Winco 8550 Referenzhandbuch

Page 1 of 4

006070 Rev R Date 06-06-12 JWC

1. READ AND FOLLOW ALL DIRECTIONS.

2. NEVER stand on table or INJURY MAY OCCUR.

3. NEVER allow user to sleep unattended on table or INJURY MAY OCCUR.

4. NEVER leave an unconscious user unattended on table or INJURY MAY OCCUR.

5. DO NOT use table for transporting user in or with ANY type of vehicle or trailer. Winco tables have not been tested

or approved for use by an occupant in any type of vehicle or trailer.

6. NEVER leave an infant or child unattended on table or INJURY MAY OCCUR.

7. Periodically, recheck tightness of all nuts, bolts and screws.

8. USE ONLY WINCO AUTHORIZED REPLACEMENT PARTS.

9. NEVER EXCEED the recommended weight capacity of 400 lbs. (181.4 kg).

10. SAVE THESE INSTRUCTIONS for future reference and training.

8550

Recovery Couch

CUSTOMER INSTRUCTIONS

Tools needed:

Phillips-head screwdriver

7/16” wrench (multiple size wrench included)

Scissors or box cutter

Cardboard shipping container (stays under table during assembly to protect upholstery)

- If using powered tools, always start hardware together by hand first & wear safety goggles

SEE “Parts Reference” (pg.3) for visual reference during assembly.

1. After checking your product for any shipping damage, table needs to be positioned upside-down on cardboard or

protective surface. Remove all packing material and hardware that was secured for shipping. Cut tape on corners of

box so that cardboard will lay flat while you assemble table.

2. You will find two Table Legs, in-between and attached to the Table Frame Rails. Pivot up the (2) Table Legs.

NOTE: The table legs have braces that need to align with two threaded holes in the wood

of the Upholstered Top.

3. Install (4) ¼-20 x 1-½” screws through (2) holes in each Upper Leg Brace of the Table Legs, and into (2) threaded

holes (each end) in the wood of the Upholstered Top.

NOTE: Do not fully tighten at this time.

4. Place (4) ¼-20 x 1-½” carriage bolts into the (4) holes through the Lower Leg Brace of the Table Legs.

Heads of screws should face the ends of table, for better appearance.

5. Align the Cross-brace (smoothest side up) with the (4) screws that you just installed on step 4,

and fasten with (4) ¼-20 nuts.

PLEASE READ AND FAMILIARIZE YOURSELF WITH

LL INSTRUCTIONS BEFORE PROCEEDING WITH ASSEMBLY

PLEASE READ AND FAMILIARIZE YOURSELF WITH ALL INSTRUCTIONS BEFORE USING THIS PRODUCT.

If you have trouble understanding these instructions contact your dealer or Winco customer support, (800) 237-3377

before attempting to use this product; otherwise injury may occur.

8550 Weight Capacity = 400 lbs. (181.4 kg.)

Winco assumes no responsibility for damage or injury caused by improper assembly,

installation, use, or maintenance of these products.

Page 2 of 4

006070 Rev R Date 06-06-12 JWC

6. TIGHTEN ALL nuts and bolts at this time.

7. Install the four (4) Threaded Inserts with Glide Feet into the ends of the table legs.

8. Using at least two people, turn table upright.

9. Remove (1) of the white plastic caps on the Paper Rod and install into the (2) Paper Rod Clamps, replace cap.

Adjust (4) 5/16” Glide Feet to level table.

Optional Shelf installation:

10. Double-sided tape has been installed on the Reinforced Cross-brace.

11. Before removing paper on tape, “test fit” the shelf. Shelf should be approximately ¼” from edge of the

Lower Leg Brace of the Table Legs.

12. Once you are certain of where you will position the shelf, peel off the paper to expose adhesive.

13. Carefully position shelf in place on adhesive.

Vinyl Strap Adjustment – Should the vinyl strap on your Winco table need to be adjusted, unscrew the screw that

currently holds either side of it in place. Pierce another hole in the strap to give desired tension and re-insert screw.

Wrinkles in Vinyl – Storage and shipping can cause wrinkles of the vinyl on your Winco table. This is normal. Please

allow 1-2 weeks at room temperature (approx. 70 degrees) to allow for vinyl to expand back to original appearance.

If the Optional Shelf and Reinforced Cross-brace have been ordered; make sure that the smooth surface (side with

tape) of the Cross-brace will face upward (when the table is in the upright position) prior to fastening to Table Legs.

After peeling paper from adhesive tape:

Use damp sponge to moisten tape to allow shelf to be adjusted during install.

Once ta

e is dr

shelf will sta

lace.

Do not over tighten nuts and bolts. Periodically check all fasteners for tightness.

Page 3 of 4

006070 Rev R Date 06-06-12 JWC

Parts Reference

Visit our website www.wincomfg.com/product-documents/parts-lists for a complete parts list of your table or

call Customer Service @ 1-800-237-3377 to request it by mail.

Page 4 of 4

006070 Rev R Date 06-06-12 JWC

Inhaltsverzeichnis

Andere Winco Medizinische Geräte Handbücher

Winco

Winco S550 Bariatric Stretchair Bedienungsanleitung

Winco

Winco Caremor Cliner Series Referenzhandbuch

Winco

Winco TransMotion TMM5 PLUS Series Bedienungsanleitung

Winco

Winco 8570 Referenzhandbuch

Winco

Winco Inverness 24-Hour Treatment Recliner Bedienungsanleitung

Winco

Winco TransMotion TMM4X PLUS Kurzanleitung

Winco

Winco TransMotion TMM4 Einrichtungshandbuch

Winco

Winco HOME CARE CLINER Bedienungsanleitung

Winco

Winco 8500 Referenzhandbuch

Winco

Winco 5251-525S Referenzhandbuch

Winco

Winco 8570 Referenzhandbuch

Winco

Winco BLOOD-DRAWING series Bedienungsanleitung

Winco

Winco 5851-585S Referenzhandbuch

Winco

Winco 3130 Referenzhandbuch

Winco

Winco TransMotion Medical TMM4-X Series Bedienungsanleitung

Winco

Winco Spirit BDC Series Bedienungsanleitung

Winco

Winco TransMotion TMM4 PLUS-154 Bedienungsanleitung

Winco

Winco 3130 Referenzhandbuch

Winco

Winco 3420 Referenzhandbuch

Winco

Winco 6530 Bedienungsanleitung

Winco

Winco TransMotion TMM4 PLUS Kurzanleitung

Winco

Winco 5404 Referenzhandbuch

Winco

Winco 3400 Referenzhandbuch

Winco

Winco Care Cliner Bedienungsanleitung

Beliebte Medizinische Geräte Handbücher anderer Marken

TekTone

TekTone Tek-CARE160 Bedienungsanleitung

NeuroMetrix

NeuroMetrix Quell 2.0 Bedienungsanleitung

AMT

AMT XLR8 Bedienungsanleitung

Medipost-Nutristoma

Medipost-Nutristoma MD300K2 Bedienungsanleitung

EDAN

EDAN SONOTRAX Pro Bedienungsanleitung

Restorative Therapies

Restorative Therapies RT300 Bedienungsanleitung

Gendex

Gendex Expert DC Bedienungsanleitung

Dexcowin

Dexcowin ADX4000W Bedienungsanleitung

Libelium

Libelium MySignals Bedienungsanleitung

Acelity

Acelity V.A.C.ULTA 4 Bedienungsanleitung

Caputron

Caputron ActivaDose II tDCS Bedienungsanleitung

FujiFilm

FujiFilm Sonart Betriebsanleitung

Plinth 2000

Plinth 2000 93CDT Bedienungsanleitung

GE SENOGRAPHE 800T Bedienungsanleitung

GE Definium 5000 Bedienungsanleitung

Kanmed

Kanmed GE-1380 Bedienungsanleitung

Huntleigh

Huntleigh FD1 Bedienungsanleitung

Stryker

Stryker SPR Plus Bedienungsanleitung