Sony WRR-800A Bedienungsanleitung

3-860-929-21 (1)

Operating Instructions

Bedienungsanleitung

Wireless Channel Lists/Übertragungskanallisten

WRR-800A

UHF Synthesized

DiversityTuner

[CE62] [CE64] [CE69]

English

WARNING

To prevent fire or shock hazard, do not expose the unit

to rain or moisture.

To avoid electrical shock, do not open the cabinet.

Refer servicing to qualified personnel only.

English

Overview ...................................................................1

Features ................................................................. 2

System Configuration ........................................... 3

Channel Plan ......................................................... 3

Precautions............................................................... 4

Location of Parts and Controls............................... 5

Front Panel ............................................................ 5

Display .................................................................. 6

Rear Panel ............................................................. 7

Operation ..................................................................8

Muting Functions .................................................. 9

Channel Setting........................................................ 9

Error Messages ......................................................11

Specifications......................................................... 12

The WRR-800A is a reliable UHF synthesized diversity

tuner for the 800-MHz-band Sony UHF wireless

microphone system which uses the frequency bands

allocated for UHF TV broadcasting.

This unit is designed to enable simultaneous use of multiple

channels when channels are selected according to the

channel plan.

In building up a UHF wireless microphone system, be sure

to combine a microphone/transmitter and a tuner having the

same TV channel number (62, 64 or 69).

CE62 model

A 14 MHz frequency band is assigned to the WRR-800A/

CE62 model, permitting it to operate on any of 111

receiving frequencies in 125-kHz steps of Sony original

channel plan or 561 receiving frequencies in 25-kHz steps of

German User Group in the range of TV channels 62 and 63.

The selectable wireless channels and frequencies for this

model are listed pages L-2 through L-10.

CE64 model

A 14 MHz frequency band is assigned to the WRR-800A/

CE64 model, permitting it to operate on any one of 111

receiving frequencies in 125-kHz steps of Sony original

channel plan or 561 receiving frequencies in 25-kHz steps of

German User Group in the range of TV channels 64 and 65.

OverviewTable of Contents

The selectable wireless channels and frequencies for this

model are listed on pages L-11 through L-19.

CE69 model

An 8 MHz frequency band is assigned to the WRR-800A/

CE69 model, permitting it to operate on any of 64 receiving

frequencies in 125-kHz steps of Sony original channel plan

in the range of TV channel 69 or 14 receiving frequencies in

25-kHz steps of UK General Use.

The selectable wireless channels and frequencies for this

model are listed on pages L-20 and L-21.

Features

Phase Locked Loop (PLL) synthesized system

The WRR-800A has a refined phase locked loop (PLL)

synthesizer circuit.

Preprogrammed wireless channel plan for

simultaneous multichannel operation

The WRR-800A has many preprogrammed, easily settable

channels in a simultaneous multichannel operation.

Overview

Versatile display

A liquid-crystal display provides a variety of information,

including the levels of the reception channels, RF

information and transmitter battery alarm.

Space diversity reception system

The WRR-800A provides stable signal reception with

minimum dropout.

Tone squelch circuit for noise elimination

A built-in squelch circuit eliminates noise and signal

interference when the WRR-800A is in signal reception

standby mode.

Compander system

A compander (compressor/expander) system enables

stabilized wireless transmission over a wide dynamic range.

1) The distance depends on the operating environment and conditions.

............................................................................................................................................................................................................................................................

Frequency band Model name

TV channel Transmitter or

microphone

Frequency

(MHz)

62 WRT-800A (62)

WRT-805A (62)

800.000 to

814.000 WRR-800A (62)

WRR-801A (62)

64 816.000 to

830.000 WRT-800A (64)

WRT-805A (64) WRR-800A (64)

WRR-801A (64)

69 854.125 to

862.000 WRT-800A (69)

WRT-805A (69) WRR-800A (69)

WRR-801A (69)

Tuner

System Configuration

The unit can be used with a Sony UHF synthesized wireless

microphone or UHF synthesized transmitter among the

models listed in the table below.

Sony 800 MHz-band system models

Channel Plan

The unit stores several groups of channels. See “Overview

of Channel Plan” in the “Wireless Channel Lists” section.

Channel groups other than group 00 are designed so that all

channels of one group can be used simultaneously within the

same UHF wireless microphone system without causing

intermodulation. It is therefore recommended that you

usually use a channel group other than group 00 unless the

use of group 00 is specifically necessary.

Note

To eliminate interference or noise, please note the

following.

• Do not use two or more wireless microphones or

transmitters whose wireless channels are the same.

• If there is a TV broadcasting station nearby, to avoid

possible interference from its broadcasting, do not use that

station’s channel.

• The number of wireless microphone channels actually

usable in a multi-channel system may be smaller than the

normal capacity of that system if there is interference from

TV broadcasting or other RF signals.

• When operating two or more UHF wireless microphone

systems using the same wireless channel in the same

group, ensure that the systems are at least 100 m1) apart as

far as they are installed within sight of each other.

Precautions

On cleaning

Clean the unit with a dry, soft cloth. Never use thinner,

benzene, alcohol or any other chemicals, since these may

damage the finish.

On operation

• The unit must be used within a temperature range of 0°C to

40°C. Avoid using the unit for extended periods at

extremely high temperatures or placing it in direct sunlight,

especially outdoors because this may damage the finish of

the case. Never install the unit on or near a heat source,

such as lighting equipment or power amplifiers.

• Avoid using in very humid or dusty places, because such

use may shorten the life of the unit.

• To avoid degradation of the signal-to-noise ratio, do not

use the unit in noisy places or in locations subject to

vibration, such as the following:

— near electrical equipment, such as motors, transformers

or dimmers

— near air conditioning equipment or places subject to

direct air flow from an air conditioner

— near public address loudspeakers

— where adjacent equipment might knock against the unit

• Switching lights on or off may produce electrical

interference over the entire frequency range. Position the

unit and the wireless microphones so that interference is

minimized.

• The unit is precisely adjusted at the factory and no

adjustment before use is necessary. Do not touch the

inside of the unit or try to repair it by yourself.

Location of Parts and Controls

Front Panel

1POWER switch

Turns the power on and off.

2ANTENNA A, B (antenna A, B) connectors (BNC

type)

Connect the supplied antennas.

3Display

Displays the status of this unit and the groups and channels

assigned to the unit.

For details, see the following section “Display”.

4SET button

Press to change the group or channel.

ON ANTENNAA VOL. ANTENNA B

SET

OFF

POWER

BATT

MIN MAX

AF BATT

GP CH

1POWER switch

2ANTENNA A, B connectors

3Display

4SET button

5GP button

7VOL. Control

6CH button

5GP (group) button

Press to change the group or to display frequencies.

6CH (channel) button

Press to change the channel in a group.

7VOL. (volume) control

Adjusts the volume of the tuner output.

Display

Location of Parts and Controls

1BATT (battery) indicator

5BATT (battery) indication

Indicate the condition of the wireless microphone

transmitter batteries. The indicator and indication start

flashing about one hour before the transmitter batteries go

flat.

2RF (radio frequency) indicator

7RF (radio frequency) indications

The indicator lights and the indications (dots) appear when

the antenna reception is optimal. Depending on the RF input

level, the number of dots changes.

3AF (audio frequency) indicator

4AF (audio frequency) indication

The indicator lights and the indication appears when the

audio output level is higher than the reference level.

6GP/CH (group/channel) indication

Shows the reception channel group and respective channel

number.

Pressing the GP button changes this indication to the

frequency indication.

AF BATT

GP CH

BATT

1BATT indicator

2RF indicator

3AF indicator

4AF indication

7RF indications

6GP/CH indication

5BATT indication

1TUNER OUTPUT (tuner sound output) connector

(ø6.3 phone balanced (TRS))

Supplies audio signals. You can connect this to the audio

input connector of a mixer, amplifier, or similar equipment.

2DC IN 9V (9 V DC power input) connector

Connect the supplied AC power adaptor.

3Cord clamp

Attaches the cord of the AC power adaptor.

Operation

Rear Panel

TUNER OUTPUT

LINE LEVEL 0dBm

DC IN 9V

1TUNER OUTPUT connector

3Cord clamp

2DC IN 9V connector

1Connect the supplied antennas and make the antenna

tips point upward.

2Connect the supplied AC power adaptor to the DC IN

9V connector and an audio mixer or amplifier to the

TUNER OUTPUT connector.

3Turn the POWER switch on.

Note

Turn the POWER switch on after reducing the volume

of the equipment connected to the TUNER OUTPUT

connector. Otherwise, noise will be heard when the

POWER switch is turned on.

4Set the reception channel.

For details on setting the channels, see page 9.

5Turn on the wireless microphone or transmitter.

Use the wireless microphone or transmitter to which the

same channel is assigned as to this unit.

If noise is heard

Depending on the environment where the system is

installed, outside noise or radio wave may disrupt the

transmission of certain channels.

To select a channel under this circumstance, turn off the

wireless microphone or transmitter. Then select a channel at

which the RF indicator is off. (A channel free from noise or

radio wave interference is selected.) Set the same channel on

the microphone or transmitter.

–

ANTENNA A, B

Audio mixer, amplifier

AC power adaptor

UHF synthesized

transmitter

UHF

synthesized

wireless

microphone

DC IN 9V

TUNER OUTPUT

Andere Handbücher für WRR-800A

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Sony Tuner Handbücher

Sony

Sony ST-D777ES Bedienungsanleitung

Sony

Sony STR-NX1 Bedienungsanleitung

Sony

Sony WRR-855A Bedienungsanleitung

Sony

Sony WRR-855B Bedienungsanleitung

Sony

Sony WRR-861A Bedienungsanleitung

Sony

Sony ST-SV7 Bedienungsanleitung

Sony

Sony SVR-2000 Bedienungsanleitung

Sony

Sony Dream Machine ICF-C743 Bedienungsanleitung

Sony

Sony FD-525 Bedienungsanleitung

Sony

Sony ST-D50L Bedienungsanleitung

Sony

Sony ST-S800ES Bedienungsanleitung

Sony

Sony ST-88 Bedienungsanleitung

Sony

Sony ST-H3600 Bedienungsanleitung

Sony

Sony WRR-855S Bedienungsanleitung

Sony

Sony ST-S320 Bedienungsanleitung

Sony

Sony WRR-800A Bedienungsanleitung

Sony

Sony WRU-806B Bedienungsanleitung

Sony

Sony WRR-801A Bedienungsanleitung

Sony

Sony MBX6 Bedienungsanleitung

Sony

Sony DSX-A300DAB Bedienungsanleitung

Sony

Sony WRR-805A Bedienungsanleitung

Sony

Sony URX-M2 Bedienungsanleitung

Sony

Sony ST-JX390 Bedienungsanleitung

Sony

Sony WRR-805A Bedienungsanleitung

Beliebte Tuner Handbücher anderer Marken

Tunersys

Tunersys WS16 1 Bedienungsanleitung

Arcam

Arcam DT91 Bedienungsanleitung

Magnum

Magnum MD 102T Bedienungsanleitung

HDHomeRun

HDHomeRun 20121008 Bedienungsanleitung

Crestron

Crestron C2N-TXM Bedienungsanleitung

Eico

Eico HFT-92 Bedienungsanleitung

MFJ

MFJ MFJ-928 Bedienungsanleitung

NAD

NAD C 445 Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SC-FM1 Bedienungsanleitung

Antique Automobile Radio

Antique Automobile Radio 283501B Bedienungsanleitung

Monacor

Monacor PA-1200R Bedienungsanleitung

Technics

Technics ST-X301L Bedienungsanleitung

Manhattan

Manhattan 176156 Bedienungsanleitung

Marantz

Marantz ST-15S1 Bedienungsanleitung

Korg

Korg HA-40 Bedienungsanleitung

Harman Kardon

Harman Kardon TU915 Bedienungsanleitung

Teac

Teac T-1D Bedienungsanleitung

Pioneer

Pioneer GEX-P700DAB Bedienungsanleitung