Vestfrost FC310AL Bedienungsanleitung
FZ ... M
NL Gebruiksaanwijzing
ES Instrucciones para el uso
CZ Návod k použití
PL Instrukcja obsługi
RUS Инструкция по эксплуатации
UK Instructions for use
DE Bedienungsanleitung
FR Mode d’emploi
DK Brugsanvisning
NO Bruksanvisning
2
UK
Thank you for purchasing your new fridge/
freezer from Vestfrost. Please note that
these instructions apply to all fridge/freezers
in the FZ range. Illustrations and fittings
may therefore not necessarily correspond
exactly to your model.
Warning
As the refrigerant used in this appliance is a
flammable gas (Isobutane R600a), special
care must be taken to prevent damage
to the refrigerant circuit and piping during
transport and installation.
If damage does occur, avoid sparks or
naked flame in the vicinity of the appliance,
ensure that the room is well ventilated,
disconnect the power supply, and contact
your supplier.
The unit must only be serviced by qualified
technicians from an approved service
centre.
Old appliances
Old refrigerators and freezers are often
fitted with complicated latches that can
only be opened from the outside. If you
have one of these old units stored away
somewhere, or if you scrap one, remember
to destroy the latch first in order to prevent
children from being exposed to danger by
getting locked inside the unit.
Before use
Before operating your new appliance,
please read the following instructions
carefully as they contain important
information on safety, installation, operation
and maintenance. Keep the instructions for
future reference.
On receipt, check to ensure that the
appliance has not been damaged during
transport. Transport damage should be
reported to the local distributor before the
appliance is put to use.
Remove the packaging. Clean the inside of
the cabinet using warm water with a mild
detergent. Rinse with clean water and dry
thoroughly (see cleaning instructions). Use
a soft cloth.
If during transport the appliance has been
laid down, or if it has been stored in cold
surroundings (colder than +5°C), it must be
allowed to stabilise in an upright position for
at least an hour before being switched on.
Contents
Get to know your fridge/freezer.........3
Installation and start-up.....................4
Reversing the doors..........................8
Electrical connection.........................9
Operation and function....................10
Refrigerator section........................12
Freezer section...............................13
Cleaning and maintenance.............15
Fault finding....................................16
Warranty, spare parts and service..17
Disposal..........................................18
3
UK
Get to know your fridge/freezer
fig. 1
Control panel
Lighting
Shelf with storage boxes
Door shelf
Bottle rack
Large storage box
Glass shelf
Nameplate
Crisper bins
Freezing tray
Sealing strip
Freezer drawers
Door handle
Defrost water drain
Kick plate
Adjustable feet
4
UK
Placement
For safety and operational reasons, the
appliance must not be installed outdoors.
The appliance should be placed on a level
surface in a dry, well ventilated room (max.
75% relative air humidity). Never place the
appliance close to sources of heat such as
cookers or radiators, and avoid placing it in
direct sunlight.
Room temperature
The climate class is stated on the
nameplate (see fig. 1 on page 3 and fig. 17
on page 13). This specifies the optimum
room temperature.
Climate class Optimum room
temperature
SN +10 ºC to +32 ºC
N +16 ºC to +32 ºC
ST +18 ºC to +38 ºC
T +18 ºC to +43 ºC
Installation
The surface on which the appliance is to be
placed must be level. Do not use a frame or
similar.
The appliance can be installed as a free-
standing unit against a wall, built into a
kitchen element, or lined up with other
appliances (figs 2 and 3).
600 600
600 600
600 600
600 600
fig. 2
fig. 3
Installation and start-up
5
UK
650
30 25
fig. 2b
fig. 3b
Special considerations for
climate class ST
When building in the appliance where room
temperature exceeds +32 °C (climate class
ST), there must be at least 25 mm free
space to the right and left of it. In addition,
there must be 100 mm free space above
the appliance (see fig. 2b).
When setting up domestic appliances
side-by-side, there must be at least 30
mm between them, 25 mm between such
appliances and other kitchen elements and
100 mm above the appliances (see fig. 3b).
6
UK
Ventilation
It is important that the appliance be
well ventilated and that air can circulate
unhindered above, below and around it. The
figures below illustrate how the necessary
air circulation can be ensured (figs 6 and
7). If two fridge/freezers are placed side
by side, there must be at least 30 mm
clearance between them.
1650/1950
100
100
1560/1860
fig. 6 fig. 7
The appliance
viewed from above
If the appliance is placed beside a wall,
there must be sufficient room for the freezer
door to be opened wide enough to allow the
drawers to be pulled out (fig. 4).
600
610
fig. 4
Fitting the tilt-stop
A tilt-stop can be fitted to prevent the
unit from tilting forwards when the door
is opened. Mount the tilt-stop on the wall
behind the appliance 80-100 mm from the
left or right side of the appliance depending
on the side on which the door is hinged.
The tilt-stop must always be fitted on the
side opposite to the hinge (fig. 5).
80 - 100 mm
fig. 5
7
UK
Setting up
It is important that the appliance be
absolutely level. To level the appliance,
remove the kick plate below the door and
screw the adjustable feet up or down (figs
8 and 9). Use a spirit level to check that the
appliance is absolutely level.
If the appliance is to be placed on a soft
surface, e.g. floorboards or a carpet, it is
best to recheck whether the appliance is still
level after a period of time as the underlying
surface may give under the weight of the
appliance.
fig. 8
fig. 9
8
UK
Reversing the doors
The doors can be changed from right-hinged to left-hinged and vice versa as follows:
1. Lay the appliance on its back with the
doors uppermost.
