THORENS TD402 DD Bedienungsanleitung

16 USER GUIDE

TD402 DD

BEDIENUNGSANLEITUNG

USER GUIDE

MANUEL D’UTILISATION

РУКОВОДСТВО ПОЛЬЗОВАТЕЛЯ

使用手册

17FEATURES / TOP PANEL

0609

01. Counterweight

The counterweight is used for precise adjustment of the stylus pressure on the vinyl, to properly balance the

tonearm.

02. Anti-Skating Control

To set the anti-skating force of the tonearm.

03. Tone arm Lever

Use this lever to lower and raise the tonearm.

04. Tone arm Lock (arm rest)

To lock the tone arm in place when not in use.

05. Headshell

This holds the needle in place and provide needle protection

06. START/STOP switch

To switch to “START” to start the playing or switch to “STOP” to stop the playing

07. Platter

Place the record here when playing.

08. Rubber Mat

To provide ﬂoor protection, anti-slip safety and comfort

09. 33 / 45 RPM Switch

Select 33 or 45 rpm for playing a vinyl

FEATURES / TOP PANEL

19REAR PANEL

10. Grounding terminal

A direct electrical connection to the earth

11. RCA JACKS selector

Plug in the RCA cable, and connect the cable to the audio ampliﬁer

12. PHONO EQ

ON: Connect the RCA cable to an LINE-IN terminal of the ampliﬁer.

OFF: Connect the RCA cable to a PHONO-IN (MM) terminal of the ampliﬁer.

10 11 12 1413 15

20 REAR PANEL

13. AUTO PLAY

ON: to start the AUTO-PLAY function. Motor starts turning once the tonearm is moved out of its rest towards the

platter. After record is ﬁnished motor stops

OFF: to stop AUTO-PLAY function.

14. Power Jack

Connecting power cable

15. Power Switch

To turn the unit On/O

21INITIAL STARTING UP

DUST COVER INSTALLATION

01. Unwrap the two hinges and the dustcover.

02. Note that the hinges have a clamp side and a tab side.

03. Note that the dustcover has two spots on its rear edge shaped to accept the clamps.

04. Carefully push the clamps onto the dustcover in these locations

05. Now snap the two clamps into the areas indicated at the back of the turntable to accept them.

MOUNT AND ADJUST

01. Place the aluminum turntable platter over the center spindle. Spin the platter a few times to be sure it is placed

correctly. Now place the rubber platter mat on top of the platter so the ribbed sections point upward

02. Insert the headshell into the tone arm and ﬁx it by turning the collar.

03. Insert the counterweight on the end of the tone arm, rotating it until it threads into place.

04. Rotate the antiskating knob counterclockwise until it is set to “0“. Make sure the gauge is pointing in your direc-

tion

05. Place the lever for the tone arm lift in the front position so that the lift bank lowers.

06. Open the tone arm lock. Seize the handle of the tone arm and move it just outside the edge of the platter so

that it can ﬂoat up and down. Remove the protective cap from the stylus. (Be careful not to hit the stylus against

anything.)

07. Turn the counterweight until the tone arm ﬂoats level. If the tone arm moves up: Turn thecounterweight coun-

ter-clockwise. If the tone arm moves down: Turn the counterweight clockwise

08. Put the tone arm back onto the arm rest and lock it.

09. The counterweight has a rotary ring with a scale. Without turning the counterweight, only turn the ring until the

zero “0” aligns with the indicator line.

10. The scale indicates the stylus pressure in grams. The pressure of the cartridge supplied with this turntable is 2g,

turn the entire counterweight counter-clockwise to “2” and the anti-skating to “2“, too. If a dierent cartridge is

22 INITIAL STARTING UP

used, adjust the stylus pressure and the antiskating indicated to the corresponding speciﬁcations.

MAINS CONNECTION

An external switching power adaptor is supplied with this turntable.

There are the RCA jack on the rear panel of the turntable. You can use it to connect to your ampliﬁer. You also

could switch the selector to “ON” or “OFF”, and connect the RCA plug to the “LINE” input of your ampliﬁer.

01. Place the record on the turntable. If it is a 45 rpm, you need to place the adaptor on the record spindle.

02. Choose the playing speed.

03. Release the pick-up arm clip. If AUTO PLAY switch (13) on the back is set to ON motor starts turning automati-

cally once the arm is moved towards platter.

04. Place the cartridge vertically over the ﬁrst track of the record the turntable starts turning.

05. Lower the cue lever to place the stylus in the groove

06. When playback is complete, push the cue lever to lift the tone arm and move it back to the arm rest. If AUTO

PLAY switch (13) on the back is set to ON motor stops automatically at the end of the record.

07. After ﬁnish the playback, please switch o the power to save energy.

TO REPLACE THE STYLUS

• Put the rest clip on the pick-up arm.

• Remove Headshell (5) from the tonearm.

• Remove the protective cap from the stylus.

• Pull the stylus to the lower front and remove it.

• Put in the new stylus following the reverse procedure.

• Replace the protective cap on the stylus.

TO REMOVE THE CARTRIDGE

• Put the rest clip on the pick-up arm.

• Remove headshell (5) from the tonearm.

• Remove the stylus to prevent damage.

• Remove the two cartridge ﬁxing screws.

• Disconnect the four link wires at the back of the cartridge.

TO INSTALL NEW CARTRIDGE

• Connect the four link wires.

• Take care of the receptacle’s colors.

• Install the cartridge in the head shell.

• Install the two cartridge ﬁxing screws.

• Re-install the stylus.

• Replace the protective cap on the stylus.

MAINTENANCE

IMPORTANT RECOMMENDATIONS

We advise you to clean your records using a rag impregnate with an antistatic product for maximum enjoyment

of your records and also to make them last.

We would also point out that for the same reason your stylus should be replaced periodically (approximately

every 250 hours). Dust the stylus from time to time using a very soft brush dipped in alcohol (brushing from back

to front of the cartridge).

WHEN TRANSPORTING YOUR RECORD PLAYER DO NOT FORGET TO:

Replace the protective cap on the stylus. Remove the platter by pulling it straight up o the spindle. Put the rest

clip into the pick-up arm.

IMPORTANT!

ALWAYS KEEP THE SHIPPING CARTON IN A DRY PLACE FOR THE EVENT THAT THE RECORD PLAYER

HAS TO BE PACKED AGAIN FOR TRANSPORTATION.

IN THIS CASE IT IS IMPORTANT TO DETACH THE PLATTER AND PUT IT ON THE BOTTOM OF THE

SHIPPINGBOX, JUST AS IT WAS ORIGINALLY DELIVERED TO YOU.

MAINTENANCE

Turntable section

Drive System Direct Drive

Motor DD Motor

Speed 33 1/3 RPM, 45 RPM

Rotation Speed Variation +/–0.33%

Wow and Flutter 0.15%

Signal-to-Noise Ratio 67dB or higher (A-weighted, 20kHz LPF)

60dB or higher (unweighted, 20kHz LPF)

Platter Aluminum Die-cast

Diameter of Platter 12“, 300mm

SPECIFICATION

Andere Handbücher für TD402 DD

Inhaltsverzeichnis

Andere THORENS Drehscheibe Handbücher

THORENS

THORENS TD201 Bedienungsanleitung

THORENS

THORENS TD 903 Bedienungsanleitung

THORENS

THORENS TD 165 Bedienungsanleitung

THORENS

THORENS TP 92 Bedienungsanleitung

THORENS

THORENS TD 148 A Bedienungsanleitung

THORENS

THORENS TD402 DD Bedienungsanleitung

THORENS

THORENS TD 2035 Bedienungsanleitung

THORENS

THORENS TD 125 Bedienungsanleitung

THORENS

THORENS TD160 Bedienungsanleitung

THORENS

THORENS TD 101 A Bedienungsanleitung

THORENS

THORENS TD 160 HD Bedienungsanleitung

THORENS

THORENS TD 165 Bedienungsanleitung

THORENS

THORENS TD 2001 Bedienungsanleitung

THORENS

THORENS TP 190 Bedienungsanleitung

THORENS

THORENS TD 309 Bedienungsanleitung

THORENS

THORENS TD 125 Bedienungsanleitung

THORENS

THORENS MM 001 Bedienungsanleitung

THORENS

THORENS TD 403 DD Bedienungsanleitung

THORENS

THORENS TD 145 MKII Bedienungsanleitung

THORENS

THORENS TD 295 MKIV Bedienungsanleitung

THORENS

THORENS TD 2010 Bedienungsanleitung

THORENS

THORENS TD 320 MK II Bedienungsanleitung

THORENS

THORENS TD 158 Bedienungsanleitung

THORENS

THORENS TD 102 A Bedienungsanleitung

Beliebte Drehscheibe Handbücher anderer Marken

Gemini

Gemini CDT-05 MKII Bedienungsanleitung

Rotel

Rotel RP-820 Bedienungsanleitung

Shuman

Shuman MC-250BT Bedienungsanleitung

Stanton

Stanton STR8-150 Bedienungsanleitung

Audio Technica

Audio Technica AT-LPW40WN Bedienungsanleitung

Crosley

Crosley McQueen CR7011-GY Bedienungsanleitung

Reloop

Reloop SMP-1 Bedienungsanleitung

auna

auna TT-Classic Plus Bedienungsanleitung

COMO AUDIO

COMO AUDIO Turntable Analog Bedienungsanleitung

Dual

Dual 1009 F Bedienungsanleitung

REED

REED Muse3C Bedienungsanleitung

AXIOMTEK

AXIOMTEK OPS883-H Series Bedienungsanleitung

Pioneer

Pioneer PL-71 Bedienungsanleitung

Vestax

Vestax PDX-a1 Bedienungsanleitung

Denon

Denon DP-400 Bedienungsanleitung

Dual

Dual 504 Bedienungsanleitung

Audio-Techica

Audio-Techica AT-LP60XBT Bedienungsanleitung

Goldring

Goldring G99 Bedienungsanleitung