Volt VDL-600 Series Bedienungsanleitung

VOLT®Low Voltage Landscape Lighting

VOLT® Deck Light Cast Brass

VDL-600 and VDL-6000 Series

INSTALLATION INSTRUCTIONS

Specications and product details subject to change without notice.

reserved. [email protected] • 813.978.3700

Help Hotline:

1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)

VOLT®Deck Light Cast Brass

VDL-600 and VDL-6000 Series

INSTALLATION INSTRUCTIONS

www.voltlighting.com [email protected] • 813.978.3700

Package Contents

A. (1) Luminaire

B. (2) Lock Screws

Product Dimensions

Pro Technique for Hiding Lead Wire

Pro Technique for Hiding Splice Connections

Important: Please Read Before Installation

IMPORTANT SAFETY INFORMATION

This luminaire is intended for installation in accordance with local codes and the

National Electric Code (NEC). Failure to adhere to these codes and instructions may

result in serious injury, property damage and void the warranty.

These instructions do not intend to cover all variations in installation, operation

maintenance or mounting situations.

1. Make sure that the power is turned OFF before installing or servicing this

luminaire.

2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M) or more

from pool, spa or fountain.

3. This luminaire is intended to be used only with a power supply (transformer) rated

maximum of 300 watts (25 AMPS) at 15 volts.

4. Wiring connections must be made with wire connectors that are suitable for

outdoor use.

5. Position the low voltage wire and wire connector so that it is located within 6

inches (15.2 cm) from a building structure, a luminaire or tting.

6. The main low voltage cable is intended for shallow burial - less than 6 inches (152

mm).

7. If additional lengths of low voltage cable are required, please contact www.

voltlighting.com or call 1-813-978-3700.

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS

Lighted lamp is HOT!

WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.

1. Turn off/unplug and allow to cool before replacing lamp.

2. Lamp gets HOT quickly! Contact only switch/plug when turning on.

3. Do not touch the hot lens, guard or enclosure.

4. Keep lamp away from materials that may burn.

5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may damage

lamp.

6. Do not operate the luminaire tting with a missing or damaged shield.

SAVE THESE INSTRUCTIONS

2”

2 1/4”

3 3/8”

Determine the location for the xture. Drill a hole straight through

the desired mounting location and run the lead wire out the

backside of the location so that the wires are not visible from the

front side. Use a matching trim piece and cut a groove in the back

of trim. Cover the lead wires with the matching trim piece.

All xtures come with 4’ of lead wire enabling you to hide the splice

connections out of sight. If you must make a splice connection in view,

use an inline heat shrink style connection that is less visible than

traditional twist caps.

INSTALLATION INSTRUCTIONS

www.voltlighting.com [email protected] • 813.978.3700

VOLT®Deck Light Cast Brass

VDL-600 and VDL-6000 Series

Install Bulb

Install Lens Assembly

Insert the bulb with correct wattage and

type marked on the luminaire label.

CAUTION: Do not exceed maximum

wattage marked on luminaire label.

NOTE: DO NOT touch bulb with bare

hands. Use soft cloth to handle bulb.

Push the lens assembly back onto the

base aligned with the gaps on the

base. Push hard (moisture proof xture

requires force to get air out). Once the

lens assembly is ush with the base,

rotate the lens assembly until it stops

and locks into place.

Inner Shield

Luminaire

Base

Gap

Wire Connector

Main Supply Cable

Install/Replace Bulb

Rotate the lens assembly and then remove it to expose the bulb and replace

it with the correct wattage and type marked on the luminaire label. And

then reinstall the lens assembly.

IMPORTANT: Halogen bulbs must be protected from moisture and dust at all

times. Always reinstall lens assembly when moved.

Pigtail

Install Base

Base

Lock

Screw

Wall Anchor

Rotate the lens assembly counter

clockwise until it is stops and then

lift the lens assembly straight off.

Note: The rst time it may be

difcult because the luminaire has

a tight o-ring seal and a grease

sealant for moisture protection.

Attach the base onto the desired

location and secure with the lock

screws.

Note: Wall anchors are required for

certain installation conditions (e.g.

Brick wall, Concrete Wall, etc.).

Mark on the wall for wall anchors

from the holes on the base.

Remove the base and drill proper

holes on the wall and then insert

the wall anchors.

Remove Lens Assembly

Luminaire Lens Assembly

Base

Wire Connections

Strip both leads from the luminaire

pigtail. Using two wire connectors

(sold separately), connect the leads

from the luminaire to the main supply

cable leads.

Socket

Bulb

is-VDL-6XXX-ver5.pdf

Specications and product details subject to change without notice.

reserved. [email protected] • 813.978.3700

www.voltlighting.com

Help Hotline:

1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)

Dieses Handbuch passt für folgende Modelle

Andere Volt Landschaftsbeleuchtung Handbücher

Volt

Volt ShadowMaster VPL-1039 Series Bedienungsanleitung

Volt

Volt VFL-4602-BBZ Bedienungsanleitung

Volt

Volt VAL-2103-0-BBZ Bedienungsanleitung

Volt

Volt Guardsman VPL-1011 Bedienungsanleitung

Volt

Volt VPL-1041-4-BBZ Bedienungsanleitung

Volt

Volt VFL-4027 Bedienungsanleitung

Volt

Volt VFL-450X-BBZ Bedienungsanleitung

Volt

Volt VSDL-6013-BBZ Bedienungsanleitung

Volt

Volt Fat Boy Mini Spotlight Bedienungsanleitung

Volt

Volt VWL-510 Series Bedienungsanleitung

Volt

Volt VDL-6008-4-BBZ Bedienungsanleitung

Volt

Volt VSPL-9001-25-BBZ Bedienungsanleitung

Volt

Volt VPL-1001-4-BBZ Bedienungsanleitung

Volt

Volt Belladonna LED Path/Area Bedienungsanleitung

Volt

Volt VAL-2006-4-BBZ Bedienungsanleitung

Volt

Volt VFL-120V Series Bedienungsanleitung

Volt

Volt VSM-2407 Bedienungsanleitung

Volt

Volt VPL-1024 Bedienungsanleitung

Volt

Volt VWL-703-BBZ Bedienungsanleitung

Volt

Volt VWL-703 Bedienungsanleitung

Volt

Volt VAL-2049-35-4-BBZ Bedienungsanleitung

Volt

Volt VAL-91 Series Bedienungs- und Sicherheitshinweise

Volt

Volt VAL-1052-BBZ Bedienungsanleitung

Volt

Volt VPL-1002 Series Bedienungsanleitung

Beliebte Landschaftsbeleuchtung Handbücher anderer Marken

Intex

Intex SL1006 Bedienungsanleitung

LED Group

LED Group ROBUS R2IN13W Bedienungsanleitung

Patriot Lighting

Patriot Lighting 343-1484 Bedienungsanleitung

Hess

Hess SERA G: SERA S Bedienungsanleitung

LIGMAN

LIGMAN JET 44 Bedienungsanleitung

LIGMAN

LIGMAN MALTA 1 Bedienungsanleitung

Cooper Lighting

Cooper Lighting MCGRAW-EDISON WBG Bedienungsanleitung

Cooper Lighting

Cooper Lighting Invue 42 - 175W Bedienungsanleitung

Saxby Lighting

Saxby Lighting Islay 68784 Handbuch

LIGMAN

LIGMAN EU-10016-3 Bedienungsanleitung

Cooper Lighting

Cooper Lighting McGraw-Edison ZD Credenza Bedienungsanleitung

LIGMAN

LIGMAN KI-60475 Bedienungsanleitung

Cooper Lighting

Cooper Lighting Generation CLB25MWW5C373 Bedienungsanleitung

Malibu Boats

Malibu Boats CL905K Bedienungsanleitung

LIGMAN

LIGMAN NYB-30161 Bedienungsanleitung

LIGMAN

LIGMAN SI-80021 Bedienungsanleitung

Malibu Boats

Malibu Boats CM110P Bedienungsanleitung

U.S.T.E.

U.S.T.E. VISTA 8202 Bedienungsanleitung