Venstar T3900 Kurzanleitung

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for an

intentional radiator, pursuant to Part 15, subpart C of the FCC rules.These limits

are designed to provide reasonable protection against harmful interference

in a residential installation.This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference in radio communications.

However, there is no guarantee that the interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the

following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that of the

receiver.

•Consult the dealer or an experienced radio orTV technician for help.

Notice: Only peripherals complying with FCC limits may be attached to this

equipment. Operation with noncompliant peripherals or peripherals not

recommended by Venstar, is likely to result in interference to radio and TV

reception. Changes or modiﬁcations to the product, not expressly approved by

Venstar could void the user’s authority to operate the equipment.

FCC - INDOOR Mobile Radio Information:

To comply with FCC/IC RF exposure limits for general population / uncontrolled

exposure, the antenna(s) used for this transmitter must be installed to provide a

separation distance of at least 20 cm from all persons and must not be co-located

or operating in conjunction with any other antenna or transmitter.

This Device complies with Industry Canada License-exempt RSS standard(s).

Operation is subject to the following two conditions: 1) this device may not

cause interference, and 2) this device must accept any interference, including

interference that may cause undesired operation of the device.

Follow the Installation Instructions before proceeding. Set the

thermostat mode to “OFF” prior to changing settings in setup

or restoring Factory Defaults.

CAUTION

This Voyager thermostat has the ability to receive updates to its ﬁrmware.

Periodically ﬁrmware updates are released by the manufacturer to add features

and/or performance enhancements.This manual was produced reﬂecting the

most current ﬁrmware/feature set at the time of publication, ﬁrmware rev. 1.0.

Firmware releases after rev. 1.0 may not be adequately depicted in this manual.

Please refer to the appropriate website or contact your place of purchase to learn

about changes to the thermostat after ﬁrmware release 1.0.

Under Industry Canada regulations, this radio transmitter may only operate using

an antenna of a type and maximum (or lesser) gain approved for the transmitter

by Industry Canada.To reduce potential radio interference to other users, the

antenna type and its gain should be so chosen that the equivalent isotropically

radiated power (e.i.r.p.) is not more than that necessary for successful

communication.

Cet appareil est conforme avec Industrie Canada, exempts de licence standard

RSS(s). Son fonctionnement est soumis aux deux conditions suivantes: 1) ce

dispositif ne doit pas causer d’interférences, et 2) ce dispositif doit accepter

toute interférence, y compris les interférences qui peuvent causer un mauvais

fonctionnement de l’appareil.

En vertu des règlements d’Industrie Canada, cet émetteur de radio ne peut

fonctionner en utilisant une antenne d’un type et maximale (ou moins) Gain

approuvé pour l’émetteur par Industrie Canada. Pour réduire les interférences

radio potentielles aux autres utilisateurs, le type d’antenne et son gain doivent

être choisis aﬁn que la puissance isotrope rayonnée équivalente (PIRE) ne est pas

plus de ce qui est nécessaire pour une communication réussie.

We, Venstar, declare under our sole responsibility that the device to which

this declaration relates: Complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

MUH-SKYPORT3

iii

Glossary of Terms

Auto-Changeover: A mode in which the thermostat will turn on the

heating or cooling based on room temperature demand.

Cool Setpoint: The warmest temperature that the space should rise

to before cooling is turned on (without regard to deadband).

Deadband: The number of degrees the thermostat will wait, once a

setpoint has been reached, before energizing heating or cooling.

Dehumidify:To reduce the amount of moisture in the air.

Differential: The forced temperature difference between the heat

setpoint and the cool setpoint.

Heat Setpoint:The coolest temperature that the space should drop

to before heating is turned on (without regard to deadband).

Humidify:To increase the amount of moisture in the air.

Icon: The word or symbol that appears on the thermostat display.

Mode: The current operating condition of the thermostat (i.e. Off,

Heat, Cool, Auto, Program On).

Non-Programmable Thermostat: A thermostat that does not have the

capability of runningTime Period Programming.

Programmable Thermostat: A thermostat that has the capability of

runningTime Period Programming.

Reheat: Running the cooling and 2nd stage strip heaters at the same

time in order to dehumidify the air without cooling down the room

temperature.

Temperature Swing: Same as Deadband.

Time Period Programming: A program that allows the thermostat

to automatically adjust the heat setpoint and/or the cool setpoint

based on the time of the day.

Table of Contents

GET TO KNOW YOUR THERMOSTAT

Get to Know Your Thermostat....................................................... 1

Quick Start ..................................................................................... 6

INTALLATION INSTRUCTIONS

Installation Instructions ................................................................. 9

Sample Wiring Diagrams.............................................................. 13

Test Operation............................................................................... 16

USER SETUP

Backlight Operation...................................................................... 17

Scrolling Display Options ............................................................. 18

Programming Vacation/Away....................................................... 19

Emergency Heat ........................................................................... 19

Wireless Modules ......................................................................... 20

Service Filter ................................................................................. 24

Runtimes ....................................................................................... 25

Time Period Programming ........................................................... 26

INSTALLER SETUP

Program Mode Operation............................................................. 28

Setpoint Limits.............................................................................. 29

Timers and Deadbands ................................................................ 30

Programming Fan Operation........................................................ 31

Comfort Recovery Operation ....................................................... 31

Humidication & Dehumidication .............................................. 32

Dual Fuel Operation...................................................................... 33

Remote Sensor Operation............................................................ 34

Auxiliary Output ............................................................................ 35

Dry Contact Operation ................................................................. 37

Factory Defaults............................................................................ 38

TECHNICIAN SETUP

Sensor Calibration ........................................................................ 40

Equipment Testing ........................................................................ 40

Advanced Output Testing............................................................. 40

Advanced Setup Table ................................................................. 41

Troubleshooting ............................................................................ 44

INDEX .............................................................................................. 45

Table of Contents

Get To Know Your Thermostat

Optional Wireless Module

Backlit, Scrolling Display

Backlit Cooler & Warmer

Buttons

Backlit LCD Display

Mode Button

Heat or Cool

Demand Indicator

Red = Heat, Green = Cool

Setup Buttons Behind Door

Setup Buttons

Get To Know Your Thermostat

Display Features

1The scrolling display will be used to help you easily navigate

the setup screens in the thermostat.

2Clock with Day of the Week

Indicates the current time and day. This clock is also used to

program the time period schedules.

3Mode Indicators

Selects the operational mode of the equipment.

HEAT - Indicates the heating mode.

COOL - Indicates the air conditioning mode.

HEAT & COOL - Indicates the system will automatically change-over

between heat and cool modes as the temperature varies.

OFF - Indicates heating and cooling is turned off.

4Program icon

Indicates thatTime Period Programming is running or is enabled

to be set.

5RoomTemperature Display

Indicates the current room temperature and displays the outdoor

temperature when selected.

6Outdoor icon

Indicates the temperature displayed is from the optional

outdoor sensor.

Program ONOFF

Outdoor

Fan On

COOL

AUXHEAT

Day Night

Morning

Evening

Setup Step

2nd3rd

Stage

18:88

188

Get To Know Your Thermostat

Display Features

7 Desired SetTemperature

Indicates desired room temperature(s). Also displays

the highest and lowest temperatures for the day.

8 Morning, Day, Evening & Night icons

Indicates the day part of the time period program.

9 Wi-Fi icons

Indicates the thermostat is currently connected to the

Local Area Network, via the optional Wi-Fi module.

10 Setup Step icon

Indicates the step number when the thermostat

is in the setup mode.

11 2nd and 3rd Stage icons

Indicates what stage of cooling or heating is currently energized.

12 icon

Indicates the keypad has been locked.

Program ONOFF

Outdoor

Fan On

EAT

Day Night

Morning

Evening

Setup Step

2nd3rd

Stage

18:88

188

Get to know your thermostat

Display Features

13 AuxHeat icon

Indicates 2nd stage electric strip heat is being used when the

thermostat is programmed for Heat Pump operation. Only the

Aux icon will appear during Cool to Dehumidify to indicate

Reheat operation.

14 Lo icon

Indicates the lowest recorded outdoor temperature for the day.*

15 Hi icon

Indicates the highest recorded outdoor temperature

for the day.*

16 Fan On icon

Indicates constant, continuous fan operation.

When Fan On is not lit - indicates the fan will only

operate when necessary to heat or to cool.

* Hi and LoTemperatures for the day, reset at midnight.

Program ONOFF

Outdoor

Fan On

EAT

Day Night

Morning

Evening

Setup Step

2nd3rd

Stage

18:88

188

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Venstar Thermostat Handbücher

Venstar

Venstar ColorTouch T6800 Betriebsanleitung

Venstar

Venstar T2900 Bedienungsanleitung

Venstar

Venstar T1010 Bedienungsanleitung

Venstar

Venstar T2150 Originalbetriebsanleitung

Venstar

Venstar T1010 Bedienungsanleitung

Venstar

Venstar INSTEON 2491T1E Bedienungsanleitung

Venstar

Venstar ColorTouch Bedienungsanleitung

Venstar

Venstar T2700 Bedienungsanleitung

Venstar

Venstar T1035 Bedienungsanleitung

Venstar

Venstar T2900 Bedienungsanleitung

Venstar

Venstar T1800 Bedienungsanleitung

Venstar

Venstar ColorTouch T5800 Gebrauchs- und Pflegehandbuch

Venstar

Venstar T2300FS Bedienungsanleitung

Venstar

Venstar EXPLORER Mini T2100 Originalbetriebsanleitung

Venstar

Venstar T0051FS Bedienungsanleitung

Venstar

Venstar EXLORER Mini Originalbetriebsanleitung

Venstar

Venstar ColorTouch T6800 Betriebsanleitung

Venstar

Venstar T1070 Betriebsanleitung

Venstar

Venstar T0130 Bedienungsanleitung

Venstar

Venstar TSTATEZ Bedienungsanleitung

Venstar

Venstar T2900 Bedienungsanleitung

Venstar

Venstar T4975-IAQ Betriebsanleitung

Venstar

Venstar T2800 Bedienungsanleitung

Venstar

Venstar TSTATEZ Bedienungsanleitung

Beliebte Thermostat Handbücher anderer Marken

EWELLY

EWELLY EW-181 Bedienungsanleitung

Prolon

Prolon T1100 Montageanleitung

Computherm

Computherm Q20 Bedienungsanleitung

Heatmiser

Heatmiser neoStat Bedienungsanleitung

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Bedienungsanleitung

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Bedienungsanleitung

Saswell

Saswell SAS920XWHB-7-S-RF Leitfaden

Aircalo

Aircalo TFP1-ET85P2 Bedienungsanleitung

Honeywell

Honeywell CM721 Bedienungsanleitung

Carrier

Carrier DEBONAIR 33CS Bedienungsanleitung

Lennox

Lennox iHarmony Zone Thermostat Montageanleitung

Gemtech

Gemtech GT7000 Bedienungsanleitung

Rollei

Rollei Smartes 45000 Bedienungsanleitung

Sinope

Sinope TH1300RF Bedienungsanleitung

Honeywell

Honeywell RLV4305 Bedienungsanleitung

Honeywell

Honeywell Prestige 2.0 THX9421 Bedienungsanleitung

NuTone

NuTone NTBZ48 Original Betriebsanleitung

Stelpro

Stelpro MAESTRO ASMT402AD Bedienungsanleitung