Xylem FLOJET BW5000 Series Bedienungsanleitung

BW5000 Series

BOTTLED WATER BOOSTER SYSTEM

Insert DC plug/connector into pump

module “DC IN” port.

The connections for the ﬂoat and power

supply will require moderate force

to insert fully. This is a design feature

that assures the connections are

held securely after initial installation.

MAKE SURE PLUG / CONNECTOR IS

INSERTED ALL THE WAY INTO THE

CONNECTIONS. FAILURE TO INSERT

FULLY WILL LEAD TO POOR

OPERATION OR NO OPERATION.

Insert suction hose port ﬁtting into

pump module “IN” port and slide

locking port clip in place.

Insert ﬂoat sensor switch plug/connector into

pump module “SWITCH” port.

The connections for the ﬂoat and power

supply will require moderate force to insert

fully. This is a design feature that assures the

connections are held securely after initial

installation. MAKE SURE PLUG / CONNECTOR

IS INSERTED ALL THE WAY INTO THE

CONNECTIONS. FAILURE TO INSERT FULLY WILL

LEAD TO POOR OPERATION OR NO OPERATION.

Push clip up

to lock

Main pump module and tank assembly

Suction Wand with Universal Cap Seal, Float

Switch and Hose Assembly

Wall Power Transformer

Grounded Outlet

Power Cord

Wall Power

Transformer

On/Off Switch

Figure 1

Typical Beverage Installations

Coffee Cart/Kiosk

The Bottled Water Booster System

may also be placed in a pantry, closet,

cellar or other location where a

grounded electrical outlet is available.

Application

• Designed for dispensing Bottled Water

to coffee machines, beverage dispensers,

vending machines and carts. See diagrams

• For remote locations where mains water

supply is not accessible

• Ideal for under counter installation

Installation and Operation

Installation procedure: See Figure 1

1. Securely mount in a suitable position. If mounting vertically to a wall, ensure that the mounting ﬁxings are

suitable for the product’s wet weight. Ensure that the on / off switch is accessible and that there is sufﬁcient

space above the accumulator tank to access the air valve

2. Pre-charge accumulator tank to 18 PSI (1.2 Bar) per the troubleshooting section

3. Install appropriate adapter onto the universal wall power transformer, plug into grounded electrical outlet

and into the pump module

4. Fill water tank

5. Install suction wand with universal cap seal, ﬂoat switch and hose assembly

6. Open all faucets and switch appliance(s) on to ﬁll if necessary

7. Turn the ON/OFF switch located on the pump module to the “ON” position to prime pump

8. When water is free of air, turn all faucets off beginning with the faucet closest to the pump

Regular cleaning and sanitizing of the Flojet Bottle Water Booster System is required.

The BW Booster System is only to be used with the power supply provided.

Check accumulator tank pressure every 6 months and adjust as necessary.

Important: Do not operate the pump more than 20 minutes continuously.

CAUTION: This appliance can be used by children aged from 8 years and above and persons

with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if

they have been given supervision or instruction concerning use of the appliance in a safe way and

understand the hazards involved. Children shall not play with the appliance. Cleaning and user

maintenance shall not be made by children without supervision.

Voltage Input 100-240 VAC

Cycles 50/60 Hz

Current 1.2 Amps Max.

Maximum Pressure 40 PSI (2.8 Bar) Max.

Accumulator Air Tank Pressure 18 PSI (1.2 Bar)

Housing Material ABS

Shipping Weight 4.6 lb. (2.1 kg)

Wet Weight 7.5 lb (3.4 kg)

Overall Dimensions 11.5 in L x 10.5 in W x 7.1 in H

292 mm x 267 mm x 181 mm

Fluid Outlet 3/8” (9.5mm) OD Push-in Tube

Speciﬁcations

Application Notes & Troubleshooting

System will not dispense ﬂuid

• Check ON/OFF switch position

• Check power to dispensing system

• Check tubing and ﬂuid connections

• Check for empty ﬂuid container

• Check power cable is fully inserted and switched on at the mains

System will not shut-off

• Check for leaks in tubing system

• Check for air in system, purge air

Low ﬂow or system continually turns on and off

• Check accumulator air pressure

1. Wear appropriate safety gear

2. Turn off power and relieve water pressure

3. Unscrew valve cap and adjust air pressure to 18 PSI (1.2 Bar)

MAINTENANCE AND SANITATION

Equipment Required

• 2.5 gal (9.6 L) Household Pails

• One (1) Roll of Paper Towels

• One (1) Small Container of Household Bleach

Clean In-Place Procedure

1. Using the on/off switch on the front of the enclosure, turn BW

Booster Series off by putting the switch in the off position.

