Unique UGP 3 Montageanleitung

UNIQUE UGP 3

PORTABLE CAMPING REFRIGERATOR

Installation and Owner’s Manual

The installation of the appliance must conform with local codes ANSI

Z21.74 1992, in the absence of local national Fuel Gas Code, ANSI Z233.1,

and in Canada B149.2 Propane Storage and Handling Code.

WARNING:Improper installation, adjustment,

alteration, service or maintenance can cause

injury or property damage. Refer to this manual.

For assistance or additional information consult a

qualified installer, service agency or the gas

supplier.

!SAVE THESE INSTRUCTIONS!

FOR YOUR SAFETY IF YOU SMELL GAS

Open windows.

Do not touch electrical switches.

Extinguish any open flame.

Immediately turn off gas supply and call your gas supplier.

Do not store or use gasoline or other flammable vapors and

liquids in the vicinity of this or any other appliance.

FOR YOUR SAFETY

If you smell gas:

1. Evacuate enclosure

2. Call professional for help

2-S3-2014

MANUFACTURED AND CERTIFIED BY

Unique Gas Products Ltd

2245 Wyecroft Road #5

Oakville, Ontario Canada L6L 5L7

Ph: 905-827-6154 Toll Free: 1-877-427-2266 Fax: 905-827-2027

www.UniqueOffGrid.com

E-mail: [email protected]om

“

e”

”

Table of Contents

Chapters

Welcome 1

Safety and Warnings 1

Appliances Installation/ Operating Instructions 2

Maintenance & Service 3

Troubleshooting & Suggested Spares 4

Door Removal and Reversal 5

Temperature Controls & Food Storage and

Cleaning 6

Wiring Diagram 7

Parts & Warranty 8

UNIQUE UGP 3

Welcome &

Congratulations

ongratulations on your purchase of a UNIQUE refrigerator! We are very proud

of our product and we are completely committed to providing you with the best

service possible. Your satisfaction is our #1 priority. Please read this manual very

carefully. It contains valuable information on how to properly maintain your new gas

refrigerator.

We know you will enjoy your new refrigerator and thank you for choosing one of our

Unique Gas Products. We hope you will consider us for future purchases.

PLEASE READ AND SAVE THESE INSTRUCTIONS

This manual provides specific operation instructions for your model. Use your

refrigerator only as instructed in this manual. These instructions are not meant to cover

every possible condition and situation that may occur. Common sense and caution must

be practiced when installing, operating and maintaining the appliance

Please record your model and serial # shown below for future reference. This

information is found on your CSA rating/serial plate inside the refrigerator compartment.

Chapter

Please mail in the Warranty Registration Card

included with your refrigerator.

UNIQUE UGP 3

Safety and Warnings

If you smell gas

Open windows

Don’t touch electrical switches

Extinguish any open flame

Immediately call your gas supplier

For your safety

Do not store or use gasoline or other flammable vapors and liquids in the vicinity

of this unit or any other appliance.

Warning

Improper installation, adjustment, alteration, service or maintenance can cause

injury or property damage. Refer to this manual. For assistance or additional

information consult a qualified installer, service agency or the gas supplier.

This product can produce Carbon Monoxide. Carbon Monoxide has no odour

and can kill you. The burner and flue system must be kept clean. See owner’s

manual for cleaning instructions.

Electrical Grounding Instructions: This appliance is equipped with a three-prong

(grounding) plug for your protection against shock hazards and should be

plugged directly into a properly grounded three-prong receptacle. Do not cut or

remove the grounding prong from this plug.

Provide ample ventilation, especially when sleeping. This refrigerator consumes

air (oxygen). Do not use this refrigerator in unventilated structures to avoid

endangering your life. Provide additional ventilation for any additional fuel-

burning appliances and additional “occupants.”

Installation Instructions

The installation of the appliance must conform to ANSI Z21.74 1992 in the

absence of local national Fuel Gas Code, ANSI Z233.1, and in Canada B149.2

Propane Storage and Handling Code.



UNIQUE UGP 3

Installation and Operating Instructions

Installation

For best performance at high ambient temperatures, there must be free air

circulation over the cooling unit at the rear of the refrigerator.

Ensure that there is a free air space above the refrigerator and that the flue (chimney)

on top of the cabinet is not covered in any way. Do not place the refrigerator in a

space where air circulation is restricted. Follow “clearance” instructions.

This UNIQUE 3 appliance has been certified as a portable camping appliance in North

America it must be used as a portable camping appliance for use outdoors in sheltered

area. While using on electrical operation this unit can be used in an enclosed area but

must still be protected from moisture as comply with all clearances.

