TP-Link TL-SF1016D Bedienungsanleitung

TL-SF1005D

TL-SF1008D

TL-SF1016D

10/100Mbps Desktop Switch

REV: 1.0.0

1910010004

Specifications are subject to change without notice. is a registered trademark of

TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or

registered trademarks of their respective holders.

No part of the specifications may be reproduced in any form or by any means or used to make

any derivative such as translation, transformation, or adaptation without permission from TP-

rights reserved.

http://www.tp-link.com

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

•Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference that may

cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference,

in which case the user may be required to take adequate measures.

SAFETY NOTICES

Cautions

Do not use this product near water, for example, in a wet basement or near a swimming pool.

Avoid using this product during an electrical storm. There may be a remote risk of electric shock

from lightning.

Package Contents

The following items should be found in your box:

¾One TL-SF1005D/TL-SF1008D/TL-SF1016D Switch

¾One Power Adapter

¾This User Guide

)Note:

Make sure that the box contains the above items. If any of the listed items are damaged or

missing, please contact with your distributor.

CONTENTS

Chapter 1. Introduction of the Product...................................................................1

1.1 Overview of the Product............................................................................1

1.2 Convention................................................................................................1

1.3 Features....................................................................................................1

Chapter 2. Installation..............................................................................................2

2.1 Mounting the Switch on a Desk.................................................................2

2.2 Power On..................................................................................................2

Chapter 3. Identifying External Components.........................................................3

3.1 Front Panel ...............................................................................................3

3.2 Rear Panel................................................................................................3

Appendix A: Specifications.....................................................................................4

Appendix B: Troubleshooting.................................................................................5

Chapter 1. Introduction of the Product

Thank you for choosing the TL-SF1005D/TL-SF1008D/TL-SF1016D 10/100Mbps Desktop Switch.

1.1 Overview of the Product

TL-SF1005D/TL-SF1008D/TL-SF1016D 10/100Mbps Desktop Switch provides 5/8/16

10/100Mbps Auto-Negotiation RJ45 ports. All ports support Auto MDI/MDIX function, eliminating

the need for crossover cables or Uplink ports. The Switch is Plug-and-Play and each port can be

used as general ports or Uplink ports and can be simply plugged into a server, a hub, a switch or

a router and so on, using straight cable or crossover cable.

The TL-SF1005D/TL-SF1008D/TL-SF1016D 10/100M Desktop Switch provides you with a low-

cost, easy-to-use, high-performance, seamless and standard upgrade to improve your old

network to a 100Mbps network. It will boost your network performance up to full duplex data

transfer. Its wire-speed switching that forwards packets can be as fast as the speed that your

network delivers those packets to them.

1.2 Convention

The Switch or TL-SF1005D/TL-SF1008D/TL-SF1016D mentioned in this User Guide stands for

TL-SF1005D/TL-SF1008D/TL-SF1016D 10/100Mbps Desktop Switch without any explanation.

)Note:

The three devices of TL-SF1005D, TL-SF1008D and TL-SF1016D are sharing this User Guide.

For simplicity, we will take TL-SF1016D for example throughout this Guide,

The differences between them are:

¾TL-SF1005D Switch with 5 10/100Mbps Auto-Negotiation RJ45 ports.

¾TL-SF1008D Switch with 8 10/100Mbps Auto-Negotiation RJ45 ports.

¾TL-SF1016D Switch with 16 10/100Mbps Auto-Negotiation RJ45 ports.

1.3 Features

¾Complies with IEEE 802.3, IEEE 802.3u standards

¾5/8/16 10/100Mbps Auto-Negotiation RJ45 ports supporting Auto-MDI/MDIX

¾Supports IEEE802.3x flow control for Full Duplex mode and backpressure for Half Duplex

mode

¾Supports MAC address auto-learning and auto-aging

¾LED indicators for monitoring power, link, activity

¾Plastic case, desktop or wall-mounting design

¾External Power Adapter supply

Chapter 2. Installation

2.1 Mounting the Switch on a Desk

To install the Switch, please follow the steps:

1) You can place the Switch on a flat desk.

2) Please inspect the Power Adapter carefully and make sure that it is properly connected to a

power source.

3) Ensure adequate ventilation space around the switch for dissipating heat and air.

)Note:

Please avoid any heavy thing placed on the switch.

2.2 Power On

Powering on the Switch, it will automatically initialize and its LED indicators will respond as

follows:

1) All of the Link/Act LED indicators will flash momentarily, which represents a resetting of the

system.

2) The Power LED indicator will light all the time.

)Note:

If the LED indicators don’t respond as described above, please check the power supply and its

connection.