2. Fill a clean pail (A) with two (2) gal (7.57 L) of hot tap water

(135°F / 57.2°C), adding one (1) oz (29.57 ml) of household

bleach.

3. Remove the suction wand from the pure water bottle and sub-

merge the bottle cap end into pail (A), taking care to ensure

that the metal hose clamp connecting the hose to the suction

wand(s) is/are totally immersed in the water/bleach solution,

for ten minutes and then wash underside of cap and suction

tube exterior with a clean paper towel. If using the optional

Flojet faucet, disconnect the tubing. Remove the faucet, im-

mersing it in the water/bleach solution for ten minutes. Wash

the faucet exterior with clean paper towel; install the faucet and

reconnect the tubing. Place suction wand into clean empty pail

(B) and dispose of solution in pail (A).

4. Reﬁll the cleaned pail (A) with two (2) gal (7.57 L) of hot tap wa-

ter (135°F / 57.2°C) adding one (1) oz (29.57 ml) of household

bleach and place suction wand(s) into pail with bottle cap up.

5. Disconnect the discharge tube from the faucet and place into

the empty second pail (B). (Do not use pail with clean water and

chlorine solution).

6. Turn dispensing system on, by placing on/off switch in the on

position and dispense all of the chlorine solution into pail (B).

Place discharge tube into pail (A) and dispose of bleach, and

rinse pail (B). Replace tube into pail (B).

7. Reﬁll pail (A) with two (2) gal (7.57 L) of hot tap water (135°F

/ 57.2°C), adding one (1) oz (29.57 ml) of household bleach.

Dispense bleach as in step #6.

8. Reinstall suction wand(s) into new bottle(s) of pure water and

reconnect discharge tube into refrigerator or faucet and dis-

pense 12 to 18 oz (355 to 532 ml) of water, or until bleach taste

is removed.

9. Cleaning should be performed at least six (6) times per year.

System should be cleaned and ﬂushed with fresh water if stag-

nant for more than 48 hours.

CAUTION

Do not place BW Booster Series into a dishwasher as

it will cause electrical failure of pump and controls.

CAUTION: Do not place BW Booster System into a dishwasher as it will cause electrical failure of

pump and controls.

CAUTION: Not intended for outdoor use.

CAUTION: The BW Booster System must be installed in an enclosure and/or protected from any

splash or spillage.

CAUTION: To avoid exposure to freezing conditions, prior to storing, cleaning and servicing

of pumps, purge all liquid from the pump. Allowing water to freeze in the system may result in

damage to the pump and plumbing system.

Only used with speciﬁed products. DO NOT PUMP LIQUIDS WITH A FLASH POINT BELOW

100°F (37.8°C) OR USE WHERE FLAMMABLE VAPORS ARE PRESENT. Doing so may result in

explosion which could cause personal injury, death or property damage.

WARRANTY

XYLEM LIMITED WARRANTY WARRANTS THIS PRODUCTTO BE FREE OF DEFECTSAND WORKMANSHIP FOR A PERIOD OF 4YEARS FROM DATE OF

MANUFACTURE ON THE BOTTLE WATER PUMPAND WAND, 1YEAR FROM DATE OF MANUFACTURE ON TO THE ACCUMULATOR TANK ASSEMBLY.

THE WARRANTY IS EXCLUSIVE AND IN LIEU OF ANYAND ALL OTHER EXPRESS OR IMPLIED WARRANTIES,GUARANTEES, CONDITIONS OR TERMS

OF WHATEVER NATURE RELATING TO THE GOODS PROVIDED HEREUNDER, INCLUDING WITHOUT LIMITATION ANY IMPLIED WARRANTIES OF

MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WHICH ARE HEREBY EXPRESSLY DISCLAIMED AND EXCLUDED. EXCEPT AS

OTHERWISE PROVIDED BY LAW, BUYER’S EXCLUSIVE REMEDY AND SELLER’S AGGREGATE LIABILITY FOR BREACH OF ANY OF THE FOREGOING

WARRANTIES ARE LIMITED TO REPAIRING OR REPLACING THE PRODUCT AND SHALL IN ALL CASES BE LIMITED TO THE AMOUNT PAID BY THE

BUYER HEREUNDER. IN NO EVENT IS SELLER LIABLE FOR ANYOTHER FORM OF DAMAGES, WHETHER DIRECT, INDIRECT, LIQUIDATED,INCIDEN-

TAL, CONSEQUENTIAL, PUNITIVE, EXEMPLARY OR SPECIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LOSS OF PROFIT, LOSS OF ANTICIPATED

SAVINGS OR REVENUE, LOSS OF INCOME, LOSS OF BUSINESS, LOSS OF PRODUCTION, LOSS OF OPPORTUNITY OR LOSS OF REPUTATION. THIS

WARRANTY IS ONLY A REPRESENTATION OF THE COMPLETE LIMITED WARRANTY. FOR A DETAILED EXPLANATION, PLEASE VISIT US AT www.

xylem.com/en-us/support/, CALL OUR OFFICE NUMBER LISTED, OR WRITE A LETTER TO YOUR REGIONAL OFFICE.

