9
Direct mode: Allows for a one-to-one connection between the phone or tablet and
the scanner. Once the direct mode has been selected a number of networks will
appear on the app screen. Select the desired scanner (serial number located on rear
of hand held). The phone or tablet and scanner will be paired when both the bottom
and middle left LEDs light up blue and the device buzzes.
Network mode: Allows the scanner to connect to an external wi- network (stand
alone router). The phone or tablet will access the scanner in the same way that any
other device is accessed on a wi-fi network, such as a printer.
To enable Network Mode:
1. Connect the scanner in the direct mode
2. Hide keyboard to access settings menu, using the
Android back button.
3. In the settings menu (see below), select network
4. Select the relevant network/stand alone router
5. Enter the password for the network/router
6. Wait for the scanner to connect to the chosen
network
7. Once the top and bottom left LED light up, press
return on screen
8. The app will return to the home screen (as shown
on page 8)
9. Select option to connect to the scanner in network
mode.
10. You will be asked to choose your desired network / stand alone router)
11. Press and hold the scanner wi-fi button to broadcast the IP address of the
scanner, at which point all three blue LEDs will light up. The scanner will buzz
at which point, press discover in the app. Keep pressing the button (for up to 15
seconds) until the scanner reboots.
12. Note: this is required for rst time connection in network mode only
