Tyco Electronics AMP NETCONNECT MRJ21 Bedienungsanleitung

Instruction Sheet

AMP NETCONNECT* MRJ21* 48-Port

10/100/1000BASE-T Angled Pat h Panels 408-8963

LOC B

of 2

2007 Tyco Electronics Corporation, Harrisburg, A

All International Rights Reserved

TE logo and Tyco Electronics are trademarks.

*Trademark. Other products, logos, and company names used are the property of their respective owners.

TOOLING ASSISTANCE CENTER 1-800-722-1111

RODUCT INFORMATION 1-800-522-6752 This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at

www.ty oele troni s. om

19 JUN 08 Rev D

1777052-1 and 1777053-1

AM NETCONNECT* AM TRAC*

rinted Circuit ( C) Board Subassembly

(2 laces) (AM TRAC atch anel Only)

EIA Rack

(Ref)

Front of Patch Panel

Back of Patch Panel

12-24 Screw

(4 laces)

HD -22 Connector

(2 laces) (AM TRAC

atch anel Only)

MRJ21 Receptacle

(8 laces)

ort Identification

(16 laces)

ort Identification

(8 laces)



6 RJ45 Connector

Assembly (4 laces)

Right Side AM TRAC

ort Identification (AM TRAC

atch anel Only)

Left Side AM TRAC

ort Identification (AM TRAC

atch anel Only)

Standard Pat h Panel AMPTRAC Pat h Panel

1777052-1 1777053-1

Figure 1

1. INTRODUCTION

MRJ21 48–Port 10/100/1000BASE–T angled patch

panels are designed to be mounted onto a standard

483–mm [19–in.] Electronic Industries Alliance (EIA)

rack or equipment cabinet as shown in Figure 1.

The AMPTRAC patch panel is designed for use with

the AMP NETCONNECT AMPTRAC system. Read

these instructions thoroughly before starting

installation.

All numerical values in this instruction sheet are

in metric units [with U.S. customary units in

brackets]. Dimensions are in millimeters [and

inches]. Figures are not drawn to scale.

For the AMPTRAC patch panel, these

instructions assume that the reader understands

the operation of e uipment and software used

with the AMPTRAC system.

AMPTRAC Retrofit Kit 1479853–1 can be installed

onto the standard patch panel to enable the patch

panel to be connected to the AMP NETCONNECT

AMPTRAC system. Back Cable Manager Kits

1933352–[ ] or Wiring Distribution Bracket Kit

557548–1 must be used to support the cable.

To obtain information on AMP NETCONNECT

products, call PRODUCT INFORMATION at the

number at the bottom of this page, or visit the

AMP NETCONNECT website at

www.ampnetconnect.com.

Reasons for reissue of this instruction sheet are

provided in Section 6, REVISION SUMMARY.

2. DESCRIPTION

Each patch panel contains eight MRJ21 receptacles

(two per 2



6 RJ45 connector assembly). The ports

are identified by numbers printed on the front and

back of the patch panel. Four 12–24 screws are

included to mount the patch panel to the rack.

In addition, the AMPTRAC patch panel has two pc

board subassemblies and two HDP–22 connectors

to enable the patch panel to connect to the

AMP NETCONNECT AMPTRAC system.

NOTE

408-8963

M J21 48-Port 10/100/1000BASE-T Angled Patch Panels 1777052-1 and 1777053-1

Rev

of 2 yco Electronics Corporation

3. INSTALLATION

1. Using the screws, mount the patch panel onto

the rack. Refer to Figure 1.

2. Plug a connector (from the trunk cable) into

each MRJ21 receptacle (at the back of the patch

panel). Refer to Figure 2. Make sure to align the

keying features of the connector and receptacle.

Ensure that the connector is fully seated,

then

using a small cross–recessed tipped screwdriver,

turn the jack screws of the connector

clockwise

and tighten to a maximum torque of

0.23 Nm [2 lbf–in.].

To avoid damage to the connector, DO NOT

over-tighten the jack screws. DO NOT use an

automatic screwdriver.

3. For the AMPTRAC patch panel, plug the

connector of an I/O cable assembly

(PN 1499507–[ ]) from the analyzer into each

HDP–22 connector (at the back of the patch

panel). See Figure 2.

4. Install the bracket onto the rack. Using cable

ties or similar fasteners, attach the cables to the

bracket. It is recommended to maintain a minimum

bend radius of 50.8 mm [2 in.] when securing and

routing cables. See Figure 2.

For installation procedure for the wiring

distri ution racket, refer to Figure 2; for the

ack ca le manager, refer to Instruction Sheet

408-10170.

4. T OUBLESHOOTING

For port–to–cable pair cross–reference, refer to

Figure 3.

