Town & Country Fireplaces TC42 Bedienungsanleitung

INSTALLER: Leave this manual with the appliance.

CONSUMER: Retain this manual for future reference.

These instructions are supplementary to the Installation and

Operating Instructions supplied with the replace and should be kept

together.Refer to the Installation and Operating Instructions for proper

gas supply, safety requirements and operating instructions

030511-16 TC42.NG05C 5056.426C5

TC42

HEARTWOOD

BURNER INSTALLATION

INSTRUCTIONS

PART#

TC42.NG05C

FOR TC42

Contents of Package

TC42.NG05C 030511-16

• BURNER ASSEMBLY

(including pilot and manifold)

• LOG GRATE

• EMBER MATERIAL (one bag)

• COAL CHUNKS (one bag)

• VERMICULITE (one bag)

• HARDWARE PACKAGE

If this replace is to be

used on Propane please

convert prior to installtion.

See pages 10 – 12.

Burner Installation

1. Place the keyhole slots in the burner

over the two screws located in the rebox

base. (Fig. #1 & 1a)

2. Slide the burner back to engage the

screws in the small part of the keyhole

slot and tighten screws. (Fig. #1b)

3. Remove access cover from side of

rebox(Fig. #1c)

Fig. # 1a

Fig. # 1b

SCREWS

Fig. # 1

Fig. # 1c

TC42.NG05C 030511-16

BULKHEAD PLATE

2 SCREWS

4. Secure the electrical bulkhead plate and

gasket to the rebox. (2 screws) Attach the

ignition and sensor wires to the module.

Red end to the connector marked by the

red dot, white end to the connector marked

by the white dot

Fig.#2 & Fig.#3

Fig. # 2

Burner/ Grate Installation

RED END TO

RED DOT

WHITE END TO

WHITE DOT MODULE

Fig. # 3

TC42.NG05C 030511-16

PILOT SUPPLY

TUBE

MAIN GAS SUPPLY

TUBE

Fig. # 4

5. Attach the pilot and gas supply tubes to

the bulk head tting and tighten.

(Fig. # 3b) Ensure the connections are

gas tight. Conceal the spark and

sensor wires below the supply tubes.

A panel set must now be installed. See

Installation and Operating Instructions

manual for details.

6. Position the slots of the grate securing

brackets over the holes in the oor shield

and secure with the two screws

(Fig. # 4).

Fig. # 3b

TC42.NG05C 030511-16

Note:

Ember material placement

and amount will affect

ame appearance.

More ember material

results in lower ame

height.

Add or remove as needed

until desired ame affect.

Reduce the amount used

on Propane models, as too

much will create soot

Fig. #5

Ember Material

Fig. #6

A large bag of ember material is shipped with the replace and needs to be installed on

the burner to ensure optimum performance and ame appearance. A bag of coal chunks

and lava rock is also supplied this must only be used around the burner pan to cover up

the gas lines and brackets.

1. Pull apart the material into ember size pieces (approximately 1” square) and

gently place them into the burner pan. Do not compress, leave them loose for best

performance.

2. Fill the burner pan with embers until level with the top of the pan at rear, and gradually

slope forward to the rebox oor at the front, covering both burner tubes.

3. Place remaining ember material, coal chunks and lava rock outside of the burner pan

as desired to cover-up gas lines and brackets. Do not put coal chunks or lava rock

inside burner pan as this will cause sooting and the burner to malfunction.

Embers only in this area.

Embers, coal chunks and lava rock.

TC42.NG05C 030511-16

Gas plumbing and vent connections should

be completed before proceeding.

The logs are fragile, and should be handled

with care. Unpack and inspect log set. There

should be a total of seven logs.

Position the logs as indicated by the following

pictures.The seven main logs have holes and /

or pins.Engage each pin in the corresponding

holes. The remaining two logs do not have

holes or pins. They rest in position. Locate as

per the diagrams (g. # 7-15)

Note:Improper placement of logs will cause

sooting on internal parts and glass. The

logs may need to be repositioned slightly

to avoid excessive ame impingement.

Log Placement

Fig. # 7

Fig. # 8

BASE LOG, #1

LEFT CENTER LOG, #2

TC42.NG05C 030511-16

Fig. #9

Fig. #10

LEFT FRONT LOG, #3

LOG WITH HOLE, #4

TC42.NG05C 030511-16

Fig. #11

Fig. #12

RIGHT CENTER LOG, #5

FRONT RIGHT LOG, #6

TC42.NG05C 030511-16

Fig. #14

Fig. #15

Fig. #13

CENTER TWIG, #8

RIGHT BASE LOG, #7

CENTER BASE CHUNK, #9

TC42.NG05C 030511-16

Propane Conversion

If the unit is to be used on propane,

convert as follows using the

components supplied with this

replace:

CAUTION

The gas supply and electrical power

must be shut off before proceeding

with the conversion.

