Teletype PocketTracker 1442 Montage- und Bedienungsanleitung

User Manual Addendum

TeleType GPS

PocketTracker System

TeleType Part #1442

Revision 1.2

Aug 1, 2002

TeleType Co. Inc.

20 Park Plaza

Boston, MA 02116

1-617-542-6220

www.teletype.com

Introduction

This documentation is an addendum to the TeleType GPS software manual. This document is

intended for use by TeleType GPS software customers who have purchased the PocketTracker

(part #1442). We will refer to this device as the “PocketTracker”. The PocketTracker allows you

to track the location of another PocketTracker user or allow your position to be tracked.

Currently the Pocket Tracker service is free with purchase of the hardware, but that is not

guaranteed after October 2002.

Software Installation

1. To monitor the position of a PocketTracker user or to have your position tracked, you will

need to install the TeleType GPS software onto a Windows 98/NT/2000/XP computer (which

we will refer to as the “desktop computer”) with internet access or a PDA running PocketPC

2000 or newer (which we will refer to as the “PDA”).

a) Insert the TeleType GPS CDROM into your CD drive.

b) An automatic splash screen will appear.

c) Select Install Program.

d) Select PC (for install onto the desktop computer) or PocketPC (for install onto

the PDA) when prompted.

e) Follow the directions for installation as prompted by the installer. You can also

refer to the TeleType GPS User Manual which can be found online or in the Gps

folder on your hard drive.

2. Install the desired TeleType GPS maps from the CD to your hard drive.

a) Return to the splash screen.

b) Select the installation folder.

c) Select the state maps to install.

d) Click Install.

3. Activate the TeleType GPS program by double clicking the TeleType GPS program icon on

your desktop computer or PDA.

4. Determine whether the user to be tracked has a static or dynamic IP address

a) Dynamic IP – The Internet address of the PDA or computer is not always the

same. This is typically the case when connecting to the Internet over the phone line

or with CDPD (Cellular Digital Packet Data or Wireless IP) services. Dynamic IP

systems are used when the Internet Connection does not always have to be

available.

b) Static IP – The Internet address of the PDA or computer is always the same. Static

IP addresses are provided by some DSL and Cable Modem providers, and are

often used in business networks.

5. Setup the user to be tracked using the Pocket Tracker system

For Dynamically Assigned IP Addresses

a) Select Track, Pocket Track, Dynamic IP, and Setup.

b) Click ID.

c) Enter the User ID and Password provided when you purchased the Pocket Tracker

software.

d) Click OK.

e) Click Exit.

f) Select Track, Pocket Track, Dynamic IP, and Keep Sending.

For Static IP Addresses

If you have a device with a static IP address, no setup is required.

4. Load the appropriate maps into the TeleType GPS program.

a) Click on the city or cities you would like to load maps for and select “Load Street

Maps”

5. Enter the Pocket Tracker ID, Description, and Password for each user you wish to track

For Dynamically Assigned IP Addresses

a) Select Track, Pocket Track, Dynamic IP, Setup.

b) Click add and enter the ID for the PocketTracker user you wish to track.

c) Enter the description of this user you wish to track. Note that you cannot have

identical descriptions for two vehicles being tracked on the same computer or

PDA.

d) Enter the password for the ID. Your password has been assigned and is enclosed

in your product shipment.

e) Optionally, you can select a different icon for the user you wish to track, in order

to differentiate between multiple Pocket Tracker users.

f) Click OK.

g) Click Modify, and select the ID of the user that was just added from the list

h) Change the frequency of the position updates and the resolution of the updates.

i) Click OK.

j) Click Exit.

k) Select Track, Pocket Track, Dynamic IP, and Start Tracking.

For Statically Assigned IP Addresses

Note – Currently PocketPC devices can only manually track Static IP based

Pocket Tracker users. To query their position, highlight the user and click on

Query in the Pocket Tracker Setup window.

a) Select Track, Pocket Track, Static IP, and Setup.

b) Click add and enter the IP Address for the Pocket Tracker user you wish to track.

c) Enter the description of this user you wish to track. Note that you cannot have

identical descriptions for two vehicles being tracked on the same computer or

PDA.

d) Enter the password for the User. Your password has been assigned and is enclosed

in your product shipment.

e) Optionally, you can select a different icon for the user you wish to track, in order

to differentiate between multiple Pocket Track users.

f) Click OK.

g) Change the frequency of the position updates and the resolution of the updates.

h) Click OK.

i) Click Exit.

j) Select Track, Pocket Track, Static IP, and Start Tracking (PC Only).

6. In order to track the position of a PocketTracker user, both the user being tracked and the

person doing the tracking must be connected to the Internet. In the case of a mobile user,

CDPD service is recommended.

TeleType GPS Pocket Tracker Menu Description

The section above describes in detail how to set up the Pocket Tracker portion of the TeleType

GPS software. Further detail is provided with the screen prints shown below.

Setup – This will bring you to the setup screen described below.

Keep/Stop Tracking – These two menu options will turn on and off the tracking system. Once

one or more users are being tracked, “Stop Tracking” will be highlighted and “Keep Tracking”

will not be highlighted.

Keep/Stop Sending – This is for use by the Pocket Track user being tracked. Selecting “Keep

Sending” would turn on the Pocket Tracker system and allow the user to be tracked. “Stop

Sending” would turn off the Pocket Tracker system.

Server Setup – This is for entering the Pocket Tracker server address. The address of this server

is teletype.serveftp.com

Note – If you open the Waypoint window tracking of any users will be suspended until the

window is closed again.

Use the Pocket Tracker Setup window to configure the Pocket

Tracker system. Each line with a check in the box will be

tracked by the software.

Add - Allow you to add an additional Pocket Tracker user for

the system to track. See the setup instructions for how to add a

user.

Delete – Delete a user from the list.

Modify – Modify the information for the selected user. This

will allow you to change the description of a user, the frequency

of the updates on their position, and the resolution of their

position.

ID – Set the ID and Password of the user so that they can be

tracked.

Send Posit – Send your current position to the server.

Query – Query the position of the currently highlighted user.

Exit – Exit this window.

This is the screen as it appears on the PDA. Multiple vehicles

can be listed on this screen, but only the currently highlighted

vehicle will actually be tracked when the window is closed. Each

line shows the icon, the description, the ID number, the

frequency of position requests, and the resolution.

This is the window for modifying the tracking settings of a Pocket

Tracker user.

ID – Drop-down list of all of the currently entered IDs in the

program.

Description – Description of the vehicle or person being tracked.

Icon – List of different icons to choose from for each ID.

Frequency – How often the position of the ID will be checked.

Resolution – Determines if a new waypoint will be created if the

position has not changed by this amount. If the distance traveled

between position checks is less then this number, no new waypoint

will be created. Avoids the creation of multiple waypoints when the

vehicle or person is stationary.

\\Conferencee533\C\TeleType GPS Documentation\PocketTracker\PocketTracker_Manual.doc

Inhaltsverzeichnis

Andere Teletype GPS Handbücher

Teletype

Teletype WorldNav 5200 Installationshandbuch

Teletype

Teletype WorldNav 3300 Bedienungsanleitung

Teletype

Teletype WorldNav 3500 Installationshandbuch

Teletype

Teletype WorldNav 3100 Bedienungsanleitung

Teletype

Teletype WorldNav 4300 Bedienungsanleitung

Teletype

Teletype 1240 Bedienungsanleitung

Teletype

Teletype WorldNav 7650 Montageanleitung

Teletype

Teletype 2151 Series Bedienungsanleitung

Teletype

Teletype WorldNav 5100 Installationshandbuch

Teletype

Teletype SatelliteTracker 1405 Montage- und Bedienungsanleitung

Teletype

Teletype 2151 Series Bedienungsanleitung

Teletype

Teletype 1250 Bedienungsanleitung

Teletype

Teletype WorldNav Sicherheitsleitfaden

Teletype

Teletype 2151 Series Bedienungsanleitung

Teletype

Teletype WorldNav 3100 Bedienungsanleitung

Teletype

Teletype WorldNav 7100 Bedienungsanleitung

Teletype

Teletype Bluetooth GPS Receiver Bedienungsanleitung

Teletype

Teletype 1390 Bedienungsanleitung

Teletype

Teletype WorldNav 3300 Bedienungsanleitung

Teletype

Teletype 1351 Bedienungsanleitung

Teletype

Teletype WorldNav 3100 Bedienungsanleitung

Teletype

Teletype 2951 Series Bedienungsanleitung

Teletype

Teletype GPS Marine Bedienungsanleitung

Teletype

Teletype 2851 Series Bedienungsanleitung

Beliebte GPS Handbücher anderer Marken

Raven

Raven Cruizer II Handbuch

Hama

Hama 53118 Bedienungsanleitung

Garmin

Garmin SOUNDER 125 Bedienungsanleitung

Garmin

Garmin DEZL 580 Bedienungsanleitung

Jigabot

Jigabot EX Bedienungsanleitung

Pointer

Pointer Cellocator CelloTrack XT LTE Installationsanleitung

Queclink

Queclink GV55LITE Bedienungsanleitung

Voxson

Voxson Voxtrack GPS500 Gebrauchsanweisung

Garmin

Garmin ECHOMAP PLUS Bedienungsanleitung

Starcom Systems

Starcom Systems Kylos Compact Bedienungsanleitung

Garmin

Garmin 15 H Series Bedienungsanleitung

Cobra

Cobra Marine MC 600Ci Bedienungsanleitung

Cellocator

Cellocator CelloTrack T Bedienungsanleitung

Enfora

Enfora Mini-MT GSM2228UG001 Bedienungsanleitung

Magellan

Magellan eXplorist 100 Bedienungsanleitung

LTE

LTE G50B Bedienungsanleitung

Garmin

Garmin DEZL OTR500 Bedienungsanleitung

SkyGolf

SkyGolf SkyCaddie SG1 Bedienungsanleitung