Vintec V40bvc Bedienungsanleitung

______________________________________________

INSTRUCTION MANUAL - BEVERAGE CENTRE

V40BVC

______________________________________________

WARNING

•To prevent damage to the door gasket, make sure you have the door fully open when pulling

shelves out of the compartment.

•The appliance must be positioned so that the plug is accessible. Release the electric cord. Move

your cabinet to its final location. Do not move your cabinet while loaded with wine as it will distort

the body. The beverage centre should be installed in a suitable place in order to avoid touching

the compressor with the hand. If the supply cord is damaged, it must be replaced by an ap-

proved service agent to ensure correct installation.

Important Safety Instructions

Warning

To reduce the risk of ﬁre, electrical shock, or injury

when using your appliance, follow these basic pre-

cautions

•Read all instructions before using the Beverage centre

•DANGER OR WARNING: Risk of child entrapment. Child entrapment and suffocation are

not problems of the past. Junked or abandoned appliances are still dangerous ... even if they

will “just sit in the garage for a few days”

•Before you throw away your old Beverage centre: Take off the door, Leave the shelves in

place so that children may not easily climb inside

•Never allow children to operate, play with, or crawl inside the appliance.

•Never clean appliance parts with ﬂammable ﬂuids. The fumes can create a ﬁre hazard or ex-

plosion.

•Do not store or use gasoline or any other ﬂammable vapors and liquids in the vicinity of this or

any other appliance. The fumes can create a ﬁre hazard or explosion.

>> Save these instructions <<

Installation Instructions

Before Using Your Beverage Centre

★Remove the exterior and interior packing.

★Before connecting the Beverage centre to the power source, let it stand upright for

approximately 2 hours. this will reduce the possibility of a malfunction in the cooling

system from handling during transportation.

★Clean the interior surface with lukewarm water using a soft cloth.

Installation of your Beverage centre

★This appliance s designed to be free standing installation or build-in (fully recessed)

★Place your Beverage centre on a floor that is strong enough to support it when it is fully

loaded. To level your Beverage Centre, adjust the leveling legs of the Beverage

centre until it is balanced.

★Locate the Beverage centre away from direct sunlight and sources of heat (stove,

heater, radiator, etc) Direct sunlight may affect the acrylic coating and heat sources

may increase electrical consumption. Extreme cold ambient temperatures may also

cause the unit not to perform properly.

★Avoid locating the unit in moist areas.

★Plug the Beverage centre into an exclusive, properly installed - grounded power outlet.

Do not under any circumstances cut or remove the third (ground)prong from the power

cord. Any questions concerning power and/or grounding should be directed toward a

certified electrician or an authorised service agent.

Reversing the Door Swing of Your Appliance

This appliance has reversible doors but is delivered with a right hinged door. The left hand hinge kit

comes with the unit (in the box) should you wish to opposite hinge your unit.

1. Lock Screws 2. Lower Hinge (right 3. Door axis

4. To hinge (right) 5. Door 6. Cabinet

7. Top hinge (left) 8. Lower hinge (left)

•Rescrew the Lock screws (1) please see picture 1.

•Pull the door (5) outward, take it out (please see picture 2.)

•Screw off 3 pcs bolts, take out the top hinge (right) 4. (please see picture 3)

Fix the top hinge (left) with bolts on the position as picture shows, then install the door as the

way it pulls out, then steps finish (please see picture 4)

Attention

•Store wine in sealed bottles

•Do not overload the cabinet

•Do not open the door unless necessary

•Do not cover shelves with aluminium foil or any other shelf material which may prevent air circu-

lation.

•Should the beverage centre be stored without use for long periods, it is suggested, after a careful

cleaning, to leave the door ajar to allow air to circulate inside the cabinet in order to avoid possi-

ble formation of condensation, mold or odors.

Operating your Beverage Centre

The Beverage centre should be placed in an area where the ambient temperature is between 0 -

38oC. If the ambient temperature is above or below this range, the performance of the unit may be

affected. For example, placing your unit in extreme cold or hot conditions may cause interior tem-

peratures to fluctuate and therefore required temperature may not be reached.

