Unicol NST1 Bedienungsanleitung

WARNING

Please carefully inspect the product before assembling. If you notice any apparent damage, call your

carrier claims agent and do not continue the installation until it has been reviewed. Please watch for

pinch points. Do not put your ﬁngers between moveable parts. Do not tamper with or disassemble any

spring loaded parts. Before installing, make sure that the supporting surface will support ﬁve times the

combined load of the solution and the hardware. Never exceed the maximum load capacity. Please also

layout all components to ensure that you have all of the required parts before proceeding (see BOM list

on following page). Use of this product for anything other than its speciﬁed use may result in failure or

personal injury. This product is intended for indoor use only. We recommend using a qualiﬁed trades

person for installation. Use an assistant or lifting equipment to lift and position products.

For support, please call: +44 (0)1865 767676 or email: [email protected]

Revised 15/12/20

01865 767676

[email protected]

www.unicol.com

*Please check model speciﬁc details before installing*

NST1 / NST2

Screen Size: 33-90” Guide Max. Weight: 80-150kg

01865 767676

[email protected]

www.unicol.com

2Revised 15/12/20

COMPONENTS

INSTALLERS REQUIRED

1-2

# DESCRIPTION QTY

1Standard Rhobus Base 1

2Universal Mount Back Plate 1

3Universal Mount Arms 2

4Rhobus Mast (inc. cabinet door) 1

5Manoeuvrability Handle 2

6Security Key 2

#TOOLS REQUIRED

1 Pozi Head Screwdriver

2 5mm Allen Key

3 4mm Allen Key

4 19mm Spanner

5 17mm Spanner

1 2

01865 767676

[email protected]

www.unicol.com

Revised 15/12/20

STEP 1

Laying the mast on a ﬂat surface, offer the base

up and attach as shown above. All castors should

already be pre-ﬁxed to the base.

STEP 2

Unlock and lift out rear door. Remove upper rear

panel by unscrewing 4x M6 screws.

STEP 3

Place 2x screws loosely in bottom two rivnuts of

the back plate from rear. Slot into chosen keyholes

in mast. From the rear, screw in top two screws into

the back plate and fully tighten all four screws.

STEP 4

Secure the manoeuvrability handles onto the side

of the mast. From the rear screw into the keyhole

slots and fully tighten. Repeat on the other side.

01865 767676

[email protected]

www.unicol.com

Revised 15/12/20

STEP 5

Feed cables for screen through hole in backplate

and front of mast and down through cable access.

Reﬁt rear top panel using x4 M6 screws. Reﬁt rear

top panel door and lock.

STEP 6

Locate the mounting holes on the back of your

screen. Line the two mounting arms up and using

the taglocks/two part spacers provided and the

manufacturer recommended screws (not included),

attach the arms to the back of the screen.

STEP 7

Line the screen and arms up with the secured back

plate and offer it up at a slight angle - allowing the

top of the arms to hook over the lip of the back

plate.

STEP 8

Gently lower the screen until the arms are securely

hanging on top of the back plate. Once centered,

adjust the level of the screen with the two top

screws on the mount arms. Once levelled secure

the screen by tightening the bottom two screws.

Dieses Handbuch passt für folgende Modelle

Andere Unicol Rack & Stand Handbücher

Unicol

Unicol PA2 Bedienungsanleitung

Unicol

Unicol ODS DOUBLE SIDED KIOSK Bedienungsanleitung

Unicol

Unicol GYROLOCK Bedienungsanleitung

Unicol

Unicol KP Kit Bedienungsanleitung

Unicol

Unicol TVV1 Bedienungsanleitung

Unicol

Unicol VERTISLIDE VTS1 Bedienungsanleitung

Unicol

Unicol Parabella Bedienungsanleitung

Unicol

Unicol AV2X2T Bedienungsanleitung

Unicol

Unicol RH200UHD Bedienungsanleitung

Unicol

Unicol WB0 Bedienungsanleitung

Unicol

Unicol AVECTA TWIN SCREEN ACHP Bedienungsanleitung

Unicol

Unicol RH200HD Bedienungsanleitung

Unicol

Unicol VS1000 Bedienungsanleitung

Unicol

Unicol NEC W82 Bedienungsanleitung

Unicol

Unicol PZW TILTING MOUNT Bedienungsanleitung

Unicol

Unicol Powalift Bedienungsanleitung

Unicol

Unicol TCAVT Bedienungsanleitung

Unicol

Unicol AZENITH VSX1800SC Bedienungsanleitung

Unicol

Unicol GKUX Bedienungsanleitung

Unicol

Unicol AX12P Bedienungsanleitung

Unicol

Unicol ADAPTA-WALL VWP0 Bedienungsanleitung

Unicol

Unicol SBM Bedienungsanleitung

Unicol

Unicol NEC W32-65L Bedienungsanleitung

Unicol

Unicol VCC1 Bedienungsanleitung

Beliebte Rack & Stand Handbücher anderer Marken

Salamander

Salamander Acadia AC/W/L400/WH Bedienungsanleitung

Fohhn

Fohhn VAT-09 Benutzerhandbuch

ricoo

ricoo FS0522 Bedienungsanleitung

AMSOIL

AMSOIL BMK-22 Kurzanleitung

Kargo Master

Kargo Master 48220 Bedienungsanleitung

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung

ricoo

ricoo S1222 Bedienungsanleitung

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Bedienungsanleitung

VidaBox

VidaBox VB MNT FFS2 Bedienungsanleitung

Welch Allyn

Welch Allyn 48960 Bedienungsanleitung

Arkon

Arkon CM035-ST-2 Bedienungsanleitung

PROEL

PROEL PLWIN60C Bedienungsanleitung

Agilent Technologies

Agilent Technologies E2609B Bedienungsanleitung

Mustang

Mustang MV-ARM4 Bedienungsanleitung

Mounting Solutions

Mounting Solutions WRM-320 Bedienungsanleitung

Pyle

Pyle PMKSPAD1 Bedienungsanleitung

ShelterIt

ShelterIt 21208 Bedienungsanleitung

SPL

SPL RackPack?4 1040 Bedienungsanleitung