RETURN PROCEDURE

Warranty returns are conducted through the place of purchase. Please contact the appropriate entity with a receipt of purchase to verify date.

Notes

Xylem Inc. — USA

17942 Cowan

Irvine, CA 92614

Xylem Inc. — HUNGARY KFT

2700 Cegléd

Külso-Kátai út 41

Xylem Inc. — UK

Harlow Innovation Park,

London Road, Harlow, Essex, CM17 9LX

Xylem Inc. — AUSTRALIA

2/2 Capicure Drive

Eastern Creek, NSW 2766

Xylem Inc. — CHINA

30/F Tower A, 100 Zunyi Road, Shanghai

200051

www.xylem.com/ﬂojet

Flojet is a trademark of Xylem Inc. or one of its subsidiaries

81000918 Rev. A 06/2022

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Xylem Wasserpumpe Handbücher

Xylem

Xylem GOULDS 45HB Betriebsanleitung

Xylem

Xylem Rule 33ALA Bedienungsanleitung

Xylem

Xylem JABSCO 18660 Series Bedienungsanleitung

Xylem

Xylem Bell&Gosset 100 Series Bedienungsanleitung

Xylem

Xylem GOULDS e-HM Series Bedienungsanleitung

Xylem

Xylem Goulds J Series Bedienungsanleitung

Xylem

Xylem Flowtronex SILENT STORM Bedienungsanleitung

Xylem

Xylem Goulds Marlow Series Bedienungsanleitung

Xylem

Xylem Laing Thermotech E-10 Series Bedienungsanleitung

Xylem

Xylem GOULDS HMS Handbuch

Xylem

Xylem Bell & Gossett ecocirc XL Fehlerbehebungshandbuch

Xylem

Xylem LOWARA e-LNEEE Bedienungsanleitung

Xylem

Xylem Flygt 2190 Bedienungsanleitung

Xylem

Xylem FLOJET 3526 Series Bedienungsanleitung

Xylem

Xylem Bell & Gossett e-80 Series Bedienungsanleitung

Xylem

Xylem FLOJET VFLO 5.0 Bedienungsanleitung

Xylem

Xylem GOULDS NSC Betriebsanleitung

Xylem

Xylem Rule iL500Plus Bedienungsanleitung

Xylem

Xylem Lowara DDC Kurzanleitung

Xylem

Xylem GOULDS NPO Bedienungsanleitung

Xylem

Xylem Lowara SEKAMATIK 200 E UF Service-Handbuch

Xylem

Xylem LOWARA Sekamatik 3MK2 Kurzanleitung

Xylem

Xylem Goulds MPVN Series Bedienungsanleitung

Xylem

Xylem Bell & Gossett e-80SCXL Series Bedienungsanleitung

Beliebte Wasserpumpe Handbücher anderer Marken

Neptun

Neptun NPHW 5500 Bedienungsanleitung

Sensidyne

Sensidyne Gilian BDX-II Montage- und Bedienungsanleitung

Draper

Draper 47808 Bedienungsanleitung

Trolla

Trolla 12820 Bedienungsanleitung

Sunfab

Sunfab SVH Series Bedienungsanleitung

WilTec

WilTec 50740 Bedienungsanleitung

Fieldmann

Fieldmann FVC 5015 EK Bedienungsanleitung

Everbilt

Everbilt EFSUB5-122HD Bedienungsanleitung

Graco

Graco Husky 3300e Bedienungsanleitung

esotec

esotec 101018 Bedienungsanleitung

Becker

Becker BASIC VASF 2.80/1-0.AC230 Bedienungsanleitung

Sykes AmeriPumps

Sykes AmeriPumps GP100M Fehlerbehebungshandbuch

DUROMAX

DUROMAX XP WX Series Bedienungsanleitung

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 Bedienungsanleitung

Franklin Electric

Franklin Electric IPS Bedienungsanleitung

Milton Roy

Milton Roy PRIMEROYAL Bedienungsanleitung

STA-RITE

STA-RITE ST33APP Bedienungsanleitung

GÜDE

GÜDE HWW 900 GC Bedienungsanleitung