RUN

Indicator light illuminates to signify the cooling mode is currently in operation

Light

To control the inner light turn on/off

Power

To control this appliance turn on/off

“Up” Button

Used to raise (warm) the temperature in 1oC.

“Down” Button

Used to lower (cool) the temperature in 1oC.

“Display”

To show the temperature of the internal cabinet.

Setting the Temperature Control

•To set the temperature:

Connect the power cord to a properly grounded outlet. In the event of a power interruption, all

previous temperature settings are automatically erased and it will default to a preset temperature

setting of 5oC.

•Set the desired cooling temperature by pressing the buttons adjacent to the “Up/Down” program.

Each depression of the buttons will scroll through the available temperature settings in incre-

ments of 1 degree. The temperature selected will flash in the LED display for approximately 5

seconds, then revert back to display the temperature of the internal cabinet. The temperature

setting can be adjusted from 2 to 10 degrees.

Shelves

•To prevent damaging the door gasket, make sure you have the door fully opened when pulling

shelves out of the compartment.

•For easy access to the contents, you must pull the shelves approximately 1/3 out of the com-

partment, however this unit was designed with a notch on each side of the shelf tracks to prevent

bottles from falling.

•When removing any of these shelves out of the compartment, you must first unscrew the Phillips

screws and remove both of the plastic posts which hold the shelves in place.

Note

•If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting

the unit. If you attempt to restart before this time delay, the Beverage centre will not start.

•When you use the beverage centre for the first time or restart the beverage centre after having

been shut off for a long time, there could be a few degrees variance between the temperature

you select and the one indicated on the LED readout. This is normal and it is due to the length of

the activation time. Once the beverage centre is running for a few hours everything will be back

to normal.

CARE AND MAINTENANCE

Cleaning your Beverage Centre

•Turn off the power, unplug the appliance, and remove all items including shelves and rack.

•Wash the inside surfaces with a warm water and baking soda solution. The solution should be

about 2 tablespoon of baking soda to a quart of water.

•Wash the shelves with a mild detergent solution.

•Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electri-

cal parts.

•Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry

and a clean soft cloth.

Power Failure

•Most power failures are corrected within a few hours and should not affect the temperature of

your appliance if you minimise the number of times the door is opened. If the power is going to

be off for a longer period of time, you need to take the proper steps to protect your contents.

Vacation Time

•Short Vacations: Leave the Beverage Centre operating during vacations of less than three

weeks.

•Long Vacations: If the appliance will not be used for several months, remove all items and turn

off the appliance. Clean and dry the interior thoroughly. To prevent odor and mold growth, leave

the door open slightly - blocking it open if necessary.

Moving Your Beverage Centre

•Remove all items

•Securely tape down all loose items (shelves) inside your appliance.

•Turn the adjustable leg up to the base to avoid damage.

•Tape the door shut.

•Be sure the appliance stays secure in the upright position during transportation. Also protect out-

side of appliance with a blanket, or similar item.

Energy Saving Tips

•The Beverage Centre should be located in the coolest area of the room, away from heat produc-

ing appliances, and out of the direct sunlight.

V40 Series - Under Bench Installation Instructions

1. Cabinet dimensions: H 820 x W 595 x D 572 mm

2. Please note that a minimum cut out of 615mm is required to facilitate installation, removal

and servicing.

3. This cabinet requires 1cm clearance on both sides and top, 4 cm clearance at the rear. A

ventilation grid is required (see above diagram for positioning of grid)

4. This cabinet is front venting - if kick board is to be used it will need a grille to allow adequate

in and out flow of air.

5. The power point should be offset for easy access.

6. The diagram below shows details of vent and door measurements.

You can solve many common Beverage Centre problems easily, saving you the cost of a possible

service call, Try the suggestions below to see if you can solve the problem before calling the serv-

icer.