Fig. # 17

Fig. # 18

Fig. # 16

WARNING

This conversion kit shall be

installed by a qualied

service agency in

accordance with the

manufacturer's instructions

and all applicable codes

and requirements of the

authority having

jurisdiction.

If the information in these

instructions is not followed

exactly, a re, explosion or

production of carbon

monoxide may result

causing property damage,

personal injury or loss of

life.

The qualied service

agency is responsible for

the proper installation of

this kit.

The installation is not

proper and complete un-

til the operation of the

converted appliance is

checked as specied in the

manufacturer's instructions

supplied with the kit.

Note: Factory supplied components must

be used to ensure correct input.

After conversion conrm proper manifold

pressure.

1. Ensure the burner, pilot and gas

supply are turned off, and the

appliance has cooled.

2. Remove the two screws securing the

manifold assembly to the burner.

(Fig. #16)

3. Remove the manifold assembly from the

burner. (Fig. #17)

4. With a ½”wrench remove the natural gas

orice (#25) and replace with propane

orice (3/32) (our part # 5021.31)

(Fig. #18)

5. Fully open the primary air shutter.

6. Reinstall the manifold assembly and

air deector.

MAIN BURNER

(332) ORIFICE (5021.31)

MINIMUM RATE SCREW (5005.016)

CONVERSION LABEL (5052.5206C)

LP GAS/

DU GAZ LP

12.5 in/wc /12.5 po/c.e.

(3.11 kPa)

13.9 in/wc / 13.9 po/c.e.

(3.45 kPa)

11.0 in/wc / 11.0 po/c.e.

(.95 kPa)

3/32” (2.38 mm)

Max.: 61,000 (17.9)

Min.: 46,200 (13.5) 260411 6-TC42C 5052.5206C

Date: ______________________

By / Par: ___________________

Kit # TC42.LPKTB/EB/EC for use with model:

Pour utilise avec du modèle:

This appliance was converted

to PROPANE GAS with this

kit on this date by the or-

ganization which accepts the

responsibility that this conver-

sion has been properly made.

/ Cet appariel etair converter

au gaz LP par l’emploi de la

trousse de conversion par une

organization qui accepte la

responsibilité pour une instal-

lation en bon état.

TC42

Series C

Andere Handbücher für TC42

Inhaltsverzeichnis

Andere Town & Country Fireplaces Brenner Handbücher

Town & Country Fireplaces

Town & Country Fireplaces TC36.NG03D Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36.NG01 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TCWS.54NGST04D Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TCWS54 SERIES D Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36.NG02CN Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC54.NG02D Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC42 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36.NG03C Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC30.NG02DN Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC42.NG03C Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC54.NG04C2 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC30.NG04C Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC42.NG02DN Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TCWS.38CE2 Gebrauchsanweisung

Town & Country Fireplaces

Town & Country Fireplaces TC42.NG06D2 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36.NGST03C Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36.NG06.D2 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC42.NG06C Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36.NG02DN Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC30.NG04D Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TCWS38 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC36.NG04D Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces TC30 Black Diamond Bedienungsanleitung

Beliebte Brenner Handbücher anderer Marken

Riello

Riello RS 28/M Kurzanleitung

True Induction

True Induction TI4B Bedienungsanleitung

Weishaupt

Weishaupt WG20 Series Bedienungsanleitung

Carolina Cooker

Carolina Cooker M116672 Bedienungsanleitung

Riello

Riello RX 500 S/PV Bedienungsanleitung

Unigas

Unigas HTP2000 Bedienungsanleitung

baltur

baltur BT 250 DSG 4T Bedienungsanleitung

muenkel design

muenkel design round burner Bedienungsanleitung

baltur

baltur BT 14 DSGW Bedienungsanleitung

artisan

artisan Art-SB1 Leitfaden

AESYS

AESYS TurboFire II Bedienungsanleitung

Riello

Riello RG1RKD Kurzanleitung

IKEA

IKEA GRILLSKÄR Bedienungsanleitung

RUSTA

RUSTA SAREK Bedienungsanleitung

PROPOINT

PROPOINT 8933657 Bedienungsanleitung

baltur

baltur TBL 1000 ME Referenzhandbuch

Riello Burners

Riello Burners P 200 P/G Kurzanleitung

WLD-TEC

WLD-TEC powerjet Bedienungsanleitung