Thorn WeatherForce LED Bedienungsanleitung

IP65

IP65 IP65

WeatherForce LED

Installation Instructions

Warning

Please read these instructions carefully before installation or lamp

replacement. Warranty of this product is subject to installation

and maintenance being carried using appropriate conventional

practices and/or any specic instructions enclosed within.

Installation must be carried out by a qualied electrician in

accordance with local wiring regulations. Ensure that the rated

voltage and frequency of the luminaire are compatible with the

electrical supply.

Disconnect mains power supply before installing, servicing or

maintaining the luminaire.

Changes to specication

The right is reserved to change the design and/or specication

without prior notice or public announcement.

Specication

This luminaire is designed to comply with

the requirements of AS/NZS 60598.

Supply Voltage: 240v ~ 50Hz

Classication For Protection: Against electric shock:

Class 1 earthed metalwork. This luminaire must be earthed.

IP Rating: 65 - A 6-10mm Ø, circular electrical supply

cable must be used to maintain the IP rating.

Maximum ambient operating temperature:

Up to Ta: 25�C

1. Remove the diffuser and gear tray

Product application

IP65

To install, remove diffuser, detach gear tray and maintenance suspension devices.

Installation positions and IP rating

This strong impact resistant product is made from Polycarbonate.

This material is ideal in waterproof & industrial applications.

However, it is not suitable for use in areas prone to contact with

solvents, detergents, oil, alkalis, organic chemicals, animal fats &

industrial cleaners.

Please contact your local Thorn ofce for suitable alternative

products to suit the above applications

Remove Screws

Suspended Mounting Direct Mounting

600mm Single

416mm 507mm

600mm Twin

1200mm Single

880mm 980mm

1200mm Twin

Green/Yellow Earth

Brown Active

Blue Neutral

SAP No: 96540006 Rev: A 1/2013

thn_weatherforce_0113

Thorn Lighting Pty Limited (ABN 74 060 142 501)

Head Ofce: 43 Newton Road, Wetherill Park NSW 2164

Ph. 1300 139 965 Fax. 1300 139 953 www.thornlighting.com.au

Attach the gear tray to the

base. Tighten screws rmly.

Fit the uorescent lamp (ordered

separately).

Attach the diffuser to the base.

Ensure the diffuser is locked in

place.

Mounting kits suitable for surface mounting, or suspension mounting

are available to order.

Order reference: Single - 96039252, Twin - 96039253.

5. Secure the gear tray to the base

8. Attach the diffuser

Mounting kits

Make the electrical connections at the terminal block.

4. Make the electrical connections

The WeatherForce can be mounted by direct screw xing through the

housing. It should only be drilled at the appropriate marked points where

the housing is suitably reinforced. Do not use oil.

Note: Fixing screws and washers are NOT supplied.

It is recommended drill bits specically designed for plastic are used.

Standard metal or timber twist drills may be used but if not properly

prepared for plastic they can instigate stress cracking which may spread

under load.

Do not overtighten any screws into or in contact with the plastic housing.

Permanent damage may occur even if not immediately obvious.

Recommended maximum torque 1.5Nm

It is recommended that installation is made using the end entry and gland

kit provided with the tting.

Warning: If the housing is pierced for back entry of cabling, do not run

mains cabling past ballast, Temperatures exceed 100°C.

Fit the electrical supply cable, conduit and cable gland to the entry point

on the base. Ensure the cable gland is tightened rmly.

Note: If not suitably sealed with

appropriate washers, glands

or proprietary sealing kits any

piercing of the housing will

interfere with the IP rating of

the product.

2. Mount the luminaire

3. Attach conduit, cable glands and electrical

supply cable to tting.

Mounting point

Mounting screws

Cable gland

Suspension mounting kit

Surface mounting kit

Screw

Washer

Andere Thorn Außenleuchte Handbücher

Thorn

Thorn OXANE Bedienungsanleitung

Thorn

Thorn DYANA 1 Bedienungsanleitung

Thorn

Thorn THOR L Series Bedienungsanleitung

Thorn

Thorn THOR BOLLARD Series Bedienungsanleitung

Thorn

Thorn ADELIE Series Bedienungsanleitung

Thorn

Thorn URBA DECO Bedienungsanleitung

Thorn

Thorn ADELIE WIDE Bedienungsanleitung

Thorn

Thorn BASALT Bedienungsanleitung

Thorn

Thorn ISARO PRO Bedienungsanleitung

Thorn

Thorn AFP L Series Bedienungsanleitung

Thorn

Thorn AERIE SLIM Bedienungsanleitung

Thorn

Thorn EP 145 LED Bedienungsanleitung

Thorn

Thorn RAZE BOLLARD Series Bedienungsanleitung

Thorn

Thorn CONTRAST 2 LED MENA M Bedienungsanleitung

Thorn

Thorn Voyager Twinspot Bedienungsanleitung

Thorn

Thorn ORUS LED Bedienungsanleitung

Thorn

Thorn VOLUPTO VO 18L105-740 SF RS CL2 W5 T60 ANT Bedienungsanleitung

Thorn

Thorn D-CO Bedienungsanleitung

Thorn

Thorn CLAN Series Bedienungsanleitung

Thorn

Thorn EP 445 LED Bedienungsanleitung

Thorn

Thorn FLEXITY Bedienungsanleitung

Thorn

Thorn Areaflood Pro 2 Bedienungsanleitung

Thorn

Thorn CIVITEQ Bedienungsanleitung

Thorn

Thorn AVENUE F2 AVF 18L50-730 RS CL BS 3550 CL2... Bedienungsanleitung

Beliebte Außenleuchte Handbücher anderer Marken

Sealey

Sealey LED37 Bedienungsanleitung

nordlux

nordlux VEJERS Benutzerhandbuch

SImx

SImx ELITE LED LHTC637 Bedienungsanleitung

GEV

GEV CAROLINE 10833 Bedienungsanleitung

NEBO

NEBO NEB-LSP-0020 Bedienungsanleitung

WE-EF

WE-EF PFL540 LED Bedienungsanleitung

Lindby

Lindby 9949029 Bedienungsanleitung

HEPER

HEPER DOGO Side LW6048.585-US Montage- und Bedienungsanleitung

HEPER

HEPER LW8034.003-US Montage- und Bedienungsanleitung

Maretti

Maretti VIBE S 14.6080.04.A Bedienungsanleitung

BEGA

BEGA 84 253 Handbuch

HEPER

HEPER MINIMO Montage- und Bedienungsanleitung

LIGMAN

LIGMAN BAMBOO 3 Bedienungsanleitung

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Bedienungsanleitung

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Bedienungsanleitung

urban ambiance

urban ambiance UQL1273 Bedienungsanleitung

TotalPond

TotalPond 52238 Bedienungsanleitung

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Bedienungsanleitung