ThePondguy LEDPro Series Bedienungsanleitung
LEDPro™ Series
High Output
Lights
Product Manual
TM
Important Information........................2
Technical Specs ...............................2
Installing Your LEDPro™ Lights .................3
Maintaining Your LEDPro™ Lights...............4
Troubleshooting..............................4
Warranty Information.........................4
Table of Contents:
For Models:
• LEDPro™Mini 1-Watt Light Kit,
3 Pack (Item #120813)
• LEDPro™3-Watt Light Kit,
3 Pack (Item #120810)
• LEDPro™6-Watt Light Kit,
3 Pack (Item #120817)
• LEDPro™12-Watt Single Light
(Item #120828)
MAINTAINING YOUR LEDPRO™LIGHTS:
THANK YOU FOR CHOOSING:
IMPORTANT INFORMATION:
Please read these instructions thoroughly before use. Failure to follow instructions may result in
equipment damage or failure, losses, injury or death.
DANGER:
To avoid possible electric shock:
• If the power cord, lens, or other components have been damaged, DO NOT operate, LEDPro™ Lights
should be replaced.
• Close supervision is necessary when the unit is used by or near children.
WARNING:
To reduce the risk of electric shock:
• Connect only to a properly grounded receptacle, which is serviced by a Ground Fault Circuit
Interrupter and never remove the ground pin from the plug.
• Provide a “drip loop”for the power cord. This is a loop in the cord below the level of the receptacle or
plug that prevents water from traveling along the cord in the direction of the receptacle.
• ALWAYS unplug the LEDPro™ Lights from power source when not in use, and before installing,
removing or servicing the LEDPro™ Light’s components.
• If an extension cord is necessary, a cord with a proper rating should be used. A cord may overheat if
the cord is rated for less amperes or watts than the unit rating.
• DO NOT immerse the LEDPro™ Light’s plug in water or attempt to use a wet plug.
• The LEDPro™ Lights are NOT suitable for use in swimming pools, swimming ponds, or other
situations where bodily contact is made with the water.
Important – LEDPro™ Lights may be used in or out of water. When used in open air application,
unplug the lights and allow to cool before servicing.
CAUTION:
To reduce the risk of equipment damage or failure:
• DO NOT place LEDPro™ Lights near ammable or other dangerous materials or objects.
• DO NOT use the LEDPro™ Lights in uids other than water.
• DO NOT exceed the voltage and wattage indicated on the transformer.
• DO NOT operate during freezing conditions. Remove LEDPro™ Lights and store in a protected
location.
IMPORTANT:
The Pond Guy® is not responsible for equipment damage or failure, losses, injury or death resulting
from failure to follow safety precautions, misuse or abuse of equipment.
TECHNICALSPECS :
MODEL # OF LIGHTS WATTAGE ITEM
NUMBER
LEDPro™ Mini 1-Watt 33x1 Watts 120813
LEDPro ™ 3-Watt 33x3 Watts 120810
LEDPro ™ 6-Watt 33x6 Watts 120817
LEDPro ™ 12-Watt 11x12 Watts 120828
thepondguy.com | 866-POND-HELP (766-3435)
2
INSTALLING YOUR LEDPRO™LIGHTS:
DO NOT TAMPER WITH POWER CORD.
Lights may be placed in or out of water.
Step 1
Plug the two-pin connector on the end of each Light(C) cord into the Splitter(B) and
tighten plastic retaining nut.
Step 2
Plug the two-pin connector on the end of the Splitter(B) cord into the Transformer(A)
and tighten plastic retaining nut.
Step 3
Place Lights(C) in desired locations.
Step 4
Make sure Photocell (E) is located out of the water, in an area exposed to natural light.
Step 5
Plug the Transformer(A) into a standard 110 volt outlet with GFCI.
(B)
(E)
(A) |-------3’-------|
16’
16’
16’
(C)
(D)
LEDPro™ 1, 3 & 6-Watt Light Kits
•(A) Transformer
•(B) Splitter
•(C) Light
•(D) Lens
•(E) Photocell
(E)
(A) 16’ (C)
LEDPro™ 12-Watt Single Light
(D)
6’6’
6’6’ 3’
(B)
15425 Chets Way | Armada, MI 48005 3
View other great products on-line at www.thepondguy.com
MAINTAINING YOUR LEDPRO™LIGHTS:
MAINTENANCE :
WARNING:
Before performing any maintenance, always unplug the LEDPro™ Lights from the
power source.
CLEAN lenses regularly to remove algae/debris buildup that will reduce light intensity.
CLEAN with a soft cloth or brush with water, or a descaler if needed. When using a
descaler be sure to rinse components well before reinstalling.
TROUBLESHOOTING :
One or more lights fail to illuminate:
• Check connection from Light(C) to Splitter(B)
• Inspect Lens(D) for algae/debris accumulation
• Ensure bulb is properly seated in housing
• Replace bulb (3-Watt light set only)
All lights fail to illuminate:
• Make sure Transformer(A) is properly seated in electrical outlet
• Make sure electrical outlet provides power
• Check Splitter(B) to Transformer(A) connection
• Check connections from Lights(C) to Splitter(B)
• Ensure bulbs are properly seated in housing and check photocell
Lights stay on during the day:
• Make sure photocell is upright, unobstructed & exposed to sunlight
PRODUCT WARRANTY:
LEDPro™ Series High Output Lights carry a 3-year warranty.
The Pond Guy® will repair or replace any units found to be
defective. This limited warranty is extended exclusively to
the original purchaser and begins from the date of original
purchase receipt. Abuse or misuse of this product or
power cord alterations void all warranty. Please call for
a Return Authorization Number prior to returning
product by calling our Customer Care Department at
866-766-3435. Failure to request an RMA number may
result in delay or dismissal of your warranty claim.
THANK YOU FOR CHOOSING:
The Pond Guy®Inc.
We Know Ponds™
15425 Chets Way
Armada, MI 48005
866-POND-HELP (766-3435)
thepondguy.com
REPLACEMENTPARTS/ACCESSORIES
DESCRIPTION ITEM
NUMBER
LEDPro ™ 3-Watt Replacement Bulbs
(Choose from red, blue, yellow, warm white, cool white.Warm white comes standard) 120812
ThePondGuy® Colored Lens Set for LEDPro™ Mini 1-Watt
(Comes with red, blue, yellow & green lenses ) 190135
20’ Extension Cord
(Maximum of 1 extension should be added per light) 110525
Dieses Handbuch passt für folgende Modelle
4
Inhaltsverzeichnis
Andere ThePondguy Außenleuchte Handbücher
Beliebte Außenleuchte Handbücher anderer Marken
LIGMAN
LIGMAN BAMBOO 3 Bedienungsanleitung
Maretti
Maretti TUBE CUBE WALL 14.4998.04 Bedienungsanleitung
Maxim Lighting
Maxim Lighting Carriage House VX 40428WGOB Bedienungsanleitung
urban ambiance
urban ambiance UQL1273 Bedienungsanleitung
TotalPond
TotalPond 52238 Bedienungsanleitung
Donner & Blitzen
Donner & Blitzen 0-02661479-2 Bedienungsanleitung