Toshiba T1000 Series Bedienungsanleitung

T1000 Series UPS 4-Post Rack Slide Kit Installation Instructions 94034-000 1

T1000 Series UPS 4-Post Rack Slide Kit

Installation Instructions- 94034-000

1. 4-Post Rack Slide Kit

Use the 4-Post Rack Slide Kit 92800 (1 kit per module) to mount a T1000 module with slides in a 19-inch,

4-Post rack. The slide assemblies are non-handed, and are provided with a lock-open feature and a quick

disconnect for the Inner Slide Member. When the Inner Slide Member is disconnected, the E-Z Rail latch in

the slide assembly locks the Middle Member in the fully open position until the Inner Member is reinstalled.

2. Contents - 4-Post Rack Slide Installation Kit (92800)

1 ea.: T1000 Series UPS 4-Post Rack Slide Kit Installation Instructions - 94034

2 ea.: Slide, 22 in., 370EZ-22

2 ea.: Bracket, Front Offset, SPO-538

2 ea.: Bracket, Rear Offset, SPO-552

8 ea: Screw, FHP (Flat Head Phillips) 8-32 x 3/8 in.

8 ea: Nut, serrated head, 8-32

8 ea: Screw, PHP, (Pan Head Phillips) 8-32 x 1/4 in.

16 ea.: Cage Nut, 1/4”-20

16 ea.: SEMS Hex bolt, 1/4”-20 x 5/8” (with assembled washer)

3. Attach E-Z Rail to Module

No. ITEM

1Slide Rail Inner Member (EZ Rail)

2Slide Rail Middle Member

3Slide Rail Outer Member (Outer Rail Sleeve)

4 E-Z Rail Latch

FIGURE 2 SLIDE ASSEMBLY

1. Remove the EZ Rail (Slide Rail Inner Member), Figure 2-(1), from the Slide Rail Middle Member, Fig-

ure 2-(2), by pressing the E-Z Rail Latch and sliding the EZ Rail out of the Middle Member. Repeat

for the second Slide Assembly.

2. Attach an EZ Rail to each side of the UPS module using 4 x Phillips 8-32 x 1/4”. Orient the inner

Slide Member so the rounded end is towards the rear of the module. (Figure 3)

1 2 3

FIGURE 3: INSTALL INNER SLIDE MEMBER ON LEFT AND RIGHT SIDES OF MODULE(S)

4 @ PHP

8-32 x 1/4 in.

7 in.

(178 mm)

7 in.

(178 mm)

5 in.

(127 mm)

Slide Rail

Inner Member

T1000 Series UPS 4-Post Rack Slide Kit Installation Instructions 94034-000 2

3. Repeat Steps 1-2 for all modules to be installed.

4. Attach Extender Brackets to Slide Assemblies

1. Ensure the Middle Slide Member, Figure 2-(2), is extended forward from the outer slide sleeve (outer

slide member), Figure 2-(3).

Note: The Bracket to Slide Assy. fasteners are a screw secured with a serrated nut.

2. Attach the long bracket to the rear of the slide assembly with two #8-32 x 3/8 in. screws and serrated

nuts (Figure 4). Insert the FHP screws from the inside out, so the nut is on the outside of the slide as-

sembly.

Do not over tighten the fasteners until the bracket assemblies have been mounted on the 4-Post rack.

3. Repeat Step 2 for the second long bracket.

4. Attach the front (short) bracket to the front of the slide assembly with two (2) #8-32 x 3/8 in. screws

and serrated nuts (Figure 4). Insert the screws through the access holes provided in the Middle Slide

Member.

Do not over tighten the fasteners until the bracket assemblies have been mounted on the 4-Post rack.

5. Repeat step 4 for the second front bracket.

5. Attach Slide Assemblies to 4-Post Rack

1. Remove the cage nuts from the Slide kit.

2. Clip one cage nut (Cage Nut, 1/4”-20) from the 92800 kit over each post’s

rack mounting hole at the desired elevation.

NOTE: Ensure all bracket slots align with the rack rail mounting holes to

establish the bottom unit elevation.

NOTE: If installing more than one T1000 module, begin with the lowest

module rst.

3. Clip a second cage nut 1.75 in. above each cage nut installed in step 1

(Figure 5). If using all four mounting slots, install all four cage nuts.

4. If more than one module is being installed for the T1000 system, install

the next set of cage nuts from the other module’s 4-Post Slide Kit three

(3) Rack Units (5 1/4”) above the rst set of cage nuts (Figure 5). Repeat

steps 2-3.

5. Repeat steps 2-4 until cage nuts for all the modules

in the system have been clipped on the 4-Post rack.

5.25 in.

(133 mm)

1.75 in.

(44 mm)

FIGURE 5 CAGE NUT

INSTALLATION

1.75 in.

(44 mm)

Short Bracket

Long Bracket Slide Assembly (shown w/o

Middle Member for clarity)

Fastener Insertion

1 in.

(25 mm)

1.75 in.

(44 mm)

FIGURE 4: ATTACH EXTENDER BRACKETS TO SLIDE ASSEMBLY

Front

T1000 Series UPS 4-Post Rack Slide Kit Installation Instructions 94034-000 3

6. Bolt the Side Rail/Bracket assembly to the 4-Post

Rack using two 1/4”-20 x 5/8” bolts each on the front

and back. Ensure the end with the short adapter

bracket is to the front of the rack. (See Figure 6)

7. Tighten the #8-32 screws used to assemble the Slide

Assembly and Bracket Extenders in Section 4.

8. Repeat step 6-7 for the remaining Side Rail/Bracket as-

semblies. (Figure 7)

6. Install T1000 Modules in Rackmount Slides

CAUTION: Battery Modules weight 150 lb.

(68 kg). Use lifting aids and proper lifting

techniques

NOTE: The T1000 System modules must be arranged top-

to-bottom in the following relative order:

• Transformer Module (if present)

• Power (UPS) Module

• Battery Module w/Output Panel (if present)

• Battery Panel w/o Output Panel (if present)

1. Lift the module intended for the bottom slide rail set, and slide the module’s E-Z Rails into the extended

Slide Middle Members.

2. Gently slide the module backward until the slides are fully retracted.

3. Repeat steps 1-2 for the module slide rail set immediately above the bottom one.

4. Continue until all modules have been installed on their slide rails.

5. Go to T1000 Installation and Operation Manual - 91074 to continue installation and cabling of the

T1000 System.

FIGURE 7: INSTALL REMAINING SLIDE RAIL

ASSEMBLIES IN 4-POST RACK

FIGURE 6: INSTALL SLIDE RAIL

ASSEMBLIES IN 4-POST RACK

INDUSTRIAL DIVISION

13131 West Little York Road, Houston, Texas 77041

Tel (713) 466-0277 Fax. (713) 466-8773

US (800) 231-1412 Canada (800) 872-2192 Mexico 01/800/527-1204

www.Toshiba.com/ind

Printed in the U.S.A.

Andere Handbücher für T1000 Series

Inhaltsverzeichnis

Andere Toshiba UPS Handbücher

Toshiba

Toshiba Black Gold Series Bedienungsanleitung

Toshiba

Toshiba G9000 SERIES Bedienungsanleitung

Toshiba

Toshiba UPSMON PRO T1000 Series Bedienungsanleitung

Toshiba

Toshiba 1800 SERIES Bedienungsanleitung

Toshiba

Toshiba Satellite 1700 Series Bedienungsanleitung

Toshiba

Toshiba 4400 Series Bedienungsanleitung

Toshiba

Toshiba 4200FA Series Bedienungsanleitung

Toshiba

Toshiba 4200FA Series Bedienungsanleitung

Toshiba

Toshiba G9000 SERIES Bedienungsanleitung

Toshiba

Toshiba UT1A1A010C6 Bedienungsanleitung

Toshiba

Toshiba RemotEye II Bedienungsanleitung

Toshiba

Toshiba G8000 Series Bedienungsanleitung

Toshiba

Toshiba G9000 SERIES Bedienungsanleitung

Toshiba

Toshiba UE3G2L036C61T Bedienungsanleitung

Toshiba

Toshiba 1000 Series Bedienungsanleitung

Toshiba

Toshiba Power Supply Bedienungsanleitung

Toshiba

Toshiba 1500 Plus Series Bedienungsanleitung

Toshiba

Toshiba G9000 SERIES Bedienungsanleitung

Toshiba

Toshiba UC1A1A020C6TB Installationshandbuch

Toshiba

Toshiba 4200FA Series Bedienungsanleitung

Toshiba

Toshiba 1600EP Series Bedienungsanleitung

Toshiba

Toshiba Satellite 1700 Series Bedienungsanleitung

Toshiba

Toshiba T90S3S08KS6XSN Bedienungsanleitung

Toshiba

Toshiba TOSNIC-7000S Bedienungsanleitung

Beliebte UPS Handbücher anderer Marken

Pylontech

Pylontech Victron & Pylontech US5000 Bedienungsanleitung

Tecnoware

Tecnoware EVO DSP PLUS MM 6.8 Bedienungsanleitung

Mustek

Mustek PowerMust 530(B) Plus Installations- und Betriebshandbuch

Emerson

Emerson Liebert NXL series Bedienungsanleitung

MAKELSAN

MAKELSAN BOXER SERIES Bedienungsanleitung

Block

Block PC-0524-400-0 Bedienungsanleitung

CyberPower

CyberPower CP585LCD Bedienungsanleitung

Eaton

Eaton 3S Montageanleitung

CyberPower

CyberPower Office Tower Series UPS 1000 Bedienungsanleitung

CyberPower

CyberPower BM100 Bedienungsanleitung

Best Power

Best Power 610 Bedienungsanleitung

Best Power

Best Power Unity/I UT3K Bedienungsanleitung

Mustek

Mustek PowerMust 400 Offline Bedienungsanleitung

Xantrex

Xantrex Trace 512 UR-UPS Bedienungsanleitung

Forza

Forza SL-1501UL Bedienungsanleitung

LEGRAND

LEGRAND keor 310081 Bedienungsanleitung

ABB

ABB Conceptpower DPA 500 Bedienungsanleitung

ZincFive

ZincFive BC Series Bedienungsanleitung