4
AEROMAT 150 Installation and operating instructions
03.2020
Safety notices
Type DK
• This unit can be used by children aged 8 and above as well as by people with physical, sensory or mental difficulties or
with a lack of experience and knowledge as long as they are supervised or have been instructed in how to use the unit
safely and understand the resulting risks. Children must not play with the unit. Cleaning and user maintenance must not be
carried out by children without supervision.
• Electrically operated unit. Risk of fatal injury from electric shock or fire.
To prevent personal injury or damage to property, always comply with the following instructions:
- Work on a 230 V AC mains power supply may only be performed by a qualified electrician.
- If the mains connection cable for the unit is damaged, it must be replaced by SIEGENIA, the company's customer service
department, or similarly qualified personnel in order to prevent personal injury or damage to property.
- All-pole safety isolation is required if the customer is routing the network connection cable.
- All work on the 230 V AC mains power supply must be carried out in compliance with the current German VDE regulations
(e.g. VDE 0100) and any relevant country-specific requirements.
- Relevant country-specific regulations must be strictly followed for all work carried out on the voltage supply system or house
wiring system.
- Should a solid object or any liquid get inside the unit, stop operation immediately and disconnect the AEROMAT 150 from
the mains power supply:
Check whether the AEROMAT 150 is damaged
If necessary, repair work can be performed by experienced professionals
Installation
Prerequisites for installation
• The position from which the outdoor air is drawn in must be selected in such way that any nearby emission sources have
as little impact as possible on the quality of the air being drawn in.
• Installation option: Installation in impost
AEROMAT 150
Installation sequence
1.
Carefully remove AEROMAT 150 from the packaging. We recommend placing the unit on a soft surface (e.g. cardboard or
blanket) during installation.
2. Type DD: Close the plate on the front to prevent contamination (e.g. dust) from entering the unit during installation.
3. Install the AEROMAT 150 in its intended installation position and seal it in accordance with the installation directives
applicable on site.
4. Check AEROMAT 150 for cleanliness prior to starting it up. If necessary, clean the unit thoroughly as described in our
operating and maintenance instructions.
