XAC XC50 Bedienungsanleitung

d



TERM

ALLATI

NAL PAY

UID

ENT CRA



1. PACKAGE CONTENT

2. DEVICE OVERVIEW



XC50KeyButtons&InterfacePorts(Figure1):

Figure1



BACKAREA1 COM1

2 COM2

3 USB

4 RJ45

5 Reset Button



REAR

XC50 Power adaptor Paper Roll



Figure2



Figure3



FRONTAREA 6 Charging Contact

7 LED

8 Paper Roll



FRONT



Figure4

BOTTOMAREA 9 DC JACK



BOTTOM

■XC50 Power spec:

Input:12VDC,3A

■Power Adapter spec:

Input:100~240ac

Output:12VDC,3A

ThissymbolisintendedtoalerttheuserbeforestartingusingthePOS.

Caution:Thisproductshallbeonlyusedwithacertifiedpowersupplyunitwhichwas

investigatedaccordingtothestandardofIEC60950‐1,UL60950‐1andCAN/CSAC22.2No.

60950‐1‐07,CSAC22.2No.60950‐1,andmarked“I.T.E.LPS”,andwithoperatingtemperature:

minimum40°C,outputrated:12VDC,minimum3A.



OperatingTemperature:0oCto40oC



3. POWER ON/OFF THE DEVICE



Topoweronthedevice:PlugintheDCJACK

Topoweroffthedevice:PlugofftheDCJACK



Figure5

4. LED BEHAVIORS



InsertPoweradapteranddevicewillpowerup,thereisaLEDstatus:

Location:

zToprightcorner(Figure6)



Figure6

SolidRed–XC50ispoweredupandunderbootingprocess

SolidGreen–XC50bootingprocessissuccessfullycompleted

BlinkingRed–Firmwareupdateprocess

RedLightOn–Errorstatus(systemerrorsandfirmwareupgradefailed)

SolidOrange–Forprinterstatus

5. LOADING THE PAPER

Gentlypoptheprintercover’slatch;thenpullthecover(Figure7).Loadarollofthermalpaper

intotheprinter.Loaditsothattheprint‐sideofthepaperwillfeedoutfacingtheoperator.

Closethecoverbypressingonthecenteroftheprintercover.Usetheserratedbartotearoff

anyexcesspaper.





Figure7

Federal Communication Commission Interference Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate this equipment.

This transmitter must not be co-located or operating in conjunction with any other antenna

or transmitter.

Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance

20cm between the radiator & your body.

Note: The country code selection is for non-US model only and is not available to all US

model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation

channels only.



The above information is the exclusive intellectual property of XAC Automation Corporation and shall not be

disclosed, distributed or reproduced without permission of XAC Automation Corporation.

XAC Automation Corporation

886-3-577-2738

Inhaltsverzeichnis

Andere XAC Zahlungsterminal Handbücher

XAC

XAC xCL AT-170 Series Bedienungsanleitung

XAC

XAC RP-10 Bedienungs- und Wartungsanleitung

XAC

XAC xAPT-103LE Bedienungsanleitung

XAC

XAC xAPT-103WiFi.3G Bedienungsanleitung

XAC

XAC xCL AP-10 Handbuch

XAC

XAC FD130Duo Bedienungsanleitung

XAC

XAC 8002R PIN PAD Bedienungsanleitung

XAC

XAC XCL_T305 Bedienungs- und Wartungsanleitung

XAC

XAC XCE-25-C Bedienungsanleitung

XAC

XAC xCL_AT-150 Series Bedienungsanleitung

XAC

XAC XPED-8006L2-3CR Bedienungsanleitung

XAC

XAC XCL_AT-170 Bedienungsanleitung

XAC

XAC XCL AT-150 SERIES Bedienungs- und Wartungsanleitung

XAC

XAC xCL AP-10 Bedienungsanleitung

XAC

XAC CL AT-170-R Series Bedienungsanleitung

XAC

XAC XCL AT-100 SERIES Bedienungsanleitung

XAC

XAC XCL AT-150 SERIES Bedienungsanleitung

XAC

XAC PINPAD 8006L1-1CR Series Bedienungsanleitung

XAC

XAC FD130 Bedienungsanleitung

XAC

XAC FD150 Bedienungsanleitung

Beliebte Zahlungsterminal Handbücher anderer Marken

PAX

PAX D180SRF Bedienungsanleitung

LinkPoint

LinkPoint AIO Bedienungsanleitung

Moneris

Moneris hispeed 6200 Bedienungsanleitung

Moneris

Moneris iWL220 Bedienungsanleitung

Ingenico

Ingenico iUC280 Bedienungsanleitung

Ingenico

Ingenico Tetra Move/5000 Bedienungsanleitung

Ingenico

Ingenico iWL250B Bedienungsanleitung

Optimum

Optimum M4230 Bedienungsanleitung

Triton

Triton RL5000 Bedienungsanleitung

Ingenico group

Ingenico group Lane/8000 Bedienungsanleitung

Gilbarco

Gilbarco FlexPay IV CRIND Installations- und Betriebshandbuch

Infinite Peripherals

Infinite Peripherals Infinea Tab Lite Bedienungsanleitung

PAX

PAX S920 Bedienungsanleitung

Ingenico

Ingenico iCT220, iCT250 Bedienungsanleitung

dejavoo

dejavoo Z Series Bedienungsanleitung

VeriFone

VeriFone VX 520 Series Bedienungsanleitung

Optomany

Optomany axept S900 Bedienungsanleitung

Skyzer

Skyzer iWL252 BLUETOOTH Bedienungsanleitung