System Specifications
Personal PA®R35-8 Receiver
Dimensions: 4.5” H x 2.85 W x 1.2” D (115 mm x 72 mm
x 30 mm)
Weight: 4.6 oz (130 g)
Color: Black
Battery Type: Two (2) AA non-rechargeable alkaline batteries
(BAT 001), approx. 50 hours battery life; or
Two (2) AA rechargeable NiMH batteries (BAT 026), 1400
mAh, approx. 32 hours battery life.
Current Consumption: Nominal 40 mA
Operating Freq: 8 channels: 72.1, 72.3, 72.6, 72.8, 74.7,
75.4, 75.7, or 75.9 MHz*. All Channels Not Available on the
PPA T20 Transmitter
Intermediate Freq: 10.7 MHz
FM Deviation: +/- 75 kHz
De-emphasis: 75 uS
LED Indicator: Power: Red. Low Battery: Flashes.
Sensitivity: 2 µV at 12 dB SINAD with squelch defeated
Input Overload: 20 mV
Frequency Response: 40 Hz to 15 kHz +/- 3 dB
Signal to Noise Ratio: 60 dB at 100 µV
Receiver Antenna: Integral with earphone/headphone cord
Audio Output: 35 mW, max 16 ohm load
Output Connector: 3.5 mm mono phone jack
Squelch: Located inside battery door. Factory set for 25 dB S/N.
Squelch may be set with JFD-7104-5 from Sprague Goodman or
any flat tipped tuning tool with tip size .095 X .016
Notes: The R35-8 is NOT field tunable. The eight channels have
been carefully selected to inhibit inter-modulation interference.
Channel frequencies are 72.1, 72.3, 72.6, 72.8, 74.7, 75.4,
75.7, and 75.9 MHz.
Approvals: FCC, Industry Canada, RoHS, WEEE
Warranty: Five Years, Parts and Labor. 90 days on cords, ear-
phones, headphones, batteries, and other accessories
*DISCLAIMER: FCC RULES LIMIT USE OF THIS EQUIPMENT TO “AUDITORY
ASSISTANCE FOR THE HANDICAPPED.”
NOTE: SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Belt Clip Installation
FIG C FIG D
For hands free operation of the R35-8 receiver, use the
provided belt clip to secure the unit on your belt, pocket
or pants.
To Install: Position the belt clip on the rear of the R35-8
receiver as shown in FIG C. Turn the belt clip 180° left or
right as shown in FIG D. The belt clip is now installed and
ready for use.
To Remove: Turn the belt clip 180° so the edge points
toward the top of the unit as shown in FIG C. Gently pull
the belt clip away from the unit to remove.
Limited Warranty
Williams Sound products are engineered, designed and
manufactured under carefully controlled conditions to
provide you with many years of reliable service. Williams
Sound warrants the PPA R35-8 receiver against defects
in materials and workmanship for FIVE (5) years. Dur-
ing the first five years from the purchase date, we will
promptly repair or replace the PPA R35-8 receiver.
Earphones, headphones, batteries, cables, carry cases,
and all other accessory products carry a 90-day warranty.
WILLIAMS SOUND HAS NO CONTROL OVER THE CONDITIONS
UNDER WHICH THIS PRODUCT IS USED. WILLIAMS SOUND,
THEREFORE, DISCLAIMS ALL WARRANTIES NOT SET FORTH
ABOVE, BOTH EXPRESS AND IMPLIED, WITH RESPECT TO THE
PPA R35-8 RECEIVER, INCLUDING BUT NOT LIMITED TO, ANY
IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE. WILLIAMS SOUND SHALL NOT BE LI-
ABLE TO ANY PERSON OR ENTITY FOR ANY MEDICAL EXPENSES
OR ANY DIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES
CAUSED BY ANY USE, DEFECT, FAILURE OR MALFUNCTION OF
THE PRODUCT,
If you experience difficulty with your system, call Toll-
Free for Customer Assistance:
1-800-843-3544 (U.S.A.) or
+1 952 943 2252 (Outside the U.S.A.)
If it is necessary to return the system for service,
your Customer Service Representative will give you
a Return Authorization Number (RA) and shipping
instructions.
Pack the system carefully and send it to:
Williams Sound
Attn: Repair Dept.
10300 Valley View Rd.
Eden Prairie, MN 55344
MAN 117H © 2011 Williams Sound, LLC
76 8 9 10
