Vinotemp WineMate VINO1500CD Bedienungsanleitung

WINE-MATE Cooling Unit

Use & Care Manual

VINO1500CD, CTED

VINO2500CD, CTED

- 1 -

Important Safety Information

•DO NOT PLUG IN UNTIL 24 HOURS AFTER DELIVERY.

•DO NOT USE A GROUND FAULT INTERRUPTER (GFI).

•A DEDICATED 15 AMPCIRCUIT IS HIGHLY RECOMMENDED.

- 2 -

TABLE OF CONTENTS

Feature Description…………………………….……………..3

Installation Instruction………………………………………..5

Temperature Control & Humidity Adjustment………….9

Care Guide……………………………………………………13

Troubleshooting……………………………………………..14

Wiring Diagram……………………………………….………17

Customer Support……………………………………………18

Warranty……………………………………………………….19

- 3 -

Feature Description

•VINO1500CD, CTED and VINO2500CD, CTED cooling units are designed

and used to provide a subtle temperature between 50~65 °F for suitable

space at a normal environment.

•The refrigerated space will maintain humidity of 50~70% RH even when

the environment becomes dry and humid.

•These temperatures and humilities are optimized for long term storage of

wine.

•Bottom cold-air supply is optimized for use in the wine cabinets.

•Multiple options for top and rear hot air exhaust

•Self-contained ready for use and easy for installation

Fig. 1.1 FEATURES

- 4 -

Fig. 1.2 DIMENSIONS (in)

The dimension and capacity are specified as follows:

Model Exhaust Cooling

Capacity, CFM

55°F/ 75°F

Bottle

Capacity

55°F/ 75°F Electrical Weight

1500cd Rear Exhaust 1500 Btu/h,

120 CFM 150

cu ft 800

bottles 115V/60Hz

4A 50 lb

1500cted Top Exhaust 1500 Btu/h,

120 CFM 150

cu ft 800

bottles 115V/60Hz

4A 50 lb

2500cd Rear Exhaust 2500 Btu/h,

180 CFM 250

cu ft 1200

bottles 115V/60Hz

5A 55 lb

2500cted Top Exhaust 2500 Btu/h,

180 CFM 250

cu ft 1200

bottles 115V/60Hz

5A 55 lb

•See the voltage, frequency and current specified on the label at the

cooling unit.

- 5 -

Installation Instruction

1. Cabinet Location

•Place the wine cabinet in a properly ventilated location. Otherwise, heat

exhausted by the cooling unit will build up and it will not operate properly.

•The exhaust area must not be a closed space and must be ventilated. The

ambient temperatures shall not be higher than 90 °F or lower than 50 °F.

1) Rear Exhaust Location

•Leave min 6 “clearance from the rear to the wall.

•Leave min 12” clearance from the top to the ceiling.

•Leave min 6” clearance from the left and right sides.

2) Front Exhaust Location

•Leave min 6” clearance from the front if left and right sides unobstructed.

•Or, leave min 36” clearance from the front if left and right sides obstructed

3) Top Exhaust Location

•Leave min 12” from the top to the ceiling.

•Leave min 2 “clearance from the rear to the wall.

•Leave min 2” clearance from the left and right sides.

4) Side Exhaust Location

•Leave min 6 “clearance from the left or right side to the wall.

•Leave min 12” clearance from the top to the ceiling.

2. Cooling Unit Installation

•The cooling unit produces cooling supplied into the cabinet, and it also

generates heat that must be exhausted outside the cabinet. So the supply

side and exhaust side must be separated and sealed (see Fig. 2.1).

•Cut a rectangular inside opening at the rear of the cabinet with the 1/4”

clearance inwards to the width and height of the cooling unit. By not going

through, leave 1/2” lip inside at the wall to place the gaskets (see Fig. 2.2).

•If top exhaust, cut another rectangular opening at the top of the cabinet to

the length and width of the top exhaust (see Fig.2.2).

•Make 2 holes at the ceiling to install the 1/4 inside diameter wood thread

inserts (see Fig.2.2).

•Place the gaskets (1/2” foam tape)on the gasket lips (see Fig 2.1).

•If top exhaust, place another gaskets along the top exhaust at the top of

the cooling unit (see Fig.2.3).

•Move the cooling unit towards the mounting sides and push to press the

gaskets.

•Fasten the 2 brackets and use 7/16” wrench to tighten the two ¼” screws

(see Fig 2.1).

- 6 -

•Attach the exhaust and fresh air grille with screws from the rear side of the

cabinet.

•If top exhaust, install another top exhaust grille at the top of the cabinet.

•Plug the cooling unit in receptacle.

•Plug the wine cabinet.

Fig. 2.1 COOLING UNIT MOUNTING

- 7 -

Fig. 2.2 MOUNTING CUTOUT & GASKET LIPS

Fig. 2.3 TOP EXHAUST GASKET

NOTES:

1) DO NOT INSTALL ANY DUCTS ONTO THE SUPPLY, INTAKE ANY

EXHAUST.

2) MOUNTING BRACKETS, SCREWS, GASKETS AND OTHER SEAL

MATERIALS ARE NOT INCLUDED.

- 8 -

2. Electrical Cord

•We strongly recommend against the use of an extension cord. However, if

you still select to use an extension cord, it is absolutely necessary that it is

a UL LISTED 3-wire grounding type appliance extension cord. The

marked rating of the extension cord shall be 115 V, 15 A. or equivalent

and not greater than 15ft in length.

- 9 -

Temperature Control & Humidity Adjustment

1. Temperature Setting

•Set the temperature at 55 °Ffor the optimum aging of wine

•On initial start-up, the time required to reach the desired temperature

will vary, depending on the quantity of bottles, temperature setting

and surrounding temperature.

•Allow 24 hours to stabilize the temperature for each new temperature

setting operation

2. Use of the controller

Fig. 3.1 DIGITAL CONTROLLER

1) Display

During normal operating conditions, the display shows the value measured by

the air regulation probe. In case of active alarm, the temperature flashes

alternately to the code alarm.

1.1 LED Functions

1.2 Front Panel Commands

Andere Handbücher für WineMate VINO1500CD

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Vinotemp Küchengerät Handbücher

Vinotemp

Vinotemp Designer VT-DS26SB149 Bedienungsanleitung

Vinotemp

Vinotemp VT-BD Bedienungsanleitung

Vinotemp

Vinotemp element EL-300COMM Bedienungsanleitung

Vinotemp

Vinotemp VT-PARTYCOOLER Bedienungsanleitung

Vinotemp

Vinotemp VT-12TEDi Bedienungsanleitung

Vinotemp

Vinotemp Element EL-12TEDCS Bedienungsanleitung

Vinotemp

Vinotemp element EL-168COMM Bedienungsanleitung

Vinotemp

Vinotemp Element EL-30SWCB2D Bedienungsanleitung

Vinotemp

Vinotemp VT-VC130RGS Bedienungsanleitung

Vinotemp

Vinotemp element EL-168WCGM Bedienungsanleitung

Vinotemp

Vinotemp Element EL-32COMM-B Bedienungsanleitung

Vinotemp

Vinotemp VT-155SBB Bedienungsanleitung

Vinotemp

Vinotemp ELEMENT EL-BWC30TB-S Bedienungsanleitung

Vinotemp

Vinotemp WINE-MATE WM-2500HZD Gebrauchsanweisung

Vinotemp

Vinotemp element EL-24WCUB Bedienungsanleitung

Vinotemp

Vinotemp VT-BD Bedienungsanleitung

Vinotemp

Vinotemp WINE-MATE WM-3500HZD Bedienungsanleitung

Vinotemp

Vinotemp WINE-MATE WM-1500SLIM Gebrauchsanweisung

Vinotemp

Vinotemp element EL-40WCST Bedienungsanleitung

Vinotemp

Vinotemp VT-12TEDi Bedienungsanleitung

Vinotemp

Vinotemp element EL-WCU101-03 Bedienungsanleitung

Vinotemp

Vinotemp VT-122TS-2Z Bedienungsanleitung

Vinotemp

Vinotemp VT-DS300SS-2Z Bedienungsanleitung

Vinotemp

Vinotemp element EL-168COMML Bedienungsanleitung

Beliebte Küchengerät Handbücher anderer Marken

Tayama

Tayama TYG-35AF Bedienungsanleitung

AEG

AEG 43172V-MN Bedienungsanleitung

REBER

REBER Professional 40 Benutzerhandbuch

North American

North American BB12482G / TR-F-04-B-NCT-1 Bedienungsanleitung

Presto

Presto fountain popper Bedienungsanleitung

Westmark

Westmark 1035 2260 Bedienungsanleitung

Zanussi

Zanussi ZCG64396XA Bedienungsanleitung

HOFFEN

HOFFEN SM-9302M Bedienungsanleitung

Philips

Philips HD3133 Bedienungsanleitung

Ronco

Ronco Beef Jerky Bedienungsanleitung

Hendi

Hendi 470411 Bedienungsanleitung

Livoo

Livoo MEN386 Bedienungsanleitung

croydon

croydon WR-10313-700 Bedienungsanleitung

Chefman

Chefman RJ43-SQ Series Bedienungsanleitung

Vacmaster

Vacmaster VP680 Bedienungsanleitung

Jetmaster

Jetmaster 900HG Bedienungsanleitung

Küppersbusch

Küppersbusch EEH 610.0 Kurzanleitung zur Einrichtung

HURAKAN

HURAKAN HKN-F10 Bedienungsanleitung