8. Opposite the hinge, there are two
screws covered by plastic caps.
Remove the caps and screws.
13. Refit the kick plate
14. Adjust the lower hinge and tighten.
2. Remove the upper hinge.
3. Move the plastic plugs to where the
upper hinge was fitted.
4. Lift off the upper door and lay it aside.
9. Turn the central bridging plate and insert
the pins into the slots on the opposite side.
10. Refit the screws and plastic caps.
15. Fit the lower door and attach the
middle hinge.
16. Adjust the hinge and tighten.
5. Remove the door-closer and refit it on
the opposite side.
11. Remove the kick plate by pulling it
outwards and upwards.
17. Fit the upper door.
18. Keep the door-closer to the left.
19. Fit the upper hinge.
6. Remove the middle hinge by unscrewing
the screws.
7. Lift off the lower door and lay it aside.
12. Remove the screws holding the lower
hinge in place. Turn the pin on which
the door was mounted so that it points
in the opposite direction. Rotate the
hinge through 180° and refit it on the
opposite side of the appliance.
20. Remove the door handles and refit
them on the opposite side. Refit the caps.
21. The appliance must be allowed to
stabilise in an upright position for at least
1 hour before being switched on.
22. After reversing the door(s), it is important to check that the sealing strip provides a tight seal all the way round.
If it does not, carefully heat the strip all the way round using a hair dryer. Then ease the strip outwards slightly so that it forms a tight
seal against the cabinet.
Be careful not to heat the strip so much that it melts!
9
UK
The appliance is intended for connection
to alternating current. The required voltage
(V) and frequency (Hz) are stated on the
nameplate inside the appliance. Power
must be connected via an independent wall
socket outlet.
If the mains lead has been damaged, it
must be replaced with a corresponding
type supplied by the manufacturer or an
approved service centre.
Technical data
This appliance complies with CE marking
regulations, directives and standards.
Low Voltage Directive 73/23/EEC.
EMC Directive 89/336/EEC.
Council Directive 92/75/EEC on the energy
labelling of household appliances as
subsequently amended by 94/2/EC and
2003/66/EC.
Directive 96/57/EC on energy efficiency
requirements, and subsequent
amendments.
Electrical connection
10
UK
Electronic controls
The appliance is factory set to maintain
+5°C in the refrigerator section and -18°C
in the freezer section. Following any power
failure, these settings are automatically
recalled.
After switching the appliance on, it takes a
few hours before the correct temperatures
are achieved. During this period, the control
lamp flashes red and the acoustic alarm is
heard. It is therefore a good idea to switch
off the sound. To do so, press the alarm
button .
The electronic controls have the following
functions:
• On/off function
• Temperature setting
• Temperature display
• Automatic defrosting of refrigerator
section
• Automatic defrosting of freezer
section (frost-free models only)
• Super Freeze
• Acoustic and visual alarms
• Fault-finding, emergency and
service programs
On/off switch
Button for displaying and setting
refrigerator temperature
Button for displaying and setting
freezer temperature
Display showing temperature
Button for switching off the alarm
Super Freeze button
Control lamp
Four-star freezer symbol
Freezer temperature
Refrigerator temperature
Alarm on/off
Super Freeze
On/off switch
Concealed door switch
Display
Operation and function
fig. 12
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Vestfrost Kühlschrank Handbücher
Vestfrost
Vestfrost VR-BB27612H0S Bedienungsanleitung
Vestfrost
Vestfrost CW 286 W Bedienungsanleitung
Vestfrost
Vestfrost VW18LFM00W Bedienungsanleitung
Vestfrost
Vestfrost VCF 10186-L Bedienungsanleitung
Vestfrost
Vestfrost BBR150 Bedienungsanleitung
Vestfrost
Vestfrost VC 1084 TT Bedienungsanleitung
Vestfrost
Vestfrost CW 375 M Bedienungsanleitung
Vestfrost
Vestfrost R-90i Bedienungsanleitung
Vestfrost
Vestfrost R-90i Bedienungsanleitung
Vestfrost
Vestfrost CW250-2R Bedienungsanleitung
Vestfrost
Vestfrost VCF 14179 X FD NoFrost Bedienungsanleitung
Vestfrost
Vestfrost VW719FFE00B Bedienungsanleitung
Vestfrost
Vestfrost SW 330MW A+ Bedienungsanleitung
Vestfrost
Vestfrost VCF 13186 NoFrost Bedienungsanleitung
Vestfrost
Vestfrost VFC252 Bedienungsanleitung
Vestfrost
Vestfrost VW18NFE01B Bedienungsanleitung
Vestfrost
Vestfrost VR-FB373-2E1BG Bedienungsanleitung
Vestfrost
Vestfrost VIUC 1082 Bedienungsanleitung
Vestfrost
Vestfrost FW M Series Bedienungsanleitung
Vestfrost
Vestfrost VW18NFE00W Bedienungsanleitung
Beliebte Kühlschrank Handbücher anderer Marken
Bonnet Neve
Bonnet Neve SKYVIEW PLUS Bedienungsanleitung
Zanussi Electrolux
Zanussi Electrolux ZERB 8441 Bedienungsanleitung
Sharp
Sharp SJ-BA31IEXW2-EU Bedienungsanleitung
CORBERO
CORBERO CC2300MCW Bedienungsanleitung
KitchenAid
KitchenAid 2205264 Bedienungsanleitung
Stengel
Stengel KU 1101 A++ Bedienungsanleitung