Chapter 3. Identifying External Components

This Chapter describes the front panel, rear panel and LED indicators of the Switch.

3.1 Front Panel

Figure 3-1 TL-SF1016D Switch Front Panel

The Switch’s LEDs are located on the front panel.

¾Power LED: This indicator will light up when the Switch powers on.

¾LEDs (1-16): One LED indicator will light green when a device is connected to the

corresponding port. It flashes when data is being transmitted or received

on the connection.

3.2 Rear Panel

Figure 3-2 TL-SF1016D Switch Rear Panel

The following parts are located on the rear panel:

¾Power: The Power socket is where you will connect the power adapter. Please use

the power adapter provided with this TL-SF1016D Switch.

¾Port (1-16): The TL-SF1016D Switch is equipped with 16 10/100Mbps Auto-Negociation

RJ45 ports where you will connect your network devices. The working

status can be indicated by the corresponding LEDs on the front panel.

Appendix A: Specifications

General

Standards IEEE802.3 10Base-T, IEEE802.3u 100Base-TX

Topology Star

Protocol CSMA/CD

Ethernet: 10Mbps (Half Duplex), 20Mbps (Full Duplex)

Data Transfer Rate Fast Ethernet: 100Mbps (Half Duplex), 200Mbps (Full Duplex)

10Base-T: UTP category 3, 4, 5 cable (maximum 100m)

EIA/TIA-568 100ΩSTP (maximum 100m)

Network Media(Cable) 100Base-TX: UTP category 5, 5e cable (maximum 100m)

EIA/TIA-568 100ΩSTP (maximum 100m)

Number of Ports 5/8/16 10/100Mbps Auto-Negotiation RJ45 ports

LED indicators Power, 10/100Mbps Link/Act

Transfer Method Store-and-Forward

MAC Address Learning Automatically learning, automatically aging

10Base-T: 14880pps/Port

Frame Filter Rate 100Base-Tx: 148800pps/Port

10Base-T: 14880pps/Port

Frame Forward Rate 100Base-Tx: 148800pps/Port

Environmental and Physical

Operating Temperature 0℃ ~40℃ (32℉~104℉ )

Storage Temperature -40℃ ~70℃ (-40℉~158℉)

Operating Humidity 10%~90% non-condensing

Storage Humidity 5%~90% non-condensing

Appendix B: Troubleshooting

1. The Power LED is not lit

Check to see if the power cord is connected to the Switch properly, and make sure the

power source is ON.

2. The Link/Act LED is not lit when a device is connected to the corresponding port

Check to see if the cable connectors are firmly plugged into the Switch and the device, and

verify the connected device is turned on and working well. Make sure the cable is not longer

than 100 meters (328 feet).

Andere Handbücher für TL-SF1016D

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere TP-Link Schalten Handbücher

TP-Link

TP-Link UH700 Bedienungsanleitung

TP-Link

TP-Link TL-SG1005D Bedienungsanleitung

TP-Link

TP-Link TL-SF1005P Bedienungsanleitung

TP-Link

TP-Link KS205 Bedienungsanleitung

TP-Link

TP-Link TL-SG105E Bedienungsanleitung

TP-Link

TP-Link T3700G-28TQ Bedienungsanleitung

TP-Link

TP-Link HS200 Bedienungsanleitung

TP-Link

TP-Link JetStream T1500G-10MPS Bedienungsanleitung

TP-Link

TP-Link JetStream TL-SL3452 Bedienungsanleitung

TP-Link

TP-Link JetStream T2600G-18TS Bedienungsanleitung

TP-Link

TP-Link JetStream L2 Lite TL-SG3210 Bedienungsanleitung

TP-Link

TP-Link UH720 Bedienungsanleitung

TP-Link

TP-Link JetStream T3700G-52TQ Bedienungsanleitung

TP-Link

TP-Link TL-SL5428 Bedienungsanleitung

TP-Link

TP-Link HS210 Bedienungsanleitung

TP-Link

TP-Link UH400 Bedienungsanleitung

TP-Link

TP-Link TL-SF1008P Installationsanleitung

TP-Link

TP-Link LiteWave LS1005G Bedienungsanleitung

TP-Link

TP-Link TL-SF1005D Bedienungsanleitung

TP-Link

TP-Link HS220 Bedienungsanleitung

TP-Link

TP-Link TL-SG1016DE Bedienungsanleitung

TP-Link

TP-Link TL-SF1005D Bedienungsanleitung

TP-Link

TP-Link JetStream L2+ Bedienungsanleitung

TP-Link

TP-Link TL-SG1428PE Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung