Sunjoy L-GZ760PST-B Bedienungsanleitung

Assembly Instructions

Item# L-GZ760PST-B

GAZEBO ASSEMBLY INSTRUCTIONS

Our clear, easy-to-follow, step-by-step instructions will guide you through the project

from start to finish. The final product will produce a quality shelter that will offer you

years of enjoyment.

All that is required is a screwdriver, a hammer and two ladders of at least 8 feet (2.5 m)

high. (not included).

For you safety, DO NOT assemble this item alone. Two people or more are required

for a smooth and safe installation.

Item identification: For ease of identification, all parts are labeled to correspond to the

Step number in which the part is used.

Have six or more people helping you when assembling or

moving the product.

Description Part Quantity Image

Large panel 1 A1 2

Large panel 2 A2 2

Small panel 1 B1 2

Small panel 2 B2 2

Long beam 1 C1 2

Long beam 2 C2 2

Short beam D 2

Lower connector 1 E 4

Lower connector 2 F 8

Top beam 1 G1 2

Top beam 2 G2 2

Support beam G3 2

Slanted beam H 4

Middle beam I 8

Long PC 1 J1 4

Long PC 2 J2 4

Short PC 1 J3 4

Short PC 2 J4 4

Middle PC J5 8

Small PC 1 K1 2

Small PC 2 K2 2

Parts List

Description Part Quantity Image

Left plate L1 4

Right plate L2 4

Middle plate L3 4

Long plate M1 2

Short plate M2 2

Left rail N1 4

Right rail N2 4

Middle rail N3 4

Center plate O1 8

Corner plate O2 8

Hook P 1

Small top connector Q 1

Cover R 1

Small slanted beam 1 S1 2

Small slanted beam 2 S2 2

Long netting tube T 4

Short netting tube U 4

Mosquito netting V 1

Parts List

Part Description Quantity Image

AA M6 x 35 Bolt 4 PCS

BB M6 Flat washer 80 PCS

CC M6 x 15 Bolt 76 PCS

Z M6 Wrench 2 PCS

Hardware Pack 1

Fig.1: Secure the small panels (B1 and B2) to the large panels (A1 and A2) with bolts (AA) and flat washers (BB).

Fig.2: Secure the lower connector 1 (E) to the corner of the panels with bolts (CC) and flat washers (BB).

Fig.3: Insert the long beam 1 into the long beam 2 (C2), then secure the lower connector 2 (F) to long beam 1 (C1) and long

beam 2 (C2) with bolts (CC) and flat washers (BB). Reserve one hole on the long beam (C2) to install the netting tube.

Fig.4: Secure the assembled long beam 1 to the large panels (A1 and A2) with bolts (CC) and flat washers (BB).

Repeat this step to secure the short beam (D) to small panels (B1 and B2).

Fig.5: Secure the lower connector 2 (F) and short netting tube (U) to the short beam (D) with bolts (CC) and flat

washers (BB).

Fig.6: Secure the long netting tubes (T) to the long beams (C1 and C2) with bolts (CC) and flat washers (BB). Repeat

this step to secure the short netting tubes.

Part Description Quantity Image

BB M6 Flat washer 56PCS

CC M6 x 15 Bolt 32PCS

DD M6 x 20 Bolt 24PCS

Hardware Pack 2

Fig.7-1: Secure the slanted beam (H) to the top beams (G) with bolts (DD) and flat washers (BB).

Fig.8: Secure the slanted beam (H) to the lower connector 1 (E) with bolts (CC) and flat washers (BB).

Fig.9: Secure the middle beam (I) to the top beams (G) with bolts (DD) and flat washers (BB).

Fig.10: Secure the lower end of the middle beam (I) the lower connector 2 (F) with bolts (CC) and flat washers (BB).

Fig.7: Insert the top beam (G1) into the top beam (G2) and using bolts (CC) and flat washers (BB) to secure the top

beam 2 (G2) with top beam 1 (G1).

Fig.11: Secure the small slanted beam 1 and 2 (S1 and S2) to the top beam 1 (G1) with bolts (CC) and flat

washers (BB).

Fig.12: Secure the small slanted beam 1 and 2 (S1 and S2) to the small top connector (Q) with bolts (CC) and

flat washers (BB).

Fig.12-1: Secure the support beam (G3) to the top beams with bolts (CC) and flat washers (BB).

Fig.13: Attach the hook (P) to the small top connector (Q).

Part Description Quantity Image

AA M6 x 35 Bolt 2 PCS

BB M6 Flat washer 18 PCS

EE M6 x 20 Screw 16 PCS

Hardware Pack 3

Fig.14: Insert the small PCs (K1 and K2) into the rail of the small slanted beam (S).

Fig.15: Insert the plates (M1 and M2) into the lower of the small PCs (K1 and K2), then secure the corner

plate (O2) to the small slanted beam (S) through three holes with screws (EE) and flat washers (BB).

Fig.16: Secure the cover (R) to the small top connector (Q) with bolts (AA) and flat washers (BB).

Fig.19: Insert the plates (L1, L2 and L3) into the lower of the PCs; then secure the center plate (O1) to the middle beam (I)

through three holes with screws (EE) and flat washers (BB).

Fig.20: Secure the corner plate (O2) to the slanting beam (H) through three holes by using screws (EE) and flat washers (BB).

Part Description Quantity Image

GG Ring 56 PCS

HH Φ8 X 180 mm Stake 16 PCS

Fig.21: Attach the mosquito netting (V) to the long netting

tubes (T) and short tubes (U) with rings (GG).

Fig.22: Secure the whole gazebo to the ground with stakes

(HH).

Fig.17: Insert the short PC 1 and 2 (J3 and J4) into the middle beam (I) and slanted beam (H), then insert the rails (N1 and

N2) into it. Insert the long PC (J1) into the middle beam (I) and slanted beam (H). Repeat this step to install the right PCs.

Fig.18: Insert the middle PC (J5) into the middle beam (I); then insert the middle rail (N3) into it. Insert the middle PC (J5)

into middle beam (I).

Hardware Pack 4

IMPORTANT

1. Keep all children and pets away from assembly area. Children and pets should be

supervised while gazebo is being assembled.

2. The assembled gazebo should be located at least 6 feet (2 m) from any obstruction such as

a fence, garage, house, overhanging branches, laundry lines or electrical wires.

3. This unit is heavy. Do not assemble this item alone. Six people are recommended for safe

assembly.

4. Some parts may contain sharp edges. Wear protective gloves if necessary during assembly.

5. When assembling and using this product, basic safety precautions should always be

followed to reduce the risk of personal injury and damage to equipment. Please read all

instructions before assembly and use.

6. For outdoor use only. Install on level ground. 16 stakes are provided to secure the gazebo in

the ground. If you wish to secure the pavilion to a wood deck or concrete surface, use 16

anchors suited for these surfaces (anchors not included).

7. Check all bolts for tightness before and during usage.

8. Please check your state and local regulations prior to purchasing. Some jurisdictions may

require permits for installation and use. Some special procedures may be valid in your area.

9. While this gazebo is manufactured to withstand strong force winds through only the supplied

ground stakes, securing the gazebo to a deck, concrete patio or a stronger base, in areas

subject to frequent severe weather should be considered.

NOTE: The gazebo’s roof and structure are not guaranteed against extreme weather

conditions (storms, high winds, etc.). If the gazebo is not dismantled for the winter, snow must

be cleaned off regularly. Any damage caused by snow accumulation is not covered by the

warranty.

Limited Warranty:

This limited warranty is extended to the original purchaser and applies to defects in materials

and workmanship of your item provided the item is maintained with care and used only for

personal, residential purposes.

The item is warranted to be free from defects in material or workmanship for a period of one (1)

year. We don't reimburse for transportation or delivery costs, or compensate the individual or

any outside party for assembling or disassembling the product.

Items used for commercial, contract, or other non-residential purposes, or items damaged due

to acts of nature, vandalism, misuse, or improper assembly are not covered. Corrosion or

rusting of hardware is not covered. Proof of purchase (dated register receipt) is required for

warranty claims. Warranty is to the original purchaser and is non-transferable. Any

replacement of warranted items will be in the original style and color, or a similar style and

color if the original is unavailable or has been discontinued. As some states do not allow

exclusions or limitations on an implied warranty, the above exclusions and limitations may not

apply. This warranty gives you specific rights, and you may also have other rights, which vary

from state to state.

Exclusions:

Maintenance:

Our iron/steel components for garden accessories and patio items are coated with rust

inhibiting paint that protects it from rusting. However, due to the nature of iron, surface

oxidation (rusting) will occur once these protective coatings are scratched.

This is a natural

process and is not a defect! To minimize this condition, we recommend care when assembling

& handling the product to prevent scratching the paint. Should any scratching or damage occur,

we recommend immediate touch-up with rust inhibiting paint. Surface rust can also be easily

removed with a very light application of common cooking oil. If surface oxidation (rusting)

occurs and if no measure is taken to prevent this, the oxidation may start dripping on to deck or

patio and cause damaging stains, which may be difficult to remove. This can be prevented if

measure is taken to keep the product from oxidizing.

Important: Please do not return this product to the store. For technical assistance on

assembly or replacement parts. Please call Sunjoy Industries at 1-866-578-6569 from 8:00 am

EST to 8:00 pm PST or fax the replacement part form which is in the box to 1-740-283-3549 or

Email customer.care@sunjoygroup.com for assistance.

Made in China

2016-2（此处填写实际出货时间）

Inhaltsverzeichnis

Andere Sunjoy Gartenmöbel Handbücher

Sunjoy

Sunjoy L-GZ288PST-4D Bedienungsanleitung

Sunjoy

Sunjoy L-GZ1048PCO-A Bedienungsanleitung

Sunjoy

Sunjoy A106004502 Bedienungsanleitung

Sunjoy

Sunjoy 10'X10' OPP Gazebo L-GZ322PST Bedienungsanleitung

Sunjoy

Sunjoy A101006400 Bedienungsanleitung

Sunjoy

Sunjoy L-GG001PST-H Bedienungsanleitung

Sunjoy

Sunjoy SHELTON A101001910 Bedienungsanleitung

Sunjoy

Sunjoy A109000100 Bedienungsanleitung

Sunjoy

Sunjoy A108000100 Bedienungsanleitung

Sunjoy

Sunjoy L-DN1128SST-B Bedienungsanleitung

Sunjoy

Sunjoy L-GZ224PAL-1 Bedienungsanleitung

Sunjoy

Sunjoy MANHATTAN L-GZ1138PST-A Bedienungsanleitung

Sunjoy

Sunjoy A110000921 Beilage

Sunjoy

Sunjoy A102018220 Bedienungsanleitung

Sunjoy

Sunjoy L-BS630SST Bedienungsanleitung

Sunjoy

Sunjoy SummerCove A102017700 Bedienungsanleitung

Sunjoy

Sunjoy D-GZ841PST-E Bedienungsanleitung

Sunjoy

Sunjoy L-DN1196SAL-RC Bedienungsanleitung

Sunjoy

Sunjoy A111005700 Bedienungsanleitung

Sunjoy

Sunjoy L-GZ339PAL Bedienungsanleitung

Sunjoy

Sunjoy L-GZ937PST-C Bedienungsanleitung

Sunjoy

Sunjoy A102005803 Beilage

Sunjoy

Sunjoy L-GZ215PST-5B Bedienungsanleitung

Sunjoy

Sunjoy Grand Summer Bedienungsanleitung

Beliebte Gartenmöbel Handbücher anderer Marken

Belleze

Belleze 014-HG-20074 Bedienungsanleitung

Hatteras Hammocks

Hatteras Hammocks DCA1-K-HH Bedienungsanleitung

Kozyard

Kozyard Morgan Aluminum Pergola Bedienungsanleitung

Lemeks

Lemeks Palmako PA120-5959 Installationshandbuch

OLT

OLT 24 Bedienungsanleitung

forest-style

forest-style HACIENDA 2354 Bedienungsanleitung

Courtyard Creations

Courtyard Creations RUS0188-WM Bedienungsanleitung

RPR

RPR OLLIE CHAIR Bedienungsanleitung

kingsley-bate

kingsley-bate MC-55 Bedienungsanleitung

Weltevree

Weltevree Carrier Bedienungsanleitung

Grange Fencing

Grange Fencing Elite Arch Bedienungsanleitung

Grosfillex

Grosfillex AUVENT YR14 Bedienungsanleitung

X-METAL

X-METAL EAGLE 33511 Bedienungsanleitung

Anova

Anova FBW6R Bedienungsanleitung

Outsunny

Outsunny 84A-090 Bedienungsanleitung

Ivy Terrace

Ivy Terrace IVTD212 Bedienungsanleitung

Breezesta

Breezesta FANBACK ADIRONDACK AD-0101 Bedienungsanleitung

hanit

hanit SUTTON 1 Bedienungsanleitung