For installation, for maintaining proper clearances from combustible material to the

refrigerator, the following minimum clearance must be observed:

Clearances

Minimum clearances to combustible materials are:

Top – 4”

Sides – 1”

Rear – 1”

Chapter

UNIQUE UGP 3

Note: DO NOT install the appliance directly on carpeting. Carpeting must be

removed or protected by a metal or wood panel beneath the appliance, which

extends at least the full width and depth of the appliance.

Keep appliance area clear and free from combustible materials, gasoline and other

liquids with flammable vapors.

WARNING –DO NOT USE FLAME TO CHECK FOR GAS LEAKS

Levelling

Ensure the fridge is leveled by using a 2ft level; the operation of this unit uses an

absorption system which requires the appliance to be level in order to operate

effectively.

Connecting to Gas Cylinder

The refrigerator is designed for a 20# steel propane self-contained fuel cylinder of

not more 4.6 gal (20lbs) capacity. The cylinder(s) must be constructed and marked in

accordance with the specifications for LP-gas cylinders of the U.S. Department of

Transportation, DOT SPEC. 39 (49CFR 178.65).

Connecting of Gas Supply

1. Use supplied regulator and hose to connect your appliance to the gas supply.

2. Hook up the 5/8”-18UNF connection to the back of your appliance using a

backup wrench.

3. Attach the regulator cap to the tank inlet connection and ensure it is tight.

UNIQUE UGP 3

4. After connecting, all

gas connections must be checked for leaks

. For this, put

a soapy solution on all gas connections, turn on the gas cylinder manual valve and

watch for bubbles. Never use an open flame to check for leaks.

Note: The gas supply system must incorporate a pressure regulator to maintain a supply

pressure of not more than 12” water column and no less than 11” water column. (Max

setting)

General Operating Instructions

Importance of Leveling a Refrigerator

The refrigerator must be adjusted to a vertical position in both directions. In an

absorption refrigeration system, ammonia is liquefied in the finned condenser coil at the

top rear of the refrigerator. The liquid ammonia then flows into the Evaporator (inside

the freezer section) and is exposed to circulating flow of hydrogen gas, which causes the

ammonia to evaporate, creating a cold condition in the freezer.

When starting this refrigerator, the cooling cycle may require 6 to 8 hours of running time

to begin cooling before the cooling unit is fully operational, you can then begin slowly

loading the compartment.

The tubing in the evaporator section is specifically sloped to provide a continuous

movement of liquid ammonia, flowing downward by gravity through this section. If the

refrigerator is operated when not level, liquid ammonia will accumulate in sections of the

evaporator tubing. This will slow the circulation of hydrogen and ammonia gas, or in

severe cases, completely block it, resulting in a loss of cooling. Warranty will not cover

recharge/rebuild if caused by not running the fridge level.

This refrigerator operates on LP Gas (Propane), 110V (Electricity) and 12V DC.

Gas Operation

“Start Up” Procedure

After initial installation, servicing, or changing gas cylinders etc., the gas pipes may

contain some air which should be allowed to escape by briefly turning on the

refrigerator. This will ensure that the flame lights immediately.

1. Make sure that all valves between the gas container and the refrigerator are

open.

2. Turn selector switch (E) to gas.

3. Depress the safety device control (D) and hold it down while immediately

depressing the electronic igniter button (B).

4. Check the flame indicator (C) to see whether the flame is alight.

UNIQUE UGP 3

5. Keep the safety device control (D) depressed for a further 10-15 seconds.

6. Release the safety device control (D) and again check to see that the flame is

alight.

7. Adjust the thermostat knob (E) to desired temperature setting after 6 to 8

hours of operation.

8. To terminate gas operation, turn selector switch (F) to either AC, DC or

OFF position.

9. To change the battery in the electronic ignition, turn button (A) to the left to

expose the battery, remove AAA battery and replace with new one (positive

facing outwards), replace the knob and turn to the right to close.

Shut Down Procedure – LP Gas

A. Turn selector knob (F) to the “AC, DC or OFF” position.

B. Shut the gas off at the LP-gas supply cylinder when the appliance is not in use.

C. If the refrigerator will not be in operation for a period of weeks, it should be emptied,

defrosted, cleaned and the doors left open. The ice tray should also be dried and kept

outside the cabinet.

110V Operation

1. Make sure that the gas valve is turned off at the tank.

2. Ensure the electrical cord is plugged into a grounded outlet.

3. Turn the selector switch (F) to AC position. AC power indicator will illuminate.

4. Adjust the thermostat knob to desired temperature setting after 6 to 8 hours of

operation.

12V DC Operation

1. If 110 Volts or LP gas is not available, the refrigerator can work with DC12V

(3-Way models only).

