Vermont Castings Intrepid II Bedienungsanleitung

Intrepid II Wood Stove

Fuel

Burn 16" ﬁrewood that has been split, stacked, and air-dried for about one year.

Controls

Two controls are used to operate the stove. The damper handle, located on the right side of the stove, controls

the position of the internal stove damper. When the damper handle is pointed down, the internal stove damper

is in the open position. Hot smoke and gases rising from the ﬁre ﬂow directly to the ﬂue collar of the stove

and to the chimney. When the damper handle is pointed to the front, the internal damper is in the closed

position. Hot smoke and gases rising from the ﬁre are directed through the exit slot in the ﬁreback and

through the catalytic combustion system before passing through the ﬂue collar of the stove and to the

chimney. The thermostat lever, located on the top right rear of the stove, allows manual control of the primary

air supply. As you move the lever toward the left, the air shutter opens and admits more air. This will increase

the rate of combustion and the heat output.

Starting the Stove

1. Set the Controls

Turn the damper handle so it points down. This opens the internal stove damper.

Move the thermostat lever toward the left to admit maximum air.

2. Kindle a Fire

Build a paper and kindling ﬁre. When the kindling wood is burning well, start adding split dry pieces of wood

about 3" in diameter. Build the ﬁre gradually until you have established a bed of hot coals 3" to 4" thick on

the grate. Avoid the extremes of a roaring blaze or a slow smoky ﬁre. Building the bed of coals on the grate

may take an hour or more.

A strong kindling ﬁre preheats the stove and chimney system.

3. Griddle Temperature

300-400oindicates low-to-medium heat output. 400-500oindicates medium heat output. 500-600oindicates

high heat output. 450ois necessary to begin catalytic combustion -- close the damper.

4. Load the Stove

Add more wood according to familiarity with the stove and heating requirements. A very full load will enable

you to increase the heat output and length of burn.

5. Close the Damper

When the griddle temperature reaches 450o, close the damper. Leave the thermostat lever open for

approximately 15 minutes after you close the damper. This will allow the hot smoke to heat the chamber

thoroughly.

6. Adjust the Thermostat

Adjust the thermostat lever to provide the desired heat output.

Reloading the Stove

Reload the stove while the system is still hot and there is plenty of charcoal to re-kindle the ﬁre quickly.

Including some smaller pieces of wood in the new load will help the stove regain high temperatures quickly.

Open the damper, empty ash pan if necessary, load wood in griddle.

The stove must rebuild its thermal momentum. Leave the damper and thermostat open until the surface

temperature reaches 450o.

Andere Handbücher für Intrepid II

Inhaltsverzeichnis

Andere Vermont Castings Holzofen Handbücher

Vermont Castings

Vermont Castings The Intrepid II 1990 Bedienungsanleitung

Vermont Castings

Vermont Castings MONTPELIER II Bedienungsanleitung

Vermont Castings

Vermont Castings 410 Montageanleitung

Vermont Castings

Vermont Castings CSVF20SNV Handbuch

Vermont Castings

Vermont Castings Encore 2550 Handbuch

Vermont Castings

Vermont Castings Encore 1450 Montageanleitung

Vermont Castings

Vermont Castings 2115 Bedienungsanleitung

Vermont Castings

Vermont Castings The Aspen 1920 Montageanleitung

Vermont Castings

Vermont Castings Encore Flexburn 2040 Montageanleitung

Vermont Castings

Vermont Castings The Intrepid II 1990 Bedienungsanleitung

Vermont Castings

Vermont Castings The Aspen 1920 Montageanleitung

Vermont Castings

Vermont Castings The Intrepid II 1990CE Montageanleitung

Vermont Castings

Vermont Castings Encore 1450CE Kurzanleitung

Vermont Castings

Vermont Castings Resolute Acclaim 2490 Montageanleitung

Vermont Castings

Vermont Castings Defiant 1610 Bedienungsanleitung

Vermont Castings

Vermont Castings Encore 2550 Bedienungsanleitung

Vermont Castings

Vermont Castings SSW30FTAL Montageanleitung

Vermont Castings

Vermont Castings Encore 1450 Montageanleitung

Vermont Castings

Vermont Castings Defiant 1945 Bedienungsanleitung

Vermont Castings

Vermont Castings Aspen C3 Bedienungsanleitung

Vermont Castings

Vermont Castings Intrepid II Montageanleitung

Vermont Castings

Vermont Castings Resolute Acclaim 2490 Montageanleitung

Vermont Castings

Vermont Castings Encore 2044-CAT-C Bedienungsanleitung

Vermont Castings

Vermont Castings Defiant Bedienungsanleitung

Beliebte Holzofen Handbücher anderer Marken

Plamen

Plamen ECO MINIMAL 50 Bedienungsanleitung

RAIS

RAIS 800 Bedienungsanleitung

Henley

Henley Arklow Bedienungsanleitung

Jøtul

Jøtul F 500 Bedienungsanleitung

Englander

Englander BLUE RIDGE 100 Bedienungsanleitung

WoodPro

WoodPro WS-TS-1500 Bedienungsanleitung

Contura

Contura C 586W Bedienungsanleitung

Nordpeis

Nordpeis N-20 T Bedienungsanleitung

Palazzetti

Palazzetti EVA Konfigurationshandbuch

Lopi

Lopi 1250 Republic Bedienungsanleitung

Panadero

Panadero CAPRI 3V Programmierhandbuch

RAIS

RAIS RONDO 92 Bedienungsanleitung

RAIS

RAIS attika NEXO 100 GAS Bedienungsanleitung

ADURO

ADURO 15-3 Benutzerhandbuch

Pacific energy

Pacific energy SUPER 27 SPECTRUM Bedienungsanleitung

Avalon

Avalon Olympic 11190 Bedienungsanleitung

Ventis

Ventis HES350 Bedienungsanleitung

IronStrike

IronStrike Striker S160GL Bedienungsanleitung