8 U421-I2 & U431-I2 OPERATOR’S MANUAL 513725 REV.0
Section 2: Operation
MAINTENANCEPARTS TROUBLESHOOTING OPERATION INTRODUCTION
A. Empty the Freezing Cylinders
Turn offfreezing cylinders.
A.1
Press the Clean buttons.
A.3
In the cab, remove the mix
pickup assemblies and place
them in a bucket filled with cool
tap water.
Remove the mix containers
and covers.
A.2
Clean mix containers on a regular basis.
Refer to State and local health codes for
frequency.
NOTE
Optional: Fill the bucket with Stera Sheen
solution to make cleaning parts easier
after disassembly.
NOTE
Open spigots to drain product
into a container until the
container is full. Empty the
container and repeat until
product has been drained from
the freezing cylinders.
A.4
Refill the bucket in the cab with cool tap water (or
Stera Sheen). Allow the freezing cylinders to fill then
drain the water into a container. Repeat until the water
draining from the freezing cylinders is clear.
A.5
Remove any remaining
water from the bucket in the
cabinet.
Drain the water and press
the Clean buttons to stop
the augers.
A.7
If the “Clean Time Exceeded” warning
is displayed on the IntelliTec2™, turn
the freezing cylinder on and offagain
and press the Clean button to clear the
warning.
NOTE
