Tannoy OCV 8 Bedienungsanleitung

OCV OWNER MANUAL_01

Series

OWNER’S MANUAL

Series

02_ OCV OWNER MANUAL

CONTENTS

INTRODUCTION 02 WIRING & SETTING UP 06

UNPACKING 02 DIMENSIONS 07

SAFETY NOTICES 02 TECHNICAL SPECIFICATIONS 08

PRODUCT FEATURE IDENTIFICATION 03 WARRANTY 09

ACCESSORIES 04 DECLARATION OF CONFORMITY 10

INSTALLATION GUIDE 05

INTRODUCTION

Thank you for purchasing this Tannoy Product loudspeaker.This product range is suited for high-level music and

speech reinforcement applications requiring exceptional sonic quality with uncompromised reliability.

UNPACKING

Every Tannoy product and accessory is carefully inspected before packing. After unpacking, please inspect your

product to make sure no damage has occurred in transit. In the unlikely event of any damage, would you please

notify your dealer immediately and retain your shipping carton, as your dealer may ask you to return the faulty unit to

them for inspection.

Each OCV loudspeaker is provided with the following accessories as standard; Gripple speed clamps, release key,

1 x hanging cable, 1 x safety cable, 1 x terminal weather boot, 1 x euroblock connector, 3/8” screwed rod adaptor,

cable ties.

SAFETY NOTICES

Some regional construction codes require the use of a secondary method of securing loudspeakers in ceiling to

provide security of a backup support. A secondary support line should be attached from the safety loop on the rear of

the product to a source point on the ceiling. Please consult the relevant construction codes in your region.

Tannoy will not be held responsible for any damages caused by the improper installation of these loudspeakers.

SAFETY NOTE:

In order to comply with the relevant re safety regulations (ie. BS 5839:1998), it is required that in the event of re,

that failure of the circuit to which the loudspeaker is connected does not occur before evacuation of the building is

complete. Suitable measures include: -

a) use of terminal blocks (for connection to primary) with a melting point of not less than 650°C, for example

constructed from ceramic materials;

b) use of terminal blocks of a lower melting point but protected with thermal insulation;

c) use of terminal blocks such that, on melting, an open-circuit or a short-circuit does not occur.

Series

OCV OWNER MANUAL_03

Series

PRODUCT FEATURE IDENTIFICATION

OCV 6 / OCV 8

HANGING / SAFETY POINT

TAP SELECTOR

EUROBLOCK

04_ OCV OWNER MANUAL

ACCESSORIES

HANGING / SAFETY WIRES

WEATHER BOOT 3/8” SCREWED ROD ADAPTOR

GRIPPLE SPEED CLAMP

OCV OWNER MANUAL_05

Series

INSTALLATION GUIDLINES

1. Gripple Instructions 2. Thread hanging cable

through Gripple as shown

3. Secure the cable to the

xing as shown.

NOTE: Repeat 1 and 2

for the safety cable.

4. Pull the cable through to adjust height. Pull to tighten.

Insert release key to loosen or adjust.

5. The hanging cable

should be attached to

the centre hole on

the bracket.

NOTE: The Safety cable

can be attached to either

of the secondary holes.

06_ OCV OWNER MANUAL

WIRING AND SETTING UP:

1. Remove the euroblock connector from the socket

2. Feed the cable through the rubber grommet then

connect the euroblock connector to the cable observing

the correct polarity

3. For connection to an amplier, use pins 1 and 2:

Pin 1 is positive

Pin 2 is negative

For connection to additional speakers in a distributed line,

pins 3 and 4 are in parallel where:

Pin 3 is negative

Pin 4 is positive

4. Connect the euroblock connecter then replace the rubber grommet

to ensure the speaker is sealed.

THE SPEAKER IS SUPPLIED IN LOW IMPEDANCE MODE.

NEVER CONNECT THE SPEAKER TO A 70/100 VOLT AMPLIFIER

WHILE IT IS SET FOR LOW IMPEDANCE.

5. The OCV 6 and OCV 8 is tted with a 60W transformer. When used in

distributed-line systems, the transformer can be tapped at

60W, 30W, and 15W, with an additional 7.5W tapping for

70.7V line systems.