TROUBLESHOOTING GUIDE

PROBLEM

POSSIBLE CAUSE

Beverage Centre does not operate

Not plugged in

The appliance is turned off

The circuit breaker tripped or a blown fuse

Beverage Centre is not cold enough

Check the temperature control setting

External environment may require a higher setting

The door is opened too often

The door is not closed completely

The door gasket does not seal properly

Turns on and off frequently

The room temperature is hotter than normal

A large amount of contents has been added to the beverage

centre

The door is opened too often

The door is not closed completely

The temperature control is not set correctly

The door gasket does not seal properly

The light does not work

Not plugged in

The circuit breaker tripped or a blown fuse

The bulk has burned out

The light button is “Off”

Vibrations

Check to assure that the Beverage Centre is level

The Beverage Centre seems to make

too much noise

The rattling noise may come from the ﬂow of the refrigerant,

which is normal

As each cycle ends, you may hear gurgling sounds caused by

the ﬂow of refrigerant in your Beverage centre

Contraction and expansion of the inside walls may cause pop-

ping and crackling noises

The Beverage centre is not level

The door will not close properly

The Beverage centre is not level

The door was reversed and not properly installed

The gasket is dirty

The shelves are out of position.

Inhaltsverzeichnis

Andere Vintec Weinkühler Handbücher

Vintec

Vintec VWS050SBB-X Bedienungsanleitung

Vintec

Vintec VWM198PBA-R Bedienungsanleitung

Vintec

Vintec VWCM149FAB Bedienungsanleitung

Vintec

Vintec VWS121SCA Series Bedienungsanleitung

Vintec

Vintec V30SG e Bedienungsanleitung

Vintec

Vintec VWS035SBA-X Bedienungsanleitung

Vintec

Vintec VWM306SBA-R Bedienungsanleitung

Vintec

Vintec VWS020SBA-X Bedienungsanleitung

Vintec

Vintec V110SG e Series Bedienungsanleitung

Vintec

Vintec V20BVCBK Bedienungsanleitung

Vintec

Vintec ESPACE Series Bedienungsanleitung

Vintec

Vintec VWS035SCA-X Bedienungsanleitung

Vintec

Vintec V300SGe Bedienungsanleitung

Vintec

Vintec V110SGe-S3 Bedienungsanleitung

Vintec

Vintec V190SG2E-BK Bedienungsanleitung

Vintec

Vintec V30 Bedienungsanleitung

Vintec

Vintec 40BVC Bedienungsanleitung

Vintec

Vintec VWS050SBA-X Bedienungsanleitung

Vintec

Vintec V30SGME Bedienungsanleitung

Vintec

Vintec V26SG e SS/S3 Bedienungsanleitung

Vintec

Vintec V20SGEBK Bedienungsanleitung

Vintec

Vintec VWM148SBA Bedienungsanleitung

Vintec

Vintec V190SG2e BK Bedienungsanleitung

Vintec

Vintec VBS020SBA-X Bedienungsanleitung

Beliebte Weinkühler Handbücher anderer Marken

U-Line

U-Line Echelon Wine Captain 2075WC Betriebsanleitung

Haier

Haier WS50GA Bedienungsanleitung

Cavist

Cavist 62 Bedienungsanleitung

Kenmore

Kenmore 461.99130 Bedienungsanleitung

Miele

Miele KWT 6422 iG Bedienungsanleitung

Danby

Danby DWC113BLSDB Bedienungsanleitung

Caple

Caple Wi6128 Bedienungsanleitung

Avanti

Avanti WC1001 Bedienungsanleitung

Frigidaire

Frigidaire FFWC38F6LS Bedienungsanleitung

Titan

Titan TT-W2454SZ Installationshandbuch

Klarstein

Klarstein Botella 166 Uno Bedienungsanleitung

Costway

Costway FP10130WL Bedienungsanleitung

Lemair

Lemair LWC59 Bedienungsanleitung

Haier

Haier JC-125GEA Bedienungsanleitung

Caple

Caple WCi46B Bedienungsanleitung

Climadiff

Climadiff CLI24 Kurzanleitung

Viking

Viking VCWB301LSS Bedienungsanleitung

Caple

Caple WC6511 Bedienungsanleitung

Vintec v40bvc Bedienungsanleitung

Beliebte Weinkühler Handbücher anderer Marken