2. Make sure that you turn the main power switch (F) to “DC” position. Then

you can connect the 12VDC power to the terminal block which is available

in the rear bottom part of the refrigerator.

3. DC operation is not as efficient as LP Gas or AC operation. DC electric

should not be used to initially cool the refrigerator. Only use DC when the

UNIQUE UGP 3

other modes are unavailable (for example; while in transit). When you start to

use AC or gas supply, make sure that you disconnect the DC power input.

CONTROLS – See Fig. #1 for description of controls

Figure #1

A B C D E F

Thermostat

The refrigerator cooling temperature is controlled by a combination thermostat that can

be adjusted by turning knob E to different settings to maintain the desired refrigerator

temperature when operating on either gas or 110V. Knob Dalso incorporates a safety

device which automatically shuts off the supply of gas if the flame goes out. The

electronic igniter discharges sparks onto the burner when the button is pushed.

1. “DEF” Defrost setting on the Gas/Electric Thermostat: In gas operation, the

thermostat closes its main valve and the burner runs continuously at the bypass rate or

pilot flame (turn fully counter clockwise), and in 110V operation the element will cycle

off, until cooling is again required.

2. “MAX” Setting of the Thermostat: In gas operation, the thermostat allows the

burner to remain on high flame continuously (turn clockwise), and in 110V operation the

element will stay on until the desired temperature is reached inside the fridge.

3. The thermostat can be adjusted between “Max” and “Warm” to obtain the desired

fridge temperature. When the thermostat reaches the set temperature, it will reduce the

burner back to bypass operation or shut the element off in 110V operation.

4. In DC operation the fridge will only maintain the temperature that’s already been

achieved. There is no thermostatic function.

Inhaltsverzeichnis

Andere Unique Kühlschrank Handbücher

Unique

Unique UGP 6C CR Bedienungsanleitung

Unique

Unique UGP-275L W Bedienungsanleitung

Unique

Unique UGP 6C Bedienungsanleitung

Unique

Unique Classic UGP-385L CR Bedienungsanleitung

Unique

Unique UGP-10 Montageanleitung

Unique

Unique UGP-60L1 Bedienungsanleitung

Unique

Unique PRESTIGE UGP-278L P S/S Bedienungsanleitung

Unique

Unique UGP-470L Bedienungsanleitung

Unique

Unique UGP 15 Montageanleitung

Unique

Unique UGP 22 Bedienungsanleitung

Unique

Unique UGP 18F Bedienungsanleitung

Unique

Unique UGP 13 Bedienungsanleitung

Unique

Unique Retro UGP-215L B AC Bedienungsanleitung

Unique

Unique UGP-275L B AC Bedienungsanleitung

Unique

Unique Prestige UGP-328L P S/S Bedienungsanleitung

Unique

Unique LGP 18 Bedienungsanleitung

Unique

Unique UGP-290L Bedienungsanleitung

Unique

Unique UGP 13 Montageanleitung

Unique

Unique UGP 6C Konfigurationshandbuch

Unique

Unique CB2426 Bedienungsanleitung

Unique

Unique UGP-80L1 W Bedienungsanleitung

Unique

Unique UGP-330L W AC Bedienungsanleitung

Unique

Unique UGP-50L1 Bedienungsanleitung

Unique

Unique UGP-170L1 Bedienungsanleitung

Beliebte Kühlschrank Handbücher anderer Marken

Bonnet Neve

Bonnet Neve SKYVIEW PLUS Bedienungsanleitung

Zanussi Electrolux

Zanussi Electrolux ZERB 8441 Bedienungsanleitung

Sharp

Sharp SJ-BA31IEXW2-EU Bedienungsanleitung

CORBERO

CORBERO CC2300MCW Bedienungsanleitung

KitchenAid

KitchenAid 2205264 Bedienungsanleitung

Stengel

Stengel KU 1101 A++ Bedienungsanleitung

NEFF

NEFF KI181 Series Bedienungsanleitung

Hoshizaki

Hoshizaki Reach-In Bedienungsanleitung

Amana

Amana ASD2524VES00 Bedienungsanleitung

BOMANN

BOMANN KGC 213 Bedienungsanleitung

Danby

Danby DAR044A1SLDD Montageanleitung

Samsung

Samsung RF323TE Bedienungsanleitung

Beko

Beko CSA31022 Bedienungsanleitung

IKEA

IKEA FROSTIG C 185 E Bedienungsanleitung

Electrolux

Electrolux ER 6821 D Bedienungsanleitung

True

True TS-28 Bedienungsanleitung

Frigidaire

Frigidaire FSC23R5DW9 Bedienungsanleitung

Beko

Beko LSP4579W Bedienungsanleitung