SOMFY Telis Soliris 4 RTS Patio Bedienungsanleitung

The Telis Soliris RTS Patio is a hand-held remote to operate awnings, screens and

shutters featuring Radio Technology. It also has the added feature of activating an

RTS sun sensor remotely. The RTS is omni-directional, so there is no need to aim

the remote at the product being controlled.

Telis Soliris 4 RTS Patio

Part Number:

1811243

Introduction - Multi-Channel Remote Control

Up Button

Center “my” Button

Down Button

Programming

Button (PROG)

Wind Only

Sun & Wind

Sun/Wind/Channel

Selector

Telis Soliris 4 RTS Patio with Sun/Wind function

Back

Programming a new remote

1. With the current remote press the Channel Selector Button. Each channel operates a single window

or group of window coverings. LED lights will illuminate, indicating which channel is being operated.

2. Using a paper clip, pen or similar device, press and hold the Programming Button on the back of your

current remote until your window shade moves up and down quickly.

3. On the new remote, select a channel to assign the window covering to. Using a paper clip, pen, or

similar device, press and hold the Programming Button on the back of the new remote. The window

shade will move up and down quickly.

4. The new remote is now programmed to operate your window covering.

Programming and Operating

Continued On Next Page

page 1 of 3

Note: repeat process for the other

window coverings/channels.

Programming Favorite Position with Remote

The remote operates interior and exteriors shading solutions. Each is operated by a channel.

1. Press the Channel Selector Button. The LED lights will illuminate, indicating which channel

is being operated.

2. Use the up ( ) or down ( ) buttons to position the shade in your favorite position.

Use the ( ) button to stop the shade when it reaches that position.

3. Press and hold the center ( ) button until the window moves up and down quickly.

Favorite position is programmed.

4. During normal operation, select the window covering to operate using the channel selector button

then press the ( ) button to place window shade in your favorite position.

Activating Sun/Wind controls (which requires optional sun/wind sensor).

• The wind sensor is factory set and does not require programming. In order to use Sun/Wind mode,

each window covering must be assigned a channel and be paired with the Sun/Wind mode.

1. Using the channel selector button, select the interior or exterior shading solution you wish to

operate with the Sun/Wind sensor.

2. Using a paper clip, pen or similar device, press and hold the Programming Button (PROG) on the back

of the remote until the interior or exterior shading solution brieﬂy moves up and down.

3. Press and hold the SUN/WIND SELECTOR BUTTON until all LED lights activate.

The lights will change sides and the interior or exterior shading solution will brieﬂy move up

and down. When the left side is lit, the interior or exterior shading solution will only react to wind

levels. When the right side is lit, the interior or exterior shading solution will react to both sun and

wind levels.

Operating the Remote

The remote operates interior and exteriors shading solutions. Each is operated by a channel.

1. Press the Channel Selector Button. The LED lights will illuminate, indicating which channel is being

operated.

2. Press the up ( ) button to raise your window covering.

3. Press the down ( ) button to lower your window covering.

4. Press the center ( ) button to stop the window covering during operation.

Programming and Operating Continued

page 2 of 3

Note: repeat process for the other window coverings/channels

This device is FCC certiﬁed and complies with part 15 of the FCC rules.

RTS compatibility: RTS transmitters are capable of operating any RTS motor.

page 3 of 3

BATTERY RECYCLING OR DISPOSAL

Discard batteries and electrical components

following local codes or regulations. Recycle

batteries and electrical components with

designated electronic recycle centers.

Battery Installation

Replacing the Battery

1. Using a small screwdriver, loosen the screws on the reverse side of the remote control and

remove the back cover.

2. Replace the battery with one 2430 Lithium 3V battery

Note: Visit https://store.somfysystems.com/ to

purchase an additional or replacement product.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere SOMFY Fernbedienung Handbücher

SOMFY

SOMFY SITUO 1 VARIATION Bedienungs- und Wartungsanleitung

SOMFY

SOMFY Telis Composio RTS Bedienungsanleitung

SOMFY

SOMFY Telis 1 Lounge Bedienungsanleitung

SOMFY

SOMFY SITUO 1 VARIATION Bedienungsanleitung

SOMFY

SOMFY Telis 1 Lounge Betriebsanleitung

SOMFY

SOMFY nina Bedienungsanleitung

SOMFY

SOMFY Sonesse 40 Bedienungsanleitung

SOMFY

SOMFY Nina Timer io Bedienungsanleitung

SOMFY

SOMFY Telis 6 Chronis RTS Installationsanleitung

SOMFY

SOMFY KEYPOP 2 RTS Bedienungsanleitung

SOMFY

SOMFY 1810632 Telis 1 RTS Pure Bedienungsanleitung

SOMFY

SOMFY myLink Bedienungsanleitung

SOMFY

SOMFY INTEO TELIS 4 RTS Bedienungsanleitung

SOMFY

SOMFY FREEROLL RTS Bedienungsanleitung

SOMFY

SOMFY KEYTIS 4 Bedienungsanleitung

SOMFY

SOMFY Nina io Bedienungsanleitung

SOMFY

SOMFY inteo CENTRALIS RTS Bedienungsanleitung

SOMFY

SOMFY 5014984 Bedienungsanleitung

SOMFY

SOMFY Easy Sun io Bedienungsanleitung

SOMFY

SOMFY SITUO RTS Bedienungsanleitung

SOMFY

SOMFY INTEO TELIS 1 RTS Bedienungsanleitung

SOMFY

SOMFY CENTRALIS RECEIVER Bedienungsanleitung

SOMFY

SOMFY INTEO TELIS 1 RTS Bedienungsanleitung

SOMFY

SOMFY Telis 1 io Bedienungsanleitung

Beliebte Fernbedienung Handbücher anderer Marken

Panasonic

Panasonic EUR7622KB0 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen Beo4 Bedienungsanleitung

Sunwave Tech.

Sunwave Tech. RemoteComm SRC-7000 Bedienungsanleitung

Multiplex

Multiplex PROFI TX 9 Bedienungsanleitung

One Remote

One Remote RMB4 Bedienungsanleitung

FUTABA

FUTABA 9ZAP - PART2 Bedienungsanleitung

HR Matic

HR Matic HR MULTI 3 Bedienungsanleitung

Yamaha

Yamaha ACC-GNRST-30-20 Bedienungsanleitung

EisSound

EisSound KBSOUND Bedienungsanleitung

Marantz

Marantz RC101 Bedienungsanleitung

Conrad

Conrad FS20 TC6 Bedienungsanleitung

Anritsu

Anritsu MP1777A Bedienungsanleitung

Niles

Niles WVC100 Fehlerbehebungshandbuch

RCA

RCA RCU1300 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BEO6 Bedienungsanleitung

GE 94901 Bedienungsanleitung

Onbon

Onbon YQ1-75 Bedienungsanleitung

FUTABA

FUTABA R7108SB Montageanleitung