OCV OWNER MANUAL_07

Series

DIMENSIONS

OCV 6

OCV 8

Pendant 601

Ø260.0mm

[10.23"]

382.1

[15.04"]

399.5

[15.73"]

423.2

[16.66"]

423.2

(16.66”)

382.1

(15.04”)

399.5

(15.73”)

O260.0

(10.23”)

Pendant 801

445.5

[17.54"]

492.6

[19.39"] 465.7

[18.33"]

302.0

[11.89"]

492.6

(19.39”) 445.5

(17.54”)

465.7

(18.33”)

O302.0

(11.89”)

08_ OCV OWNER MANUAL

TECHNICAL SPECIFICATIONS

OCV 6 OCV 8

PERFORMANCE

Frequency Response (-3dB) (1) 80Hz - 20kHz 75Hz - 20kHz

Frequency Range (-10dB) (1) 60Hz - 30kHz 60Hz - 30kHz

System Sensitivity (1W @1m) (2) 88dB 90dB

Dispersion (-6dB) 90 degrees conical 80 degrees conical

Transducers Coaxial Coaxial

Low Frequency 150mm (6.00”) mineral 200mm (8.00”) mineral

loaded cone material loaded cone material

High Frequency 20mm (0.79) 25mm (1.00”)

Crossover 5.4kHz - 2nd order LF, 2nd order HF 4.5kHz - 3rd order LF, 2d order HF

Directivity (Q) 11.3 averaged 1kHz to 6.3kHz 14.4 averaged 1kHz to 6.3kHz

Directivity (DI) 10.5 dB averaged 1kHz to 6.3kHz 11.6 dB averaged 1kHz to 6.3kHz

Rated Maximum SPL (2) 105dB (average) 111dB (peak) 108dB (average) 114dB (peak)

Power Handling

Average 60W 70W

Programme 120W 140W

Peak 240W 280W

Recommended Amplier Power 120W @ 16 Ohms 140W @ 16 Ohms

Nominal Impedance 16 Ohms 16 Ohms

Distortion 10% Full Power (9.8V) 2nd Harmonic 3rd Harmonic (6.48V) 2nd Harmonic 3rd Harmonic

250Hz 0.42% 0.14% 0.56% 0.11%

1kHz 0.11% 0.31% 0.20% 0.24%

10kHz 1.27% 0.16% 1.19% 0.15%

Distortion 10% Full Power (3.1V) 2nd Harmonic 3rd Harmonic (2.05V) 2nd Harmonic 3rd Harmonic

250Hz 0.16% 0.16% 0.14% 0.16%

1kHz 0.05% 0.18% 0.08% 0.18%

10kHz 0.27% 0.27% 0.44% 0.09%

CONSTRUCTION

Enclosure ABS / Steel ABS / Steel

Grille Steel, plated and powder coat painted Steel, plated and powder coat painted

Connectors Euroblock type removable locking Euroblock type removable locking

connector with screw terminals with connector with screw terminals with

“loop through” facility “loop through” facility

Transformer setting Rotary switch Rotary switch

Bezel diameter 260mm (10.23”) 302mm (11.89”)

Overall Length 423mm (16.66”) 492.5mm (19.39”)

Net Weight 5.9kg (12.96lbs) 7.8kg (17.2lbs)

Shipped weight 7.5kg (16.53lbs) 9.8kg (21.6lbs)

Transformer Taps

70V 60W / 30W / 15W / 7.5W 60W / 30W / 15W / 7.5W

& low Impedance operation & low Impedance operation

100V 60W / 30W / 15W & 60W / 30W / 15W &

low Impedance operation low Impedance operation

Packed quantity 1 1

Notes

(1) Average over stated bandwidth. Measured at 1 metre on axis in an anechoic chamber (2) Unweighted pink noise input, measured at 1 metre in an anechoic chamber

A full range of measurements, performance data, and Ease™ Data can be downloaded from www.tannoy.com

Tannoy operates a policy of continuous research and development. The introduction of new materials or manufacturing methods will always equal or

exceed the published specications, which Tannoy reserves the right to alter without prior notice. Please verify the latest specications when dealing

with critical applications.

OCV OWNER MANUAL_09

Series

WARRANTY

No maintenance of the OCV pendant speaker is necessary.

All Tannoy professional loudspeaker products are covered by a 5 year warranty from the date of manufacture

subject to the absence of misuse, overload or accidental damage. Claims will not be considered if the serial

number has been altered or removed. Work under warranty should only be carried out by a Tannoy Professional

dealer or service agent. This warranty in no way affects your statutory rights. For further information please

contact your dealer or distributor in your country.

Customer Services, Tannoy Ltd., Rosehall Industrial Estate, Coatbridge, Strathclyde ML5 4TF, Scotland

Telephone: 01236 420199 (National)

+44 1236 420199 (International)

Fax: 01236 428230 (National)

+44 1236 428230 (International)

E-mail: enquiries@tannoy.com

service@tannoy.com

Service Info, TC Group Americas

Telephone: (800) 565-2523 (toll free)

(519) 745-1158

Fax: (519) 745-2364

E-mail: [email protected]

Web: www.tcgroup-americas.com

DO NOT SHIP ANY PRODUCT TO TANNOY WITHOUT PREVIOUS AUTHORISATION

PLEASE NOTE: In order to direct you to the appropriate service facility a return authorization and instructions must be

issued in advance - do not send any equipment to any Tannoy or TC Group Americas facility without prior authorization

or it will be refused. In some cases a local service facility can be recommended.

Our policy commits us to incorporating improvements to our products through continuous research

and development. Please conrm current specications for critical applications with your supplier.

010_ OCV OWNER MANUAL

DECLARATION OF CONFORMITY

The following apparatus is manufactured in China for Tannoy Ltd of Rosehall Industrial Estate, Coatbridge, Scotland,

ML5 4TF and conform(s) to the protection requirements of the European Electromagnetic Compatibility Standards

and Directives relevant to Domestic Electrical Equipment. The apparatus is designed and constructed such that

electromagnetic disturbances generated do not exceed levels allowing radio and telecommunications equipment

and other apparatus to operate as intended, and, the apparatus has an adequate level of intrinsic immunity to

electromagnetic disturbance to enable operation as specied and intended.

Details of the Apparatus: Tannoy Contractor Loudspeaker

Model Number: OCV

Associated Technical File: EMCi6

Applicable Standards: EN 50081-1 Emission

EN 50082-1 Immunity

Signed:

Position: Director of Engineering

Date: 13th Apr. 11.

Inhaltsverzeichnis

Andere Tannoy Sprecher Handbücher

Tannoy

Tannoy CMS PI Series Bedienungsanleitung

Tannoy

Tannoy SR601 Bedienungsanleitung

Tannoy

Tannoy CVS Series Bedienungsanleitung

Tannoy

Tannoy PRESTIGE Autograph Mini Bedienungsanleitung

Tannoy

Tannoy IW60EFX Bedienungsanleitung

Tannoy

Tannoy ACTIVE STUDIO MONITORS Bedienungsanleitung

Tannoy

Tannoy EFX-1 Bedienungsanleitung

Tannoy

Tannoy System 1000 Bedienungsanleitung

Tannoy

Tannoy CMS 1201DC Bedienungsanleitung

Tannoy

Tannoy Definition Bedienungsanleitung

Tannoy

Tannoy T12 Bedienungsanleitung

Tannoy

Tannoy Eclipse Bedienungsanleitung

Tannoy

Tannoy MERCURY Vi Bedienungsanleitung

Tannoy

Tannoy Reveal X Bedienungsanleitung

Tannoy

Tannoy arena ELITE Bedienungsanleitung

Tannoy

Tannoy VLS 15 Bedienungsanleitung

Tannoy

Tannoy DVS Series Bedienungsanleitung

Tannoy

Tannoy POWER V15 Bedienungsanleitung

Tannoy

Tannoy Qflex Bedienungsanleitung

Tannoy

Tannoy CVS 4 (EN54) Bedienungsanleitung

Tannoy

Tannoy QCI 6DC Bedienungsanleitung

Tannoy

Tannoy ProtoJ Bedienungsanleitung

Tannoy

Tannoy Ellipse 8 Passive Bedienungsanleitung

Tannoy

Tannoy iw6 DS Discrete Bedienungsanleitung

Beliebte Sprecher Handbücher anderer Marken

argon audio

argon audio IE20 Bedienungsanleitung

Denon

Denon SC-N7 Bedienungsanleitung

Gemline

Gemline Ace 3952 Bedienungsanleitung

Focal

Focal ON WALL 300 Bedienungsanleitung

HEADRUSH

HEADRUSH Maximus HRSP 5024 Bedienungsanleitung

SoundLogic

SoundLogic BCCS-6/6395 Bedienungsanleitung

Peavey

Peavey DTH 218 Bedienungsanleitung

Avantree

Avantree Pluto Air Bedienungsanleitung

Morel

Morel Integra Series INTEGRA OVATION 4 Bedienungsanleitung

Oppo

Oppo SONICA Bedienungsanleitung

Bose

Bose SoundLink Wireless Music System Bedienungsanleitung

Rocksteady

Rocksteady Stadium Bedienungsanleitung

Bowers & Wilkins

Bowers & Wilkins 4 Bedienungsanleitung

Sonance

Sonance SONOS OUTDOOR Series Bedienungsanleitung

Electro-Voice

Electro-Voice EVID FM4.2 Bedienungsanleitung

Pioneer

Pioneer XW-HTD630 Bedienungsanleitung

Onn

Onn BWA16AA002 Bedienungsanleitung

HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung