Thor 3D Calibry Bedienungsanleitung
3D scanner
User manual
Congratulations on your purchase of the latest
professional 3D scanner Calibry!
The device uses the latest developments in structured
light scanning and even enables the capture of complex
surfaces.
This guide provides information on how to install and
use Calibry software, how to operate the scanner, and
recommendations for the scanning process itself.
When using the device, keep in mind that the 3Dscanner
is a high-precision optical device that requires careful
attention. Careful use and compliance with the rules of
use will ensure a long life for the scanner.
3D scanner
1
Front panel
Scanner hardware
device
Geometric camera
Projector
Texture camera
Texture ash
User manual
2
Rear panel
Scanner hardware
device
Touch screen
Button «START»
Scanner data
cable connector
Button «STOP»
3D scanner
3
Connect the scanner to a computer with the Calibry Nest
software installed.
•Strictly follow the connection sequence. Make all connections when
the power supply unit is disconnected. Connect the power supply unit
when all other connections have been made. Otherwise, the equipment
may be damaged, and this case will not be covered under the warranty.
When the scanner is powered on, it turns on automatically.
•When you rst connect the scanner to the computer, we recommend
that you connect the computer to the Internet. In this case, the software
will automatically download the scanner calibration le, and the scanner
will be ready for use. Otherwise, you can manually download the calibra-
tion le. The calibration le can be requested from the supplier of the
scanner.
Pre-starting
procedure
User manual
4
Main screen elements
After the scanner is loaded, the main screen is displayed
Scanner
operation
Status bar
The status bar shows the
status of the scanner
Control panel
The control panel is used
to display the sidebar.
Here you can also specify
the name of the current
project (the object being
scanned) by clicking on
the title in the centre.
All scanned parts of the
object will be placed in
the folder with this name.
If the project name is not
specied or is empty, a
standard name indicating
the full scan date will
be applied, for example,
«SCAN_ 20200101».
3D scanner
5
List of scans
Scanner
operation
The sidebar
presents information on
the available and occupied
space on the hard disk of
the computer, to which the
scanner is connected, as
well as buttons for scanner
settings and the scanner
data.
User manual
6
List of scans
Scanner
operation
The list of scans
During the scanning pro-
cess, the list of all scans
carried out will be placed
on the main screen. The
scans are sorted by crea-
tion date: the newer, the
higher. Scans can also be
grouped in their respective
project sections. At any
time, you can switch to
another project by click-
ing on the section bar, or
create a new project by
typing its name in the title.
All scans carried out are
saved to the hard disk of
the computer to which the
scanner is connected.
3D scanner
7
List of scans
Scanner
operation
Any scan in the project
can be deleted by simply
swiping the item in the list
sideways.
You can cancel the
deletion within 5 seconds
by clicking the «Cancel»
button.
You can delete all scans
by clicking the «Delete All
Scans» button
User manual
8
Inhaltsverzeichnis
Andere Thor 3D Scanner Handbücher
