D ar cli nt,
W thank you for choosing on of our products, th r sult of t chnological xp rtis and continu d r s arch in pursuit of a sup rior
product in t rms of saf ty, r liability and f atur s.
In this manual you will find all th information and us ful advic n c ssary to g t th most out of your applianc in total saf ty.
DT2010001-01
See the guarantee certificate enclosed with the product for the terms, limitations and exclusions.
n line with its policy of constant product improvement and renewal, the manufacturer may make changes without notice.
This document is the property of Gruppo Piazzetta S.p.A.; no part of it may be disclosed to third parties without the written permission of Gruppo
Piazzetta S.p.A. All rights reserved by Gruppo Piazzetta S.p.A..
• This instruction booklet has been prepared by the manufacturer and is an integral part
of the product. n the event of sale or relocation of the product make sure this booklet
accompanies it, since the information contained in it is intended for the purchaser and
for anyone involved in the installation, use and maintenance of the product.
• Read the instructions and the technical information contained in this booklet carefully
before proceeding with installation, use or any repairs.
• The observance of the instructions and technical information in this instruction booklet
guarantees the safety of persons and property; it also ensures more efficient operation
and an increased lifespan.
• Gruppo Piazzetta S.p.A. cannot be held responsible for damage or injury due to failure
to comply with the instructions for installation, use and maintenance given in this
booklet, or due to unauthorised alterations or to the use of other than original spare
parts.
• Appliance installation and use must conform with the manufacturer’s instructions as
well as with European and national legislation and local regulations.
• nstallation, electrical connection, checks, maintenance and repairs are operations
which must be carried out exclusively by qualified and authorised personal with
specialised knowledge of the product.
• The wall against which the product is to be placed must not be of wood or any other
flammable material. For correct installation it is also important to comply with the
section entitled “Safety distances”.
• Before installing the product read all instruction booklets relevant to the cladding, the
ventilation kit and any other accessory.
• Check that the floor where the product is to be installed is perfectly level.
• When handling the steel parts of the cladding it is advisable to use clean cotton gloves
to avoid leaving fingerprints that are difficult to remove at first time of cleaning.
• The stove must be assembled by at least two persons.
• Connect the pellet stove to the electricity supply only after it has been connected by
an expert to the flueway.
• The plug at the end of the power cable must be easily accessible after installation.
• Use only recommended wood pellets in the pellet stove (refer to section entitled “FUEL”).
• Never use liquid fuels to light the pellet stove or to relight the embers.
• Ensure that the area where the stove is installed is properly ventilated while the stove
is lit.
• n the event of malfunctioning the fuel supply will be stopped. Restart the stove only
after having eliminated the cause of the malfunction.
• Stop using the product in the event of fault or malfunctioning.
• Do not remove the protective grille from the pellet hopper.
• Any build-up of unused pellets in the burner left over from repeated failed ignitions
must be removed before attempting to light the stove again.
• Stove operation can result in surfaces, handles, flue pipe and glass becoming
extremely hot. When the stove is in operation, only touch these parts if wearing
protective clothing otherwise use suitable tools.
• Because of the build-up of heat on the glass, take care that those who are unfamiliar
with stove operation do not linger near the stove.
• This appliance must not be used by persons (including children) with reduced physical,
sensory or mental capacities, or lack of experience or knowledge unless they are
supervised or instructed on use of the appliance by the person who is responsible for
its safety.
• Creaking may be heard while the stove is in operation or cooling down. This is not to
be considered a defect, but is a consequence of thermal expansion of the component
materials.
• The product you have purchased may different slightly from the one illustrated in this
booklet since the pictures are only given as an indication and not an exact portrayal.
In the event of difficulties or if you are unable to understand the instruction
booklet, contact your local dealer.
Do not place objects which are not heat-resistant on top of the stove or
within the recommended minimum safety area.
Do not open the door while the stove is in operation or operate the stove
when the glass is broken.
EN 14785 Residential space heating appliances fired by wood pellets. Requirements and test methods
EN 832 Thermal performance of buildings - Calculation of energy use for heating - Residential buildings
UN 10683 Heat generators fired by wood or other solid biofuels - nstallation requirements
UN 10847 Single flue systems for liquid and solid fuel generators - Maintenance and inspection - Guidelines
and procedures
UN 7129 Gas installations for domestic use fired by mains gas supply. Design, installation and maintenance.
D N 51731 class HP2 Fuels
ÖNORM M7135 Fuels
CE EN 60335-1 Safety of household and similar electrical appliances.
Safety. Part 1: General requirements
CE EN 50165÷1997 Electrical equipment of non-electric appliances for household and similar purposes – Safety
requirements
EN 1856-1 Chimneys - Requirements for metal chimneys - Part 1: System chimney products
EN 1856-2 Chimneys - Requirements for metal chimneys - Part 2: Metal liners and connecting flue pipes
EN 1443 Chimneys – General requirements
IMPORTANT INFORMATION DT2010208-07
REFERENCE STANDARDS DT2010209-05
H07022850 / DT2000426 - 00
