly (part 4)
- remove the screw that holds the fan
bracket as shown in the picture
SFF time MNLT manual
7
5. Preparing the case – disassembly (part 5)
- remove the fan bracket
SFF time MNLT manual
8
6. Preparing the case – disassembly (part 6)
- slide the chassis out of the shell in the direction shown below
SFF time MNLT manual
9
-*note about the CPU cooler: if you are using a smaller CPU cooler or if your
CPU cooler mounting holes are not reachable from the rear side after the
MBO installation, mount the CPU cooler in this step
7. Installing the motherboard
- prepare the motherboard by installing CPU,
RAM and M.2 drives
-install the IO shield
- align the motherboard on standoffs
- screw the motherboard down using provided
bolts
SFF time MNLT manual
10
8. Installing the PSU
- place the PSU in the position like shown in the picture
- screw down the power supply to the bracket using four silver bolts
- we recommend using the bolts supplied with your PSU, as they vary in length
- plug in the AC connector and secure the cable to the PSU bracket with zip ties
- connect the 24-pin and 8-pin power connectors to the motherboard, you can use space next to the
PSU to manage the excess cables
Andere SFF time Gehäuse Handbücher
