1.5. UCW Rear Wing Kit Components
1.5.1. UCW Rear Wing Assembly
1.5.2. (2) Upright
1.5.3. (1) Trunk Mount - Left
1.5.4. (1) Trunk Mount - Right
1.5.5. (2) Carbon Endplate
1.5.6. Hardware Bag
1.5.6.1. (2) Spacer - M6, 11mm Long - Aluminum
1.5.6.2. (2) Spacer - M6, 8mm Long - Aluminum
1.5.6.3. (4) M6 x 1.0, 35mm Long BHCS (Button Head Cap Screw), Stainless
1.5.6.4. (8) M6 x 1.0, 18mm OD Fender Washer
1.5.6.5. (4) M6 x 1.0, 20mm Long BHCS, Stainless
1.5.6.6. (20) M6 x 1.0, 12mm OD Flat Washer
1.5.6.7. (12) M6 x 1.0, Nyloc Nut
1.5.6.8. (4) M6 x 1.0, 25mm Long BHCS
1.5.6.9. (4) Machined Aluminum Endplate Washer
1.5.6.10. (4) Buna-N O-Ring, #013
1.5.6.11. (4) M4 x 0.7 FHCS (Flat Head Cap Screw) x 16mm Long, Stainless
1.5.6.12. (1) VHB Double Sided Tape - Left
1.5.6.13. (1) VHB Double Sided Tape - Right
1.5.6.14. (1) Drill Template, Paper
2. UCW Rear Wing Install
2.1. Verus Engineering is not responsible for damage to you or your vehicle by following this
manual and/or installing Verus Engineering products.
2.2. We begin by gaining access to the trunk. You can leave the trunk on car during the install
but removing the trunk is also quite easy. We decided to keep the trunk installed on the car.
