Dual Band In-Wall Infrared Receiver Instruction Manual
The Dual Band In-Wall Infrared Receiver receives IR signals from a handheld IR remote control and relays
this to the audio/video equipment for operation from another room. Mounts to a single gang standard
electrical box using a decorate cover plate.
FEATURES
1. Stylish decorate design. Available in white colors.
2. Dual color LED. Green for system status and blue for talk back.
3. Ultra thin design. Mounts easily in any J-box or P-ring.
4. Wide band IR receives IR from many types of remotes.
SPECIFICATIONS
Receive Frequency Range: 34 kHz to 60 kHz
Transmit Frequencies: 38 KHz & 56 KHz
Range: 40ft. @ 38 KHz
25ft. @ 56 KHz
Power: 12VDC, 30mA max.
Status Power: 12VDC, 3mA max.
Wire requirements: 2 twisted pair, with or without shield
INSTALLATION
Connect the Dual Band In-Wall Infrared Receiver to the connecting block using 2 twisted pair wire. Use one
pair to connect GND (GROUND) and IR (SIGNAL). Use the other pair to connect ST (STATUS) and V+
(+12VDC). If the wire has a shield, connect it to the ground at both ends.
STATUS INDICATOR
To use the status indicator on the Dual Band In-Wall Infrared Receiver connect the 12 Volt 100mA or higher
power supply to the STATUS line of the connecting block as shown . Plug the power supply into the switched
outlet on the stereo receiver. When the receiver is on, the power supply will turn on the system status line and
illuminate the LED green of the Dual Band In-Wall Infrared Receiver.
MOUNTING
Mount the Dual Band In-Wall Infrared Receiver to the standard electrical box using the screws that are
supplied. Mount cover plate to the IR receiver. See Figure 1.
Figure 1
Model 50-14876
