Tyco Electronics 408-10254 Bedienungsanleitung

Instruction heet

PARALIGHT*

Active Optical 408-10254

LOC B

of 2

2008 Tyco Electronics Corporation, Harrisburg, PA

All International Rights Reserved

TE logo and Tyco Electronics are trademarks.

*Trademark. Other products, logos, and company names used are the property of their respective owners.

TOOLING A I TANCE CENTER 1-800-722-1111

PRODUCT INFORMATION 1-800-522-6752 This controlled document is subject to change.

For latest revision and Regional Customer ervice,

visit our website at

www.tycoelectronics.com

22 DEC 08 Rev A

Ca le Assem lies

1. INTRODUCTION

This product is for use in a restricted access

location onl .

This instruction sheet provides installation guidelines

for Tyco Electronics Active Cables for both CX4

and

QSFP connectors. Proper handling procedures

should be exercised when transporting or installing

the cables. Operation of the product must be

maintained within the 0 to 60°C operating ambient

temperature range.

CX4 connector is also known as Infiniband 4X or

SFF–8470.

This product does not contain an adjustable

controls.

Use of controls or adjustments or performance of

procedures other than those specified herein ma

result in hazardous radiation exposure.

Product is to be installed in accordance with both

National and Local regulations and/or

requirements or other authorit having

jurisdiction.

2. INSTALLATION GUIDELINES FOR CX4 STYLE

CONNECTOR ENDS

Refer to Figure 1 for installation of CX4 style

connectors.

1. Correctly align the CX4 plug with the receptacle

as shown in Figure 1A.

2. Insert the plug into the receptacle until it

bottoms. See Figure 1B.

3. To remove the plug from the receptacle, pull on

the “release handle” in the indicated direction until

the connector is removed as shown in Figure 1C.

3. INSTALLATION GUIDELINES FOR QSFP STYLE

CONNECTOR ENDS

Refer to Figure 2 for installation of QSFP style

connectors.

1. Correctly align the QSFP plug with the

receptacle as shown in Figure 2A.

Figure 1

1A 1B

Align CX4 Plug

with Receptacle

Insert Plug into Receptacle

Until It Bottoms

Pull on Release

Handle" to Remove

(Do NOT Pull on

Cable)

IEC60825-1

NOTE

DANGER

NOTE

408-10254

PARALIGHT Act ve Opt cal Cable Assembl es

Rev

f2 Tyc Electr nics C rp rati n

Figure 2

2A 2B

Align QSFP Plug

with Receptacle

Insert Plug int

Receptacle

Until It B tt ms

Pull n Pull

Tab" t Rem ve

(D NOT Pull

n Cable)

2. Insert the plug into the receptacle until it

bottoms. See Figure 2B.

3. To remove the plug from the receptacle, pull

back on the “pull tab” in the indicated direction until

it is removed as shown in Figure 2C.

4. HANDLING

Maximum bend radius of the optical cable per

ICEA–596 in the unloaded and install condition is

29 mm and in the loaded condition during installation

is 58 mm.

This product is classified as a Class 1M Laser product

in accordance with IEC 60825–1:1993+A1+A2 and

complies with 21CFR 1040.10 and 1040.11 except for

deviations pursuant to laser notice No. 50, dated

24–Jun–2007.

Do not c t or view a damaged fiber optic cable

with the naked eye or magnification instr ment.

For se with UL Listed ITE comp ting or

telecomm nication devises having SELV I/O

connections only.

5. REVISION SUMMARY

Initial release of document

DANGER

NOTE

Andere Tyco Electronics Kabel und Steckverbinder Handbücher

Tyco Electronics

Tyco Electronics AMP 1804018-1 Montageanleitung

Tyco Electronics

Tyco Electronics 1-1718624-1 Bedienungsanleitung

Tyco Electronics

Tyco Electronics Raychem C25-21 Bedienungsanleitung

Tyco Electronics

Tyco Electronics GPRA1 Bedienungsanleitung

Tyco Electronics

Tyco Electronics AMP NETCONNECT MRJ21 Bedienungsanleitung

Tyco Electronics

Tyco Electronics AMP Bedienungsanleitung

Tyco Electronics

Tyco Electronics AMP Series Bedienungsanleitung

Tyco Electronics

Tyco Electronics LightCrimp Plus ST Bedienungsanleitung

Tyco Electronics

Tyco Electronics AMP NETCONNECT MRJ21 Bedienungsanleitung

Tyco Electronics

Tyco Electronics LightCrimp Plus LC Bedienungsanleitung

Tyco Electronics

Tyco Electronics RECORDsplice Bedienungsanleitung

Tyco Electronics

Tyco Electronics D2950 Bedienungsanleitung

Tyco Electronics

Tyco Electronics Raychem HVS-T-1580E-S Series Bedienungsanleitung

Tyco Electronics

Tyco Electronics ACO Single Port Kits Bedienungsanleitung

Tyco Electronics

Tyco Electronics 16Pos.Plug Housing Referenzhandbuch

Tyco Electronics

Tyco Electronics LightCrimp Plus LC Bedienungsanleitung

Tyco Electronics

Tyco Electronics AMP NETCONNECT AMPTRAC Bedienungsanleitung

Tyco Electronics

Tyco Electronics 58449-1 Bedienungsanleitung

Tyco Electronics

Tyco Electronics 58062-1 Bedienungsanleitung

Tyco Electronics

Tyco Electronics SOLARLOK 4-1394462-6 Bedienungsanleitung

Tyco Electronics

Tyco Electronics 1362990-1 Bedienungsanleitung

Tyco Electronics

Tyco Electronics CPC 45 Series Bedienungsanleitung

Beliebte Kabel und Steckverbinder Handbücher anderer Marken

Philips

Philips SWA6310 Bedienungsanleitung

StarTech.com

StarTech.com CRJ4550PK Bedienungsanleitung

Nohau

Nohau EMUL-IP2K-PC Bedienungsanleitung

Foxun

Foxun SX-SP144E-HD4K2K Bedienungsanleitung

Philips

Philips SWA3305W Bedienungsanleitung

opticis

opticis Stretch DVIM1-1P0x Bedienungsanleitung

Volkswagen

Volkswagen VAS 6558A Bedienungsanleitung

NEXIBO

NEXIBO N-13 Bedienungsanleitung

CYP

CYP PU-1H3HBTL Bedienungsanleitung

Allen-Bradley

Allen-Bradley 1784-u2dhp Bedienungsanleitung

Global Caché

Global Caché Flex Link Blaster Bedienungsanleitung

Hauppauge

Hauppauge USB-Live2 Bedienungsanleitung

Fenix

Fenix MPSV 15 Bedienungsanleitung

BEGA

BEGA 71 085 Bedienungsanleitung

Tesla

Tesla HPWC Bedienungsanleitung

GAMERON

GAMERON LUXURY TV CABLE Bedienungsanleitung

molex

molex Milli-Grid Dual row 87568 Series Bedienungsanleitung

Burndy

Burndy Continental Industries thermOweld CRE-7 Bedienungsanleitung