TIL TiL-92-SC Bedienungsanleitung

VHF/AM SINGLE CHANNEL

RECEIVER Model TiL-92-SC

92-SC RECEIVER P/N 931040-1

(ITEM NO. TSR-4100)

Installation and

Operating Instructions

TiL Document No. 93RE125

Rev. F

JULY 2012

Technisonic Industries Limited

240 Traders Boulevard, Mississauga, Ontario L4Z 1W7

Tel: (905) 890-2113 Fax: (905) 890-5338

www.til.ca

REVISION HISTORY

[ 93RE125 ]

REV SECTION

- PAGE - DESCRIPTION DATE

Edited

n/c Original Document

A-D

E Global New Document Template (new file format)

Title page changed, Headers/Footers added

Added Revision page, Added Warranty page

2-5 Added note to §2.3 Channel Freq. Selection

referring to units built after Jan 2012 with a USB

port and added Appendix A (TDP-90 for USB AM

units) with Installation and Operating Instructions.

FEB 2012 FM

F iii Updated FCC information including antenna and

FCC labeling instructions.

Simplify description under “Warning”

2-5 Updated para 2.3

Appendix A Updated TDP-90 to REV A JULY 2012 FM

iiii

iii

WARNING

Do not make physical contact with antenna when transmitter is on.

CAUTION ! STATIC SENSITIVE !

This unit contains static sensitive devices. Wear a grounded wrist strap and/or conductive gloves

when handling printed circuit boards.

FCC COMPLIANCE INFORMATION

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference and (2) this device must accept any interference

received, including interference that may cause undesired operation.

WARNING: For compliance with FCC RF Exposure Requirements the transmitter antenna

installation shall comply with the following two conditions:

1.The transmitter antenna gain shall not exceed 3 dBi.

2. The transmitter antenna is required to be located outside of a vehicle and kept at a separation distance of 90 cm

or more between the transmitter antenna of this device and person(s) during operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference, in which case the user will be

required to correct the interference at his/her own expense.

FCC LABELING INFORMATION: When this device is permanently mounted in an enclosure where the

FCC ID label can not be seen, another label must be placed on the outside of the enclosure stating

‘contains FCC ID: IMA90-6R’.

WARRANTY INFORMATION

The Model 92-SC series, Single Channel rack mounted receiver, is under warranty for one year from date

of purchase. Failed units caused by defective parts, or workmanship should be returned to:

Technisonic Industries Limited

240 Traders Boulevard

Mississauga, Ontario L4Z 1W7

Tel: (905) 890-2113

Fax: (905) 890-5338

TECHNISONIC INDUSTRIES LIMITED

www.til.ca

TSR-4100 92-SC Installation & Operating Instructions TiL 93RE125 Rev F

TABLE OF CONTENTS

SECTION TITLE PAGE

SECTION 1 GENERAL DESCRIPTION

1.1 INTRODUCTION ............................................................................................................... 1-1

1.2 DESCRIPTION .................................................................................................................. 1-1

1.2.1 Receiver Module ............................................................................................................... 1-2

1.2.2 Power Supply Modules - P/N’s 922079-1, 922083-1 ........................................................ 1-2

1.2.3 Mother Board ..................................................................................................................... 1-2

1.2.4 Remote Audio Board ......................................................................................................... 1-2

1.2.5 Crystal Filter (Option 1) ..................................................................................................... 1-3

1.3 MODES OF OPERATION ................................................................................................. 1-3

1.3.1 Local/Remote Operation ................................................................................................... 1-3

1.3.2 AC and DC Operation ....................................................................................................... 1-3

1.4 TECHNICAL SUMMARY .................................................................................................. 1-3

SECTION 2 PREPARATION FOR USE AND STORAGE

2.1 INTRODUCTION ............................................................................................................... 2-1

2.2 DISASSEMBLY/ASSEMBLY ............................................................................................ 2-1

2.2.1 Remove/Replace Cover Assembly ................................................................................... 2-1

2.2.2 Remove/Replace Receiver Module .................................................................................. 2-1

2.2.3 Remove/Replace Memory Set Board Module A5A1 ......................................................... 2-3

2.2.4 Remove/Replace Audio Board .......................................................................................... 2-3

2.2.5 Remove/Replace Crystal Filter Board ............................................................................... 2-5

2.3 CHANNEL FREQUENCY SELECTION ............................................................................ 2-5

2.3.1 Introduction ........................................................................................................................ 2-5

2.3.2 Frequency Range .............................................................................................................. 2-5

2.3.3 Pre-Programming Channel Frequency ............................................................................. 2-5

2.3.4 Offset Frequency Set ........................................................................................................ 2-6

2.4 REMOTE OPERATION SET UP ....................................................................................... 2-9

2.4.1 Remote Audio Board P/N 923060-1 ................................................................................. 2-9

2.5 OPTIONAL LOUDSPEAKER, HEADPHONE INSTALLATION ........................................ 2-11

2.5.1 External Loudspeaker ....................................................................................................... 2-11

2.5.2 Headset ............................................................................................................................. 2-11

2.6 TRANSCEIVER ADJUSTMENTS AND SETTINGS ......................................................... 2-11

2.7 OPERATIONAL CHECK ................................................................................................... 2-11

2.8 STORAGE ......................................................................................................................... 2-11

SECTION 3 OPERATING INSTRUCTIONS

3.1 INTRODUCTION ............................................................................................................... 3-1

3.2 INSTALLATION ................................................................................................................. 3-1

3.3 OPERATOR'S SWITCHES, CONTROLS AND INDICATORS ......................................... 3-1

3.4 OPERATING INSTRUCTIONS ......................................................................................... 3-4

3.4.1 Receiver Operation (Local Mode) ..................................................................................... 3-4

3.4.2 Switching OFF ................................................................................................................... 3-5

3.4.3 External DC Operation ...................................................................................................... 3-5

WARRANTY ..........................................................................................................................................

Appendix A......TDP-90 Programming Software User’s Guide (for USB) ............................................ A-1

TECHNISONIC INDUSTRIES LIMITED

www.til.ca

TSR-4100 92-SC Installation & Operating Instructions TiL 93RE125 Rev F

LIST OF FIGURES

FIGURE TITLE PAGE

1.1 VHF/AM Single Channel Receiver ........................................................................................... 1-1

2.1 Single Channel Receiver - Internal View .................................................................................. 2-2

2.2 Single Channel Memory Set Board - Module A5A1 ................................................................. 2-4

2.3 Remote Audio Board P/N 923061-1 ......................................................................................... 2-10

2.4 Receiver Adjustments and Settings ......................................................................................... 2-12

3.1 Single Channel Transceiver Controls and Indicators ............................................................... 3-2

LIST OF TABLES

TABLE TITLE PAGE

1.1 92-SC Leading Particulars ....................................................................................................... 1-4

2.1 Frequency Selection MHz ........................................................................................................ 2-7

2.2 Frequency Selection kHz ........................................................................................................ 2-8

2.3 Remote Connector Functions ................................................................................................... 2-9

3.1 Operator's Switches, Controls and Indicators .......................................................................... 3-3

TECHNISONIC INDUSTRIES LIMITED

www.til.ca

TSR-4100 92-SC Installation & Operating Instructions TiL 93RE125 Rev F

1-1

SECTION 1 - GENERAL DESCRIPTION

1.1 INTRODUCTION

This publication provides general information on the VHF/AM Single Channel Receiver Model

TiL-92-SC, Part No. 931040-1, manufactured by Technisonic Industries Limited. This unit is also

referred to by Item No. TSR-4100.

The Model TiL-92-SC, Receiver is a single channel, fixed frequency receiver operating over the

frequency range of 117.975 MHz to 138.000 MHz. This unit is intended for base station operation

in an air traffic environment. The unit can operate from AC power or external DC power in local

and remote operating modes.

1.2 DESCRIPTION

The 92-SC rack mounted receiver configuration is based on the Model 90-6R pre-programmable

transceiver module. This module, as modified for receiver only capability utilizes similar circuitry

as the 90-6R with appropriate deletion of transmitter functions. In addition to this modified

transceiver module, the receiver consists of a Power Supply Module, Mother Board, and Remote

Audio Board.

An optional RF Crystal Filter which provides higher receiver selectivity is available. These filters

can be ordered to provide either an additional 20dB (4 dB loss sensitivity) or 40dB (7 dB loss) of

selectivity.

An Optional Module A6 which is a DC to DC power supply is available in the 90-6R Receiver unit.

This optional power supply will allow the 92-SC Receiver to operate with a 24 Vdc input as

opposed to the standard 12 Vdc input. When the units are operating in the AC mode and external

batteries are connected a DC charging circuit will automatically trickle charge the batteries and

the unit will switch to DC operation should the AC mains fail.

Figure 1.1 VHF/AM Single Channel Receiver

TECHNISONIC INDUSTRIES LIMITED

www.til.ca

TSR-4100 92-SC Installation & Operating Instructions TiL 93RE125 Rev F

1-2

1.2 DESCRIPTION (continued)

To improve the rejection of interfering signals, dual conversion receiver technology has been

incorporated on the Receiver (Module A1) board used in Technisonic VHF/AM base stations. The

second IF is 455 kHz using a ceramic filter, which is immune to high energy ringing. The dual

conversion module also has a second local oscillator, second mixer and ceramic filter. The first

local oscillator is the original VCO.

The dual conversion receiver board, P/N 003494-3 was implemented into TSR series base

stations starting in January 2001. An option label on the chassis will indicate OPTION 94 if the

dual conversion board is installed. It is possible to retro-fit the dual conversion receiver board into

older TSR series base station employing the single conversion board. Please contact Technisonic

for availability of an exchange board.

NOTE: If a new A1 Module has been retrofitted the squelch circuit must be aligned for the

receiver squelch to operate correctly.

The dual conversion receiver’s squelch knob must be rotated significantly more clockwise (4

o’clock position) to obtain the same squelch setting (3uV) as a single conversion receiver’s

squelch knob set to the 12 o’clock (straight up) position.

If the dual conversion receiver’s squelch knob is set to the 12 o’clock position, signals with a level

greater than 0.5uV will open the squelch. At most airports this will not be an adequate level of

squelch. Please be aware of this squelch knob adjustment variance when setting and/or

comparing squelch levels of dual conversion vs. single conversion base stations.

1.2.1 Receiver Module

The Single Channel Receiver is based on Transceiver Model 90-6R. The transceiver module is

modified for receive only, on one pre-programmable synthesized frequency, with 25 kHz channel

spacing in the frequency range 117.975 MHz to 138.000 MHz. The single channel memory set

board, module A5A1 is mounted external to the receiver internal module to facilitate ease of

frequency programming. Refer to above paragraph for details on new dual conversion receiver

A1module.

1.2.2 Power Supply Modules - Model SPG-007

The Power Supply Module, Model SPG-007 provides the DC supply voltage to the receiver and

houses a battery charger which can provide charging and trickle charging to an external

rechargeable 12 Vdc battery, if utilized.

1.2.3 Mother Board

The Mother Board provides all interconnection between the two external remote control

connectors, Power Supply, Remote Audio Board, and Receiver module. The Remote Audio

Board, Optional Crystal Filter and all internal fuses are mounted on the Mother Board.

1.2.4 Remote Audio Board

1. Line Interface Board P/N 923060-1

NOTE This board is supplied modified for the 92-SC, Receiver without transmitter keying

functions. Provides remote receiver audio monitoring over 2 wire 600 ohm audio lines.

Inhaltsverzeichnis

Beliebte Empfänger Handbücher anderer Marken

Garmin

Garmin GA 23 Bedienungsanleitung

Aiphone

Aiphone PS-12F Bedienungsanleitung

IMES

IMES TCS-01CA-PMI Bedienungsanleitung

BWI Eagle

BWI Eagle AIR-EAGLE SR Handbuch

AMIMON

AMIMON AMN12310 WHDI Bedienungsanleitung

Dual

Dual DMCPA79BT Betriebsanleitung

Sound Associates

Sound Associates SA652P Bedienungsanleitung

Sherwood

Sherwood NewCastle R-772 Bedienungsanleitung

Audio

Audio A10-RX Series Bedienungsanleitung

AllSee

AllSee PushShare PSRV1.1 Bedienungsanleitung

DEMAG

DEMAG DRC-DR D2 Bedienungsanleitung

Teleco

Teleco TVRCL868A02 Bedienungsanleitung

Bosch

Bosch RF3222E Bedienungsanleitung

Kramer

Kramer 631R Bedienungsanleitung

Xpress

Xpress xmc10 Bedienungsanleitung

JVC

JVC KD-MR1BTS Bedienungsanleitung

Omega Engineering

Omega Engineering UWTC-REC3 Bedienungsanleitung

e-survey

e-survey E300 Pro Bedienungsanleitung