6
7
Set-up drawing
Controller 0ver 200
Warning
●Install the controller taller than F.L. by 200mm(Otherwise,
the strainer on the bracket will be inaccessible for cleaning.)
●Do not bend the Flexible tube at acute angle. Also, do not
bend it at the portion near the hexagon nut.
Installation procedure
Piping
Be sure to thoroughly flush away any
foreign matter such as dirt and sand
trapped in the water supply pipe.
Remove the stop valve.
Close the source stop valve.
Warning
Do not use the stop
valve with strainer
supplied with
Automatic Faucet.
②Loosen the two screws on the front
cover with the allen wrench.
③Pull and open the controller cover
to the direction as shown right.
④
Remove the quick fastener and then
remove the stop valve.
Pull
Controller
cover
Quick
fastener
Stop valve
with strainer
Position the controller.
①Connect the flexible tube and the
controller to the Optional bracket
tentatively.
②Determine the location of the
controller and mark holes of the
Optional bracket.
③Detach the flexible tube and the
controller.
Flexible tube
Controller
Marking holes
Warning
Be sure to place the controller with
its outlet at the top.
Otherwise, the water will come into
the controller resulting in product
malfunction.
Mount the optional bracket on the wall.
After drilling the wall,tighten
the Optional bracket with
tapping screws.
Tapping screws
Optional bracket
Connect the flexible tube to the Optional bracket .
other optional parts
Flexible tube
Packing
Optional
bracket
Warning
Never fail to attach the Packing.
Controller
Quick fastener
Optional bracket
Install Automatic Faucet.
Refer to the Instruction manual of
Automatic Faucet on the subseguent procedure.
Cleaning the strainer
①Close the stop valve.
Connect the controller to the
Optional bracket.
②
①
②
Remove the strainer cover
with open-close tool.
③Pull out the strainer and clean
it with a blush.
④Put the strainer back in its
place.
⑤Reopen the stop valve full. Strainer
Strainer cover
Open-close tool
Connect the controller to the Optional bracket.
Important
Optional bracket
Outlet of controller
G1/2
IN
Attach it with a quick fastener.
