Our model kits are subject to constant quality checks throughout the production process, and we sincerely
hope that you are completely satisfied with the contents of your kit. However, we would ask you to check all
the parts before you start construction, referring to the Parts List, as we cannot exchange components which
you have already modified. If you find any part is not acceptable for any reason, we will readily correct or
exchange it once we have examined the faulty component. Just send the offending part to our Model
Department. Please be sure to include the enclosed complaint form, duly completed. We are constantly
working on improving our models, and for this reason we must reserve the right to change the kit contents
in terms of shape or dimensions of parts, technology, materials and fittings, without prior notification.
Please understand that we cannot entertain claims against us if the kit contents do not agree in every
respect with the instructions and the illustrations.
Radio-controlled models, and especially model aircraft, are by no means playthings in the usual sense of the
term. Building and operating them safely requires a certain level of technical competence and manual skill,
together with discipline and a responsible attitude at the flying field. Errors and carelessness in building and
flying the model can result in serious personal injury and damage to property. Since we, as manufacturers,
have no control over the construction, maintenance and operation of our products, we are obliged to take
this opportunity to point out these hazards and to emphasise your personal responsibility.
Specifications
Steps of assembly
Choose a flying field
Center of gravity
Safety
1.Fuselage 1pc
2.Wing 1pc
3.Elevator 1pc
4.Rudder 1pc
5.Equipment canopy 1pc
6.Right wing fence 1pc
7.Left wing fence 1pc
8.Spinner 1pc
9.Fuselage foam block 1pc
10.Left part of landing gear 1pc
11.Right part of landing gear 1pc
12.Pull-pull fishing line 1pc
13.Vector system 1pc
14.Motor mount 1pc
15.Aileron servo control horn 1pc
16.GWS HD 8040 1pc
17.Screw (ST1.4*6 ) 14pcs
18.Adjustor 2pcs
19.O ring 2pcs
20.Spinner connecting part 1pc
21.Aileron push rod 2pcs
22.Wing bracings #1 2pcs
23.Elevator push rod 1pc
24.Washers 2pcs
25.Vector system push rod 2pcs
26.Elevator bracings 2pcs
27.Wing bracings #2 2pcs
1. Matched with vector rotating system on rudder which increases the flexibility on rudder control.
2. Good wind-resistance and stability, easy for control.
3. EPO foam construction that is beaufiful, crash-resistant and easy for maintenance makes very
robust airframe.
4. A thoughtful equipment cabin design, all electronic equipments can be installed and safely
secured inside.
5. Simple design, 85% pre-assembled and super convenient assembly process keeps you far
away from the complicated traditional assembly process of indoor 3D plane and long time
waiting.
6. Professional airframe configuration and special airfoil design makes it a great lightweight 3D
airplane for a wide flight speed range.
7. No matter you’re professional 3D flyer or just starting out in 3D, we believe Sbach342 is a
good choice.
Battery
3S 400mAh
20C Li-Po
Motor
AT2206V2
KV 1500
ESC
10A
With BEC
8
NO GRAVITY Specification
33.1 in (840 mm)
37.8 in (960 mm)
0.61 lb-0.65 lb (275g-295g)
Always be careful of propeller when plugging in the lipo batter y and
the lipo batter y is installed !!!!
NO GRAVITY
NO GRAVITY
