High Resolution LPR Camera
Introduction
The Twilight Pro LPR camera adopts a high
resolution CCD, the new ISP and high speed
MCU design, which are very easy to use due
to the wired button or RS485.
The LED bright-ness can be adjusted. The
camera has a built in fan and heater and
double layer waterproof housing which is
weather sealed.
This is field proven for successful application
in extreme environments.
Specifications
Installation guide
Install the camera above the vehicle, and
avoid car headlight and sunlight from shining
directly into the camera.
For best results, the angle of elevation should
be about 30 degrees above the vehicle and no
more than 15 degrees off to either side.
The License plate should take up at least 10%
of the height of the image.
Adjust the zoom and focus once the camera is
positioned according to the suggestions
above.
The light sensor location is at the back of the
camera housing.
Avoid vehicle headlights shining at this too.
Connections
1. CVBS –Composite Video
2. DC Plug –12V DC 1A
3. RS-485 Connection
Connect the power supply. The camera can
utilise up to 1A at 12V DC.
Connect the CVBS to a Monitor or DVR.
Use L (mode -) or R (mode +) to adjust the
operation mode
The LED brightness can be adjusted using the
Up (brightness +) Down (brightness -)
Save using the centre push down button.
RS485 - The RS-485 allows the mode of
operation to be altered too.
RS-485
Connect the +/- to your controller TX +/-
The Default settings of the camera are as
listed below:-
Protocol: Pelco D/P autosensing
Baud Rate: 9600
Address: 001
T-Pro High Resolution LPR
Camera
1/3” SONY 960H Exview HAD II
1.0Vp-p/75Ω Video
composite video signal
IR LED , B/W image and ICR
auto switching
DC12V (±10%), 1A at
DC12V(Max)
Operating Temp: -30℃~to
70℃
Relative Humidity: 20%~90%