Figure 2

runk

Cable

Bracket

(Ref)

Connector Plugged

into MRJ21 Connector

(8 Places)

Cable

Front of

Patch Panel

Connector of I/O Cable

Plugged into HDP-22

Connector (2 Places)

(AMP RAC Patch Panel Only)

EIA Rack

(Ref)

357911

46810122



6 RJ45 Connector Assem lies

(Front of Patch Panel)

MRJ21 Receptacle

(Back of Patch Panel)

Pair 1Pair 3

Pair 2

Pair 4

15 17 19 21 23

16 18 20 22 2414

27 29 31 33 35

28 30 32 34 3626

25 39 41 43 45 47

40 42 44 46 4838

Left Side

Right Side

351

462

Note:

For Reference, Ports Labeled1-6AreShown

Pair 6 Pair 5Pair 8Pair 7

PO T CABLE PAI S

(4 Pairs Per Port)

1 13 25 37 1, 2, 3, 4

2 14 26 38 5, 6, 7, 8

3 15 27 39 9, 10, 11, 12

4 16 28 40 13, 14, 15, 16

5 17 29 41 17, 18, 19, 20

6 18 30 42 21, 22, 23, 24

7 19 31 43 1, 2, 3, 4

8 20 32 44 5, 6, 7, 8

9 21 33 45 9, 10, 11, 12

10 22 34 46 13, 14, 15, 16

11 23 35 47 17, 18, 19, 20

12 24 36 48 21, 22, 23, 24

Figure 3

5. EPLACEMENT AND EPAI

Patch panels are not repairable. DO NOT use a patch

panel with damaged or defective connectors.

6. EVISION SUMMA Y

Revisions to this instruction sheet include:

Added text to Steps 2 and 4 and CAUTION of

Section 3

CAUTION

NOTE

Inhaltsverzeichnis

Andere Tyco Electronics Kabel und Steckverbinder Handbücher

Tyco Electronics

Tyco Electronics 16Pos.Plug Housing Referenzhandbuch

Tyco Electronics

Tyco Electronics D2950 Bedienungsanleitung

Tyco Electronics

Tyco Electronics Raychem HVS-T-1580E-S Series Bedienungsanleitung

Tyco Electronics

Tyco Electronics RECORDsplice Bedienungsanleitung

Tyco Electronics

Tyco Electronics Raychem C25-21 Bedienungsanleitung

Tyco Electronics

Tyco Electronics 408-10254 Bedienungsanleitung

Tyco Electronics

Tyco Electronics LightCrimp Plus LC Bedienungsanleitung

Tyco Electronics

Tyco Electronics 1-1718624-1 Bedienungsanleitung

Tyco Electronics

Tyco Electronics CPC 45 Series Bedienungsanleitung

Tyco Electronics

Tyco Electronics SOLARLOK 4-1394462-6 Bedienungsanleitung

Tyco Electronics

Tyco Electronics AMP NETCONNECT MRJ21 Bedienungsanleitung

Tyco Electronics

Tyco Electronics LightCrimp Plus ST Bedienungsanleitung

Tyco Electronics

Tyco Electronics ACO Single Port Kits Bedienungsanleitung

Tyco Electronics

Tyco Electronics GPRA1 Bedienungsanleitung

Tyco Electronics

Tyco Electronics AMP Bedienungsanleitung

Tyco Electronics

Tyco Electronics LightCrimp Plus LC Bedienungsanleitung

Tyco Electronics

Tyco Electronics 58449-1 Bedienungsanleitung

Tyco Electronics

Tyco Electronics 58062-1 Bedienungsanleitung

Tyco Electronics

Tyco Electronics 1362990-1 Bedienungsanleitung

Tyco Electronics

Tyco Electronics AMP Series Bedienungsanleitung

Tyco Electronics

Tyco Electronics AMP 1804018-1 Montageanleitung

Tyco Electronics

Tyco Electronics AMP NETCONNECT AMPTRAC Bedienungsanleitung

Beliebte Kabel und Steckverbinder Handbücher anderer Marken

Philips

Philips SWA6310 Bedienungsanleitung

StarTech.com

StarTech.com CRJ4550PK Bedienungsanleitung

Nohau

Nohau EMUL-IP2K-PC Bedienungsanleitung

Foxun

Foxun SX-SP144E-HD4K2K Bedienungsanleitung

Philips

Philips SWA3305W Bedienungsanleitung

opticis

opticis Stretch DVIM1-1P0x Bedienungsanleitung

Volkswagen

Volkswagen VAS 6558A Bedienungsanleitung

NEXIBO

NEXIBO N-13 Bedienungsanleitung

CYP

CYP PU-1H3HBTL Bedienungsanleitung

Allen-Bradley

Allen-Bradley 1784-u2dhp Bedienungsanleitung

Global Caché

Global Caché Flex Link Blaster Bedienungsanleitung

Hauppauge

Hauppauge USB-Live2 Bedienungsanleitung

Fenix

Fenix MPSV 15 Bedienungsanleitung

BEGA

BEGA 71 085 Bedienungsanleitung

Tesla

Tesla HPWC Bedienungsanleitung

GAMERON

GAMERON LUXURY TV CABLE Bedienungsanleitung

molex

molex Milli-Grid Dual row 87568 Series Bedienungsanleitung

Burndy

Burndy Continental Industries thermOweld CRE-7 Bedienungsanleitung