TomTom ONE Car GPS Receiver Bedienungsanleitung

TomTom ONE

What’s in the box1.

What’s in the box

aYour TomTom ONE

(Maps for US & Canada are pre-

loaded in internal memory)

ACharging light

BOn/Off button

CReset button

DSpeaker

EUSB connector

FRDS-TMC connector

bCar charger cDocumentation pack

dWindshield

Holder

eUSB cable

fAdhesive disk for

windscreen mount

Before You Start...2.

Before You Start...

Switching on and off

To switch your TomTom ONE on or off, press and hold the On/Off button for

2 seconds. The first time you switch on, it may take a short while for your

device to start.

Note: In rare cases, your ONE may not start correctly. If this happens, press

the reset button, then switch on the device again.

Setting up

To set up your TomTom ONE you need to answer a few questions by tapping

the screen.

Important: Take care to select the correct language, since the language you

choose will be used for all menus and written instructions.

Battery notes

For information on connecting your computer, see Using TomTom HOME

(43).

Note: Your TomTom ONE uses a small amount of battery power to remember

the last screen being shown when the device is switched off.

If you do not charge your ONE for a prolonged period of time, the next time

you start your ONE it will show the default starting screen. All other device

settings will still be maintained.

Improving reception

If your TomTom ONE takes longer than 5 minutes to find your current

position, make sure that the device is in an open space away from tall objects

such as buildings or trees.

When you connect your TomTom ONE to your computer, you can use

TomTom HOME to download information about GPS satellite positions during

the next 7 days. This helps your ONE to find your position faster.

Important: Some vehicles have heat reflective shielding in the windscreen.

This may prevent your ONE from locating your current position.

Windshield Holder

Use the windshield holder to install your TomTom ONE inside your car.

To attach the holder, press the suction cup firmly to the windshield in your car,

in an area of the windshield where the glass is flat.

Make sure that both the holder and your windshield are clean and dry before

you attach the holder. Place the holder so that it does not interfere with your

view of the road.

Take care of your TomTom ONE

Never leave your TomTom ONE or accessories in view when you leave the car

or they may become an easy target for thieves.

You can set a password for your TomTom ONE which must be entered every

time you start your ONE. For more information, see Using TomTom HOME

(43).

It is important to take care of your ONE.

• Your ONE is not designed for use in extreme temperatures and any such

exposure may cause permanent damage.

• Do not open the casing of your ONE under any circumstances. Doing so

may be dangerous and will invalidate the warranty.

• Wipe or dry the screen of your ONE using a soft cloth. Do not use any liquid

cleaners.

Driving View3.

Driving View When your TomTom ONE starts, you are shown the Driving View along with

detailed information about your current location.

Tap the center of the screen at any time to open the Main Menu.

Note: The Driving View is shown in black and white until your ONE locates

your current position.

ATap + and - to zoom in and out.

BYour current position.

CThe name of the next major road or road sign information, if applicable.

DNavigation instruction for the road ahead.

Tap this area to repeat the last spoken instruction and to change the

volume.

EThe name of the street you are on.

FInformation about your trip such as trip time, remaining distance and arrival

time.

To select what will be shown, tap Status bar preferences in the Preferences

menu.

GGPS signal strength.

HTraffic bar - requires an RDS-TMC Traffic Receiver (available as an

accessory).

To set up Traffic information, tap the Traffic bar to open the Traffic menu or

tap TomTom Traffic in the Main Menu.

Making your first trip4.

Making your first trip Planning a route with your TomTom ONE is easy. To plan your first route,

follow the steps below.

Important: You should always plan your journey before you start driving. It is

dangerous to plan a route while driving.

1. Tap the screen to bring up the main menu.

Note: The buttons on your ONE are shown in full color unless a button is

currently unavailable. For example, the button named Find alternative... in

the Main Menu is not available until you have planned a route.

2. Tap Navigate to...

3. Tap Address.

When you enter an address, you can choose from the following options:

•City center - tap this button to set your destination as the center of a city

or town.

•Street and house number - tap this button to set an exact address as your

destination.

•ZIP code - tap this button to enter a ZIP code as your destination.

•Cross street or intersection - tap this button to set your destination as the

point where two streets meet.

For your first trip, we will enter an exact address.

4. Tap Street and house number.

Note: When planning a trip for the first time your ONE asks you to choose a

state or country. Your choice is saved and used for all routes you plan.

You can change this setting at any time by tapping the state symbol or country

flag.

5. Start to type the name of the town where you want to go.

As you type, the names of the towns that match what you have typed are

shown. When your destination appears in the list, tap the name of the town

to set the destination.

6. Start to type the name of the street and select it when it is shown.

As with the name of the town, the names of the streets that match what you

have typed are shown. When your destination appears in the list, tap the

name of the street to set the destination.

7. Now enter the house number of your destination and then tap Done.

8. Your ONE asks if you need to arrive at a particular time. For this exercise,

tap NO.

The route is calculated by your ONE.

9. When the route has been calculated, tap Done.

Your ONE will immediately begin to guide you to your destination, using both

spoken instructions and on-screen directions.

Arrival times

When you plan a route, your TomTom ONE asks you if you need to arrive at a

particular time.

Tap YES to enter a preferred arrival time.

Your ONE calculates your arrival time and shows you whether you will arrive

on time.

You can also use this information to work out when you need to leave. If your

ONE shows that you will arrive 30 minutes early, you can wait and leave in 30

minutes time, rather than arrive early.

Your arrival time is constantly recalculated during your trip. The status bar

shows whether you will arrive on time or if you are going to be late, as shown

below:

You will arrive 55 minutes before the arrival time you entered.

If the estimated arrival time is more than five minutes before

the time you entered, it is shown in green.

You will arrive 3 minutes before the arrival time you entered.

If the estimated arrival time is less than 5 minutes before the

time you entered, it is shown in yellow.

You will arrive 19 minutes late.

If the estimated arrival time is later than the time you entered,

it is shown in red.

Status bar

preferences

Tap Status bar preferences in the Preferences menu, to enable or disable

arrival time notifications.

Select the required options on the first menu screen and then tap Done.

To enable arrival time notifications, select Show leeway to arrival time.

To disable arrival time notifications, unselect Show leeway to arrival time.

What are the other navigation options?

When you tap Navigate to..., you can set your destination in many ways, not

just by entering the address. The other options are listed below:

Planning a route in advance

You can also use your ONE to plan trips in advance by selecting both your

starting point and your destination. You could, for example, do the following:

Home

Tap this button to navigate to your Home location.

You will probably use this button more than any other.

For information about setting your Home location, see Change Home

location (28).

Favorite

Tap this button to select a Favorite as your destination.

For more information about Favorites, see Favorites (18).

Address

Tap this button to enter an address as your destination.

Recent

destination

Tap this button to select your destination from a list of places you have

recently used as destinations.

Point of

Interest

Tap this button to navigate to a Point of Interest (POI).

For more information about POIs and navigating to a POI, see Points of

Interest (23).

GPS position

Tap this button to select your GPS position, as your destination.

For more information about GPS, see Global Positioning System (GPS)

(42).

Point on map

Tap this button to select a point on the map as your destination using the

map browser.

For more information about the map browser, see Driving View (5).

Latitude

Longitude

Tap this button to enter a destination using latitude and longitude values.

Position of

last stop

Tap this button to select your last recorded position, as your destination.

For more information about the GPS, see Global Positioning System (GPS)

(42).

• Find out how long a trip is going to take before you start.

• Check the route of a trip you are planning.

• Check a route for someone who is coming to visit you so you can explain

the route to them.

To plan a route in advance, follow these steps:

1. Tap the screen to bring up the main menu.

2. Tap the arrow button to move to the next menu screen and tap Prepare

route.

3. Select the starting point for your trip in the same way that you would select

your destination.

4. Set the destination for your trip.

5. Choose the type of route that should be planned.

•Fastest route - the route which takes the least time.

•Shortest route - the shortest distance between the locations you set. This

may not be the quickest route, especially if the shortest route is through

a town or city.

•Avoid freeways - a route which avoids freeways.

•Walking route - a route designed for making the trip on foot.

•Bicycle route - a route designed for making the trip on a bicycle.

•Limited speed - a route for a vehicle which can only be driven at a limited

speed. You have to specify the maximum speed.

6. Your TomTom ONE plans the route between the two locations you

selected.

More information about a route

To find out about your route in detail, tap the Details button on the route

summary screen.

You can then select from the following options:

Prepare route

Browse as

text

Tap this button for a list of all the turn instructions on the route.

This is very useful if you need to explain a route to someone else.

Browse as

images

Tap this button to see each turn in the trip. Tap the right and left arrows to

move forwards and backwards through the trip.

Tap the screen to turn off the 3D display and view the map from above.

Browse map

of route

Tap this button to see an overview of the route using the map browser.

For more information about the map browser, see Driving View (5).

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere TomTom GPS Handbücher

TomTom

TomTom ONE/XL Bedienungsanleitung

TomTom

TomTom GO Bedienungsanleitung

TomTom

TomTom 1EE0.052.01 Bedienungsanleitung

TomTom

TomTom Go 730 Bedienungsanleitung

TomTom

TomTom PRO 82 SERIES Bedienungsanleitung

TomTom

TomTom Navigator SDK and Betriebsanleitung

TomTom

TomTom GO 510 Bedienungsanleitung

TomTom

TomTom XL 340 Bedienungsanleitung

TomTom

TomTom Blue&Me-TomTom 2 LIVE Bedienungsanleitung

TomTom

TomTom 2004 Bedienungsanleitung

TomTom

TomTom Blue&Me- Bedienungsanleitung

TomTom

TomTom GO Bedienungsanleitung

TomTom

TomTom RIDER Bedienungsanleitung

TomTom

TomTom START Bedienungsanleitung

TomTom

TomTom GO Bedienungsanleitung

TomTom

TomTom Go 2435TM Bedienungsanleitung

TomTom

TomTom ECLIPSE Bedienungsanleitung

TomTom

TomTom NAVIGATION SYSTEM Bedienungsanleitung

TomTom

TomTom Rider 400 Bedienungsanleitung

TomTom

TomTom LINK 300 Bedienungsanleitung

TomTom

TomTom RIDER Bedienungsanleitung

TomTom

TomTom 1N01.081 Bedienungsanleitung

TomTom

TomTom LINK 201 Bedienungsanleitung

TomTom

TomTom GO Bedienungsanleitung

Beliebte GPS Handbücher anderer Marken

Raven

Raven Cruizer II Handbuch

Hama

Hama 53118 Bedienungsanleitung

Garmin

Garmin SOUNDER 125 Bedienungsanleitung

Garmin

Garmin DEZL 580 Bedienungsanleitung

Jigabot

Jigabot EX Bedienungsanleitung

Pointer

Pointer Cellocator CelloTrack XT LTE Installationsanleitung

Queclink

Queclink GV55LITE Bedienungsanleitung

Voxson

Voxson Voxtrack GPS500 Gebrauchsanweisung

Garmin

Garmin ECHOMAP PLUS Bedienungsanleitung

Starcom Systems

Starcom Systems Kylos Compact Bedienungsanleitung

Garmin

Garmin 15 H Series Bedienungsanleitung

Cobra

Cobra Marine MC 600Ci Bedienungsanleitung

Cellocator

Cellocator CelloTrack T Bedienungsanleitung

Enfora

Enfora Mini-MT GSM2228UG001 Bedienungsanleitung

Magellan

Magellan eXplorist 100 Bedienungsanleitung

LTE

LTE G50B Bedienungsanleitung

Garmin

Garmin DEZL OTR500 Bedienungsanleitung

SkyGolf

SkyGolf SkyCaddie SG1 Bedienungsanleitung