WE-EF ETC320-FS LED Bedienungsanleitung
WE-EFLEUCHTEN
Installation and Maintenance
Instructions
Inground Luminaire
ETC320-FS LED
EVC320-FSLED
This product is factory-sealed.
Do not open during installation
Do not handle the luminaire by holding
the cable end!
Refer to the instructions contained in this
document for details.
INSTALLER
HOTLINE
+61 458 933399
7am–7pm AEST
IP67, Class I, ta =25 C
Inground Luminaire
EVC320-FSETC320-FS
1
2
replacement.
cable. Damaged mains supply cable: Contact your authorised WE-EF agent for
Do not handle the luminaire by holding the cable end! Doing so can damage the supply
Apart
from
cleaning the outside of the
luminaire,
no special maintenance is
necessary.
Maintenance
LED
Light
Source
Installation Methods
Important: The luminaire is factory-sealed and does
not need to be opened during installation.
Ensure that proper drainage is provided for the shown
installation methods.
For proper installation use the supplied installation
blockout.
Please note the following installation possibilities:
1) In landscape areas, sand with gravel base (Fig. I).
2) In paved areas, concrete with gravel base (Fig. II).
Fig. I
Fig. II
Installation
The product must be installed and maintained by a
suitably qualified person in compliance with the latest
applicable regulations and relevant legislation.
When selecting the correct location for the luminaire,
it is important to remember that the lens will reach a
high temperature during operation.
The minimum distance of an object to be illuminated
must be observed (see illustration ------ m inside
luminaire).
3
Ensure the luminaire and lens is clear of dirt and
debris.
Claims based on defects attributable to improper
installation, application, operation and/or any modi-
fication carried out by the purchaser or third parties,
and the consequences thereof, are excluded.
`
Phase One
Blockout Installation Procedure
(during earth or masonry work)
1) A suitable recess to be provided to accommodate
installation blockout/mounting ring assembly B/M.
2) Set installation blockout/mounting ring assembly
B/M in position and ensure that:
a)Arrow R on mounting ring M is pointedtowards
the object to be illuminated (wall, tree, column).
b)Mounting ring M is flush with surface. If the
floor will be tiled or paved afterwards leave an
appropriate gap.
c)Mains supply cable(s) Ois of sufficient length to
connect the sealable junction box Jwith the cable
Efrom luminaire.
3) During ongoing earth and/or masonry works, do
not remove the two stickers on fixing thread holes
D. Ensure that installation blockout/mounting ring
assembly B/M is not damaged and hasmaintained
its original shape. If necessary use a cover plate.
4
Phase Two
Luminaire Installation and Electrical Connection
4) Switch off mains electrical supply.
5) Check that rating shown on luminaire label con-
forms with mains electrical supply.
6) Terminate cable E from luminaire housing A and
mains supply cable O (for individual wiring) or
branch cable (for through wiring) in sealable junc-
tion box J to connect cable(s). Follow the sealable
junction box termination instruction included in the
packaging.
7) Set cables and sealable junction box J inside the
installation blockout/mounting ring assembly B/M.
8) Peel-off the two stickers on fixing thread holes D.
Loosen the two countersunk screws C (do not twist
out). Insert mounting lever L between head of
countersunk screws C and cover lens. Lift luminaire
housing A into installation blockout/mounting ring
assembly B/M (Fig. III) while aligning holes D on
mounting ring M.
Warning: When the luminaire is placed inside the
installation blockout B, make sure that there is no
stress on the sealable junction box Jor electric ca-
bles (Fig. lV).
9) Tighten both countersunk screws C'handtight'.
R
D
O
E
O
A
M
B
Fig. III
L
5
M
C
A
Fig. IV
J
B
6
E
www.we-ef.com
TO9197W0815 © WE-EF 2020
Technical specifications are
subject to change.
WE-EF LEUCHTEN
Germany
Tel +49 5194 909 0
Fax +49 5194 909 299
info.germany@we-ef.com
WE-EF LUMIERE
France
Tel +33 4 74 99 14 44
Fax +33 4 74 99 14 40
info.france@we-ef.com
WE-EF HELVETICA
Switzerland
Tel +41 22 752 49 94
Fax +41 22 752 49 74
info.switzerland@we-ef.com
WE-EF LIGHTING
United Kingdom
Tel +44 844 880 5346
Fax +44 844 880 5347
info.uk@we-ef.com
WE-EF LIGHTING
Thailand
Tel +66 2 738 9610
Fax +66 2 175 2174
info.asiapacific@we-ef.com
WE-EF LIGHTING
Australia
Tel +61 3 8587 0444
Fax +61 3 8587 0499
info.australia@we-ef.com
WE-EF LIGHTING
United States of America
Tel +1 724 742 0030
Fax +1 724 742 0035
info.usa@we-ef.com
INSTALLER
HOTLINE
+61 458 933399
7am–7pm AEST
7
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere WE-EF Laterne Handbücher
WE-EF
WE-EF ETC310-FS LED Bedienungsanleitung
WE-EF
WE-EF ZAT40 Bedienungsanleitung
WE-EF
WE-EF ETC320-FS LED Bedienungsanleitung
WE-EF
WE-EF DLO239 LED Bedienungsanleitung
WE-EF
WE-EF ZFT400 Series Bedienungsanleitung
WE-EF
WE-EF QLS400 Series Bedienungsanleitung
WE-EF
WE-EF ETC120-FS LED Bedienungsanleitung
WE-EF
WE-EF CFT500 LED Series Bedienungsanleitung
WE-EF
WE-EF RLS400 LED Series Bedienungsanleitung
WE-EF
WE-EF ETC130-FS LED Bedienungsanleitung
WE-EF
WE-EF PFL240 LED Bedienungsanleitung
WE-EF
WE-EF RLS410 LED Bedienungsanleitung
WE-EF
WE-EF RMC320 LED Bedienungsanleitung
WE-EF
WE-EF ETC330-GB LED Bedienungsanleitung
WE-EF
WE-EF RFL530 Bedienungsanleitung
WE-EF
WE-EF DLO200 Series Bedienungsanleitung
WE-EF
WE-EF ETV100 Series Bedienungsanleitung
WE-EF
WE-EF ETC120-GB LED Bedienungsanleitung
WE-EF
WE-EF FLC122 LED Bedienungsanleitung
WE-EF
WE-EF FLC122 LED Bedienungsanleitung
