Teknik Avon 5422051 Bedienungsanleitung

Credenza

Avon Collection | Model 5422051

NOTE: THIS INSTRUCTION

BOOKLET CONTAINS IMPORTANT

SAFETY INFORMATION.

PLEASE READ AND KEEP FOR

FUTURE REFERENCE.

Your center of

attention.

Teknik

www.teknikoffice.co.uk

Table of Contents Assembly Tools Required

Part Identiﬁcation

Hardware Identiﬁcation

Assembly Steps

Safety

No. 2 Phillips Screwdriver

Tip Shown Actual Size

WARNING

Skip the power trip.

This time.

5-28

Use of a TV that is too heavy or large is hazardous. A TV that is too heavy will create a risk of a tip-over that can cause severe injury or

death. A TV that is too large for the available space might be accidentally pushed or bumped o the furniture, or subject to tip-over.

• Check the size and weight of your TV. Compare it to the diagram below – before you begin assembly!

• This Sauder unit is designed for use with televisions weighing less than 70 pounds. Never use with a TV that weighs more.

• The size of the television, front-to-back and side-to-side, must ﬁt within the space deﬁned in the diagram.

• Never place the front edge of the TV past the front edge of the TV support shelf (or stop molding – if equipped)

• Never allow the sides of the TV to extend past the side edges of the TV support surface.

• If the TV has a CRT picture tube, the picture tube cone may extend past the rear of the support shelf.

• Be sure to apply the warning label as instructed in the last assembly step. The label provides important safety related information.

70 lbs.

17-1/2"

60-1/8"

Page 2

Short Screwdriver

Part Identiﬁcation

åWhile not all parts are labeled, some of the parts will have a label or an inked letter on the edge

to help distinguish similar parts from each other. Use this part identiﬁcation to help identify similar parts.

Now you know

our ABCs.

A RIGHT END (1)

B LEFT END (1)

C UPRIGHT (1)

D TOP (1)

E SHELF (1)

F BOTTOM (1)

G UPPER DIVIDER (1)

H LOWER DIVIDER (1)

J ADJUSTABLE SHELF (1)

K BACK (1)

L DOOR (1)

M RIGHT DRAWER FRONT (1)

N LEFT DRAWER FRONT (1)

O RIGHT DRAWER SIDE (2)

P LEFT DRAWER SIDE (2)

Q DRAWER BACK (2)

R DRAWER BOTTOM (2)

S LEG (2)

T STRETCHER (3)

Page 3

Hardware Identiﬁcation

åScrews are shown actual size. You may receive extra hardware with your unit.

Page 4

HIDDEN CAM - 9

3ANGLED HEAD

CAM SCREW - 9

Angled head

(EXTENSION SET SHOWN SEPARATED)

1EXTENSION RAIL - 4 2EXTENSION SLIDE - 4

WOOD DOWEL - 9

SMALL HIDDEN

CAM - 8

5STRAIGHT HEAD

CAM SCREW - 8

Straight head

PLASTIC BRACKET - 8

HINGE - 2

9CLIP - 12

11 PULL - 3

12 METAL PIN - 4

(Refer to the last step for proper location and application)

WARNING LABEL - 1

522,68 22,68

70 lbs. 31,75 kg 31,75 kg

APPLIQUE CARD - 3

14 BLACK 1-1/2" FLAT HEAD SCREW - 13

BLACK 1/2" MACHINE SCREW - 36

BLACK 1/2" WAFER HEAD SCREW - 12

SILVER 1/2" FLAT HEAD SCREW - 4

BLACK 1/2" PAN HEAD SCREW - 6

SMALL BLACK 1/2" PAN HEAD SCREW - 24

SILVER 5/8" FLAT HEAD SCREW - 12

HINGE BRACKET - 2

Step 1

Page 5

å Assemble your unit on a carpeted ﬂoor or on the empty

carton to avoid scratching your unit or the ﬂoor.

å Push nine HIDDEN CAMS (3) into the UPRIGHT (C),

SHELF (E), and DIVIDERS (G and H).

Arrow

3 (9 used)

Some assembly

(and snacks) required.

Arrow

The arrow in the HIDDEN

CAM must point toward the

hole in the edge of the board.

Hole

Arrow

Step 2

Page 6

å Turn nine ANGLED HEAD CAM SCREWS (4) into the exact

holes shown in the RIGHT END (A), UPRIGHT (C), TOP (D),

and SHELF (E).

(9 used)

Angled head

Surface with

HIDDEN CAMS

Step 3

Page 7

å Fasten the PLASTIC BRACKETS (8) to the TOP (D) and

BOTTOM (F). Use eight BLACK 1/2" MACHINE SCREWS (18).

å NOTE: Be sure to position the BRACKETS exactly

as shown.

BLACK 1/2" MACHINE SCREW

(8 used in this step)

å Fasten the HINGE BRACKETS (10) to the LEFT END (B).

Use the screws in the HINGE BRACKETS.

å NOTE: Be sure to position the HINGE BRACKETS exactly

as shown.

Step 4

Page 8

Groove

Step 5

Page 9

å Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be

prepared, the parts are greasy.

å Fasten two EXTENSION RAILS (1) to the RIGHT END (A) and UPRIGHT (C). Use six SMALL BLACK 1/2" PAN

HEAD SCREWS (21).

å NOTE: Use the exact holes shown.

å NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner

cartridge of the EXTENSION RAIL out to ﬁnd the other holes that line up with the holes in the END and UPRIGHT. Turn

a SCREW into these holes.

Pull down on the black lever and pull the SLIDE from the RAIL.

SMALL BLACK 1/2" PAN HEAD SCREW

(6 used in this step)

Surface with

CAM SCREWS

Surface with

CAM SCREWS

Groove

Use this hole

Open end

Step 6

Page 10

å Fasten two EXTENSION RAILS (1) to both surfaces of the LOWER DIVIDER (H). Use six SMALL BLACK 1/2" PAN

HEAD SCREWS (21).

å NOTE: Use the exact holes shown.

å NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner

cartridge of the EXTENSION RAIL out to ﬁnd the other holes that line up with the holes in the LOWER DIVIDER. Turn a

SCREW into these holes.

SMALL BLACK 1/2" PAN HEAD SCREW

(6 used in this step)

Use the small

round hole

Use the slotted hole

Open end

Surface with

HIDDEN CAMS

Surface without

HIDDEN CAMS

Finished edge

Andere Teknik Inneneinrichtung Handbücher

Teknik

Teknik Hampstead Park Narrow Bookcase 5420283 Bedienungsanleitung

Teknik

Teknik City Centre 5427120 Bedienungsanleitung

Teknik

Teknik 5426135 Bedienungsanleitung

Teknik

Teknik 5422378 Bedienungsanleitung

Teknik

Teknik Boutique Style Desk Bedienungsanleitung

Teknik

Teknik Scribed Oak Storage Desk 5418294 Bedienungsanleitung

Teknik

Teknik Clifton Place 5421116 Bedienungsanleitung

Teknik

Teknik 5414142 Bedienungsanleitung

Teknik

Teknik 5425907 Bedienungsanleitung

Teknik

Teknik 5423505 Bedienungsanleitung

Teknik

Teknik Scribed Oak Desk 5414836 Bedienungsanleitung

Teknik

Teknik 5427430 Bedienungsanleitung

Teknik

Teknik 5421120 Bedienungsanleitung

Teknik

Teknik 5427872 Bedienungsanleitung

Teknik

Teknik 5414873 Bedienungsanleitung

Teknik

Teknik 5410416 Bedienungsanleitung

Teknik

Teknik Montreal Swivel Recliner Bedienungsanleitung

Teknik

Teknik Stationmaster 5426454 Bedienungsanleitung

Teknik

Teknik 5424944 Bedienungsanleitung

Teknik

Teknik 5431262 Bedienungsanleitung

Teknik

Teknik 5420649 Bedienungsanleitung

Teknik

Teknik 5426510 Bedienungsanleitung

Teknik

Teknik Essentials L-Shaped Desk 5425092 Bedienungsanleitung

Teknik

Teknik Barrister Home 4 Drawer Chest Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung