9
Installing the Trays and Element:
1. To start using the grill, begin by placing the water tray inside.
2. When the water tray is in place, slot the drip tray into place over it. This tray
gathers oil and fat while the grill is in use. Use the format of the grill base and
drip tray as guidelines when installing the tray into the unit; the tray should slot
snugly into place inside the main section of the base.
3. When both trays are correctly installed, place the heating element over the
top of the drip tray. Use the recessed notch on the side of the grilling base as a
guide when installing the heating element; the element is correctly installed
when the control panel is slotted into this notch and sitting flush inside it.
Installing the Plates:
1. This unit is equipped with 2 plates: a grill plate, ideal for bacon, egg and
pancakes, and a grill plate, ideal for steaks, meat skewers, sausages and corn on
the cob.
2. When the trays and element are in place, the grill or griddle plate can be
installed.
Note: Only one plate can be installed at one time. DO NOT install both plates into
the unit at the same time.
3. To install the grill or griddle plate, place it over the heating element until it sits
flush atop it.
4. Once the corresponding plate has been installed, insert the power cable into
its corresponding jack on the side of the unit, underneath the control panel.
5. When the power cable is correctly attached to the grill, place the lid onto the
unit and connect it to an active mains socket.
6. The smokeless grill is now ready for normal use.
5 - Using Your Appliance
Turning the Appliance On:
1. To turn the appliance on, begin by plugging it into an active mains socket.
There will be a sound prompt and all the indicators on the control panel will
light up briefly to indicate the unit has been plugged into the mains.
2. When the unit is plugged into the mains, the Power indicator light will begin
to flash red. This signals the unit is ready for use.
3. When the unit is plugged in, press the Power button to turn it on. There will be
a sound prompt and the Power indicator light will turn solid red to show the
unit has been turned on and is pre-heating.
4. Once the unit has started heating up, press the Fan button to turn on the fan
function. There will be a sound prompt, the Fan button will light up solid blue
and the fan will automatically begin to work.
WARNING! DO NOT operate the grill with the fan function turned off.
5. When the fan is operating, press the + and - temperature control buttons to
select the required temperature for the food being grilled. Press the + button
to increase the temperature, or the – button to decrease it. There will be a
sound prompt and the bars on the LED temperature indicator dial will light up
or go out accordingly to show the temperature has been